GroundTrac®
Installation Manual
Page 1 of 10
COPYRIGHT PROSOLAR® 2018: All information contained in this manual is property of ProSolar® (PSP).
GroundTrac® and RoofTrac®, are registered trademarks for PSP and are covered under U.S. patents
D547262 and #6,360,491. (V 2.0)
ProSolar®
APPLICATION:
The GroundTrac® system is designed with a minimum amount of installed footings at greatly reduced
labor. The system integrates with readily available 1-1/2” schedule #40 galvanized water pipe. This
ground mount solution includes virtually everything needed to install modules with vertical posts up
to 5’ from rear footing, 30” from front footing. The installer will only need pipe, concrete and basic
construction skills to complete the installation. This fully engineered system utilizes Professional Solar
Products’ patented Slide-n-Clamp™ module clamps and support rail.
WARNING:
All ProSolar® products are engineered and tested to withstand
stated specifications (as stated on published engineering
documents) when installed properly. Failure to install properly
may decrease the performance of installation.
SAFETY:
All regional safety requirements should be followed when
installing ProSolar® products. All tools and equipment located
on the roof should be secured to avoid falling object hazards. All
equipment/tools should be properly maintained and inspected
prior to use. Any exposed studs should be protectively capped
to avoid injury. This racking system may be used to ground and/
or mount a PV module complying with UL 1703 only when the
specific module frame has been evaluated for grounding and/
or mounting compliance with the included instructions. This
installation manual is intended for use by professional installers
with a working knowledge of construction principles.
• Post hole digger or powered auger
• ProSolar® grade stake kit
• Cordless drill
• 1/2” wood drill bit
• 1/2” & 9/16” deep socket & ratchet (or impact
gun)
• Sledge hammer (small-approx. 14”)
• 3-1/2” (min) C-clamps
• String line and line level OR builders/laser level
• Pipe wrenches (two required)
• Tape Measure
• 3/16” long-arm hex wrench
• Torque wrench with 3/16” hex bit socket
• Cordless reciprocating saw/ band saw
• Wheelbarrow or concrete pump
• 1/2” Irwin® #10 UniBit™
• Framing square
• Sharpie ™ marker
Explanation or Install Tip
Critical for Safety
Important Product
Performance Information
Symbol Legend
Tool List
