Prorack K619 Manuale utente
K619
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 1 x 1 x 2 x 4
x 4 x 4
Revision No: 7G 1
Fitting Kit K619
MAX kgs (lbs)
W/P WHD
Opel
Agila, 5dr Hatch 08-15 EU 50 kgs (110 lbs) 50 kgs (110 lbs)
Vauxhall
Agila, 5dr Hatch 08-15 EU 50 kgs (110 lbs) 50 kgs (110 lbs)
Suzuki
Splash, 5dr Hatch 08-16 EU 50 kgs (110 lbs) 50 kgs (110 lbs)
Splash, 5dr Hatch 11-+ NZ 50 kgs (110 lbs) 50 kgs (110 lbs)
2
Fitting Kit K619
X
A B C 1 2 3
Agila, 5dr Hatch 08-15 (EU) -150mm 470mm - 765mm 745mm -
-5 -15/16ths" 18 1/2ths" - 30 1/8ths" 29 5/16ths" -
Agila, 5dr Hatch 08-15 (EU) -150mm 470mm - 765mm 745mm -
-5 -15/16ths" 18 1/2ths" - 30 1/8ths" 29 5/16ths" -
Splash, 5dr Hatch 08-16 (EU) -150mm 470mm - 765mm 745mm -
-5 -15/16ths" 18 1/2ths" - 30 1/8ths" 29 5/16ths" -
Splash, 5dr Hatch 11-+ (NZ) -150mm 470mm - 765mm 745mm -
-5 -15/16ths" 18 1/2ths" - 30 1/8ths" 29 5/16ths" -
3
Fitting Kit EN
K619
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
4
Fitting Kit EN
K619
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
5
Fitting Kit EN
K619
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●Attach clamp to each leg. NOTE; clamps
may have labels showing their positions on
the vehicle (For example; "Front Right").
6
Fitting Kit EN
K619
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Refer to the underside of the pad for the
part number.
●It is important to put the pads in the correct
position on the vehicle.
●Letters refer to the pad part numbers and
position.
●Pad Part Number:
A = 11-04-250
B = 11-04-251
C = 11-04-292
7
Fitting Kit EN
K619
●Fit rubber pads (supplied with fitting kit) to
foot. Pad may vary in shape to that shown.
●Make sure the pad fits into the holes
underneath the foot.
Fitment
●Clamps directly to edge of roof under the
doors
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
8
Fitting Kit EN
K619
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
●Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
●Tighten locking screw on both legs evenly.
9
Fitting Kit EN
K619
●Check crossbar is securely attached to the
vehicle.
●Use keys to fit and lock covers
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Indice
Altri manuali Prorack Accessori per automobili
Prorack
Prorack K907 Manuale utente
Prorack
Prorack K394 Manuale utente
Prorack
Prorack K800 Manuale utente
Prorack
Prorack K546 Manuale operativo e di installazione
Prorack
Prorack K442 Manuale utente
Prorack
Prorack K687 Manuale utente
Prorack
Prorack K557 Manuale utente
Prorack
Prorack K629 Manuale utente
Prorack
Prorack K162 Manuale utente
Prorack
Prorack K113 Manuale utente
Prorack
Prorack K431 Manuale utente
Prorack
Prorack K683 Manuale utente
Prorack
Prorack K663 Manuale utente
Prorack
Prorack K1003 Manuale utente
Prorack
Prorack K704 Manuale utente
Prorack
Prorack K1143 Manuale utente
Prorack
Prorack PR3108 Manuale utente
Prorack
Prorack S4 Manuale utente
Prorack
Prorack K309 Manuale utente
Prorack
Prorack K612 Manuale utente
