Swit hing ON
onnect and switch on at mains. The red neon will light.
Turn thermostat to required setting. The amber neon
will light. When amber neon goes out, the oven has
reached the required temperature.
Swit hing OFF
Turn thermostat back fully anti-clockwise.
The red neon will remain lit.
Switch off and disconnect at mains.
Loading
When the set temperature is reached the amber neon
will go out, the elements are off but the fan will still run.
The oven is now ready to load.
If the oven cools, the thermostat will activate power to
the elements and maintain set temperature. Load the
oven quickly to prevent heat loss.
Shelves
These are designed to prevent being pulled out
accidentally. To remove a shelf, pull forward to stop
position and tilt up. When replacing a shelf, insert with
rail stop to the rear.
There are six runner positions. For even shelf cooking,
distances between trays should be consistent. Shelf
combinations with regard to position should be 2/4/6
(from the top) or 3/6.
A typical shelf load may be 12 x 56g (2oz) scones, 12 x
225g (8oz) jacket potatoes or 3 x 500g tin bread loaves.
Times and temperatures will vary according to the
quality and quantity of the food being prepared.
Never overload the oven as ex essive restri tion of
air ir ulation will affe t the ooking quality.
Cleaning an Oven
Interior
Wipe with soft cloth using a warm water and detergent
solution. Thoroughly rinse and dry.
Under no circumstances should abrasives, scrapers,
knives, scourers, paste, bleaches, steel wool with or
without soap, aerosol or proprietory oven cleaning pads
be used on enamelled panels.
LD62 and LD64 OVENS
SERVICE ACCESS
Outer Ba k Panel
Slacken mains lead cord grip.
Undo back panel fixings to remove panel.
When replacing panel, ensure cable is pulled taught
and tightened in a manner which securely grips the
cable within the fitting.
Shelf Hangers
Lift hanger to withdraw.
Replace in reverse order. Ensure hangers locate
correctly within the fixings with the narrow section of
the keyhole slots at the top.
Crown Plate
Undo fixings and remove crown plate. Replace in
reverse order.
DOOR ITEMS
Door Panel
Remove top hinge fixings.
Lift door to remove. Replace in reverse order and
ensure door seals correctly.
Door Handle
Remove door as detailed above.
Drill out pop rivets on the door edges and separate door
halves.
Undo nuts which secure handle to door and remove
handle.
Replace in reverse order.
Door Cat h
Remove door as detailed above.
Drill out pop rivets on the door edges and separate door
halves.
Drill out catch rivets and remove catch. Replace in
reverse order.
FUNCTIONAL COMPONENTS
Thermostat
Remove crown plate or counter model (Refer to Siting
section).
Remove control knob.
Remove electrical connections, noting the positions.
Undo fixings which secure thermostat to control panel
and ensure earth wire is held out of the way.
Undo fixings which retain oven phial guard and remove
guard.
Remove phial by feeding it back through hole in oven
side.
Remove sleeving.
Replace in reverse order and ensure cable is pulled
taught and tightened in a manner which securely grips
the cable within the fitting.
Fan
Remove shelf hangers.
Slacken baffle fixings and lift from keyhole slots.
Remove outer back panel.
Remove fan motor and earth lead connections.
Undo impellor retaining nut (LH thread) and remove
impellor.
Undo fixings which retain motor within oven chamber.
Replace in reverse order.
Neons
Remove crown plate or ounter model (Refer to Siting
section).
Remove electrical connections.
Undo neon retaining nut and remove neon.
Replace in reverse order.
