10 Operating instructions 0020292750_02
Condition: Control connected
▶Set the required domestic hot water
temperature on the control (→Control
operating instructions).
4.5.2 Switching off the domestic hot
water mode
▶From the basic display, press for at
least three seconds.
◁The domestic hot water mode is
switched off.
4.5.3 Switching eco mode on/off
Validity: Product with integrated hot water genera-
tion
Note
eco mode prioritises energy sav-
ings and deactivates the domestic
hot water warm start.
1. In the basic display, press seven
times to ensure that the symbol
flashes.
2. Press or to switch eco mode
on or off.
3. Confirm by pressing .
◁is shown on the display when
the eco mode is activated.
4.5.4 Switching eco mode on/off
Validity: Product for heating only
Note
Eco mode prioritises energy sav-
ings and reduces the product's
maximum output when post-heat-
ing the domestic hot water cylin-
der, provided that a high draw-off
rate is not detected at the same
time.
1. In the basic display, press seven
times to ensure that the symbol
flashes.
2. Press or to switch eco mode
on or off.
3. Confirm by pressing .
◁is shown on the display when
the eco mode is activated.
4.6 Displaying the product's
energy consumption
You have the option to call up the differ-
ent energy consumption values for your
product.
If the basic display is shown, call up the
menu in order to display the end user
level.
The product, the control and the app show
approximate values for energy consump-
tion, energy yield and efficiency, which
are extrapolated based on calculation al-
gorithms.
The values that are displayed in the app
may differ from the other display options
due to staggered transfer intervals.
The determined values depend on:
–Installation and system of the heating
installation
–User behaviour
–Seasonal weather effects
–Various tolerances of unit-internal com-
ponents
The recording of the values is only valid for
the product in the factory-delivered condi-
tion. Supplementary accessories, even if
they are installed on the product, as well
as any other components in the heating
system and other external consumers, are
not part of the data recording.
Deviations between the determined values
and the actual values may be significant.
The determined values are therefore not
suitable for creating or comparing energy
billing, for example.
Note
If the PCB is replaced, the saved
values are reset.
