Note: Red indicator is on for 20 seconds to indicate that the remote
control is ready to be programmed. The following steps must
be entered while Red indicator is on.
4Point the remote control toward the device that was turned
on in Step 1 and press in the first three-digit Set-
Up Code
number for that device using the number buttons (0-9) on the
remote control.
Your device will turn off when the correct Set-Up Code
number has been selected. If the device does not turn
off,
press in the next Set-Up Code number from the listing.
Continue to select Set-Up Code numbers until your device
turns off, before you proceed to Step 5.
Note: If you have tried all of the three digit Set-Up Code
numbers listed for your device and it still did not turn off,
please proceed to the Auto Search Method on page (10) to
program your remote control.
5Once your device turns off, press the Device Button selected
in Step 3 once again to store the Set-Up Code number. The
lights will flash twice.
6Test the remote control for your device. Try the POWER,
CHANNEL UP AND DOWN, VOLUME UP AND DOWN
buttons, etc. If any of the buttons do not perform as they
should, please repeat the set-up from Step 1 using the next
Set-Up Code number for your device.
Note: Some audio/video devices have separate buttons for POWER
ON and POWER OFF. To operate these devices on
the
remote, press the corresponding DEVICE Button to turn the
equipment ON and press the POWER button to turn the
equipment OFF.
7Please repeat the above steps to program the remote control
for each of your other devices.
Using Your Remote
9
