ProNav IM-ERC-02 Series Manuale utente
IM-ERC-02
USER
GUIDE
IM-ERC-02 SERIES COLOUR CAMERA
Water Resistant Day / Night nfra Red Colour Camera
Dimensions
66mmØ x 188mm
Weight
300g
Material
Stainless Steel / White Powder Coat Finish
Imaging
1/3” SONY CCD
Horizontal Resoluiton
420 TVL Low llumination
Pixels
510(h) x 492(v)
TV System
PAL / NTSC
Scanning
2:1 nterlaced
White Balance
Automatic
Synchronization
nternal
Output Signal
Composite Video 1V P~P 75Ω
Usable Illumination
0 Lux / F2.0 (LED ON)
Shutter Spee
Auto:PAL 1/50~1/100,000 Sec ; NTSC 1/60 ~1/100,000 Sec
IR Status
Under 10 Lux by CDS
Connections
Video via BNC Female / Power via DC Jack 2.1mm
Lens
3.6mm Fixed
Illumination
23 Pieces / R Distance = 20 meters
Power
DC12V 300mA
Operating Temperature
-10°C ~ +50° Relative Humidity 95% Max
Environmental Rating
P68
Signal / Noise
48db or more (AGC OFF)
Gamma
0.45
CAUTION
ELECTRIC SHOCK RISK. DO NOT OPEN
TO REDUCE THE R SK OF ELECTR C SHOCK DO NOT REMOVE COVER
OR D SMANTLE DEV CE. NO USER SERV CEABLE PARTS NS DE. N THE
EVENT OF MALFUNCT ON OR PRODUCT FA LURE CONTACT YOUR
DEALER.
DO NOT ATTEMPT TO CONNECT TO ANY POWER SUPPLY OUTS DE OF
THE RAT NG SPEC F ED N THE SPEC F CAT ON TABLE OR GU DEL NES
DETA L W TH N TH S DOCUMENT.
WARNING: READ BEFORE USE
INTRODUCTION
Water Resistant Day / Night nfra Red Colour Camera
CONNECTIONS
The M-ERC-02 General Purpose Water Resistant Camera adopts the latest SONY
technology, CCD Sensor and driver.
Key features of the ERC-02 are itʼs attractive, stylish housing, environmental protection
( P68), ease of installation and setup and high resolution.
Built-in nfra Red LEDʼs operate automatically in low light to provide visability in com-
plete darkness.
The M-ERC-02 is perfect for use as an engine room camera, a back-up or docking
camera, or part of an on board security system.
Please ensure installation is carried out by qualified engineer and that the device is
properly connected to the power source. This equipment must be suitably isolated to
prevent damage or risk of injury. For further technical support please contact your
dealer, or ris nnovations using the contact details within this document.
The ERC-02 camera is fitted with a cable tail which has a 2.1mm DC Jack for the
power and a female BNC connector for the video signal. The polarity of the power con-
nection is center pin = +12V, connector body = Ground.
Use a suitable coaxial cable with an impedance of 75Ω for the video signal or a suit-
able Video Balum if using Cat 5 cable.
Ready made power, video and combination cables are available from ris nnovations.
Reverse Image Version
ERC-02 cameras with reverse (or mirror image) functionality have a D P switch fitted to
the inside of the housing. To select the reverse image feature simply slip off the sun
visor and unscrew the front of the camera housing.
Set switch 1 to ON for reverse image. Set switch 1 to OFF for standard image.
Video (1v P~P Composite 75Ω)
12VDC 300mA
Connect to boatʼs distri-
bution panel and ensure
suitable isolation is in
place.
Electrical and electronic equipment, batteries, battery
chargers and equipment housings, at the end of their life
should be disposed of separately from your household
waste. Please dispose of all components correctly at your
local waste collection / recycling centre.
Declaration of Conformity
Model Number: M-ERC-02
Trade Name: ris Marine
Responsible party: ris nnovations Limited
Address: Sailmakers Loft, Kingscopse Farm, Tanhouse
Lane, Botley, Southampton SO30 2SZ. United Kingdom.
Telephone: +44(0)1489 798484
This device complies with Part 15 of the FCC Rules. Op-
eration is subject to the following rules:
(1) this device may cause harmful interference, and
(2) this device must accept any interference received, in-
cluding interference that may cause undesired operation.
Before using your camera please rea an un-
erstan these safety instructions.
Warning:
This product contains chemicals known to the state of Califor-
nia to cause cancer, birth defects or other reproductive harm.
Wash hands after handling.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions may cause harmful interference to radio
communications. f this equipment does cause interference to
radio or television reception the user is encouraged to try to
correct the interference by one or more of the following meas-
ures:
Reorientate or relocate the receiving antenna.
ncrease the separation between the equipment and transmit-
ting / receiving device.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult your dealer or a qualified CCTV engineer for help.
Iris Innovations Limite
Sailmakers Loft Kingscopse Farm
Tanhouse Lane, Botley, Hampshire SO30 2SZ
United Kingdom
Tel/Fax: +44(0)1489 798484
email: [email protected]
web: www.boat-cameras.om
Indice
