Promise Vess A6600 Manuale utente

Vess A6600 (VES0603)

Vess A6800 (VES0604)

Storage Appliance for Video Surveillance

Product Manual

Version 1.0

Also included are four levels of notices:

Warning

A Warning noties you of probable equipment damage

or loss of data, or the possibility of physical injury, and

how to avoid them.

Caution

A Caution informs you of possible equipment damage

or loss of data and how to avoid them.

Important

An Important message calls attention to an essential step or point

required to complete a task, including things often missed.

Note

A Note provides helpful information such as hints or alternative ways of

doing a task.

Vess A6000 Series Storage Appliance for Video Surveillance

iii

Warning

Turn off the power and disconnect the power cord

before servicing this device.

Warning

The electronic components within the Vess A6000 Series

enclosure is sensitive to damage from Electro-Static

Discharge (ESD). Observe appropriate precautions at all

times when handling the Vess A6000 or its subassemblies.

Promise Technology Product Manual

Warning

• Use an approved power cord. If you have questions about the type of power cord to use,

contact your PROMISE Technology, Inc. authorized service provider.

• If you have not been provided with a power cord for your product or for any AC-powered

option intended for your product, purchase a power cord that is approved for use in your

country.

• You must use a power cord rated for your product and for the voltage and current

marked on the electrical ratings label of the product. The voltage and current rating of

the cord must be greater than the voltage and current rating marked on the product.

• Do not pull on a cord or cable. When unplugging from the electrical outlet, grasp the

cord by the plug.

• Make sure that the total ampere rating of all products plugged into an extension cord

or power strip does not exceed 80 percent of the ampere ratings limit for the extension

cord or power strip.

• Do not disable the power cord grounding plug. The grounding plug is an important

safety feature.

• Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible

at all times.

• Onlyaqualiedtechnicianwhoisfamiliarwithxupserviceprocedureshouldinstall

and service the equipment.

• Verify that the external power source connected to your product matches the type of

power source indicated on the electrical ratings label. If you are not sure of the type

of power source required, consult your PROMISE Technology, Inc. authorized service

provider or local power company.

Vess A6000 Series Storage Appliance for Video Surveillance

為減少電擊或設備損壞的危險：

· 使用認可的電源線。如果您對使用的電源線類型有疑問，請聯繫喬鼎資訊授權的服務提供商。

· 如果沒有為您的產品或任何預期的交流電供電選項提供電源線對於您的產品，請購買經批准在您所在

國家使用的電源線。

· 您必須使用適用於您的產品的電源線以及電氣上標註的電壓和電流產品的評級標籤。電源線的電壓

和電流額定值必須大於電壓和產品上標明的電流額定值。

· 請勿拉扯電線或電纜。從電源插座上拔下插頭時，請抓住電源線。

· 確保所有插入延長線或配電盤的產品的總額定電流值不超過延長線或電源插座的安培額定值的80％。

· 請勿禁用電源線接地插頭。接地插頭是一個重要的安全功能。

· 將電源線插入隨時可輕鬆接地的接地（接地）電源插座。

· 只有熟悉維修程序的合格技術人員才能安裝和維修設備。

如果您不確定所需的電源類型，請諮詢喬鼎資訊授權的服務提供商或當地的電力公司。

Promise Technology Product Manual

Federal Communications Commission notice

Class A equipment

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful

interference, in which case the user will be required to correct the interference at personal expense

Modication

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Industry Canada Regulatory Compliance Notices

Avis de conformité à la réglementation d’Industrie Canada

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.

Notices for New Zealand and Australia

Class A equipment

This is a Class A product. In a domestic environment this product may cause radio interference in which case

the user may be required to take adequate measures.

Vess A6000 Series Storage Appliance for Video Surveillance

vii

Notices for European Union

This product is in conformity with the protection requirements of EU Council Directive 2014/30/EU on the

approximation of the laws of the Member States relating to electromagnetic compatibility. PROMSIE Technology,

INC. cannot accept responsibility for any failure to satisfy the protection requirements resulting from a non-

recommendedmodicationoftheproduct,includingthettingofnon-PROMISEoptioncards.

This product has been tested and found to comply with the limits for Class A Information Technology Equipment

according to CISPR 32/European Standard EN 55032. The limits for Class A equipment were derived for

commercial and industrial environments to provide reasonable protection against interference with licensed

communication equipment.

This is a Class A product. In a domestic environment this product may cause radio interference in which case

the user may be required to take adequate measures.

The point of contact for regulatory matters is PROMISE TECHNOLOGY EMEA, Science Park Eindhoven 5228,

5692 EG Son, The Netherlands.

OfceHours

8:30 am - 5:00 pm (The Netherlands)

Promise Technology Product Manual

viii

警告使用者 :

這是甲類的資訊產品，在居住的環境中使用時，可能會造成射頻干擾，在這種情況下，使用者

會被要求採取某些適當的對策。

Vess A6000 Series Storage Appliance for Video Surveillance

設備名稱：磁碟陣列儲存系統型號（型式）： VES0603、VES0604

Equipment name Type designation (Type)

單元Ｕnit 限用物質及其化學符號

Restricted substances and its chemical symbols

鉛Lead

(Pb)

汞

Mercury

(Hg)

鎘

Cadmium

(Cd)

六價鉻

Hexavalent

chromium

(Cr+6)

多溴聯苯

Polybrominated

biphenyls

(PBB)

多溴二苯醚

Polybrominated

diphenyl

ethers (PBDE)

電路板－ ○ ○ ○ ○ ○

外殼－ ○ ○ ○ ○ ○

線材 ○ ○ ○ ○ ○ ○

電源供應器－ ○ ○ ○ ○ ○

電池－ ○ ○ ○ ○ ○

備考1.〝超出0.1 wt %〞及〝超出0.01 wt %〞係指限用物質之百分比含量超出百分比含量基

準值。

Note 1：〝Exceeding 0.1 wt %〞 and 〝exceeding 0.01 wt % 〞indicate that the

percentage content of the restricted substance exceeds the reference percentage

value of presence condition.

備考2.〝○〞係指該項限用物質之百分比含量未超出百分比含量基準值。

Note 2: 〝○〞 indicates that the percentage content of the restricted substance

does not exceed the percentage of reference value of presence.

備考3.〝－〞係指該項限用物質為排除項目。

Note 3：The 〝−〞 indicates that the restricted substance corresponds to the

exemption.

Promise Technology Product Manual

Table of ContentsVess A6000 Series Storage Appliance for Video Surveillance

Contents

IntroductIon ............................................................................................................................ 1

SpecificationS �� 2

Hardware�� 4

Front Panel Hardware .....................................................................................................................................4

front of VeSS a6600 �� 5

Secure cover .....................................................................................................................................................6

Front Panel ledS.............................................................................................................................................7

rear Panel Hardware........................................................................................................................................9

VeSS a6000 rear panel componentS�� 9

VeSS a6000 rear panel led indicatorS ��11

VeSS a6000 rear panel connectionS ��11

Hardware SetuP .................................................................................................................... 12

Unpacking �� 13

packing liSt �� 13

moUnting tHe encloSUre in arack�� 14

MountIng encloSure In arack .........................................................................................................................15

InStallIng or reMovIng tHe SecurIty cover ........................................................................................................18

inStalling diSk driVeS �� 19

nuMber oF drIveS requIred ..............................................................................................................................19

driVe Slot nUmbering �� 20

reMovIng tHe drIve carrIer .............................................................................................................................21