Device Diagram
Please follow the following installation step
Please check the following items before installation, if any missing, please contact your dealer.
Power Supply Unit 1pc
Power Receiving Unit 1pc
User Manual 1pc
1 Turn off the signal and display device install the product with power on may damage the
transmission device;
2) Check the power consumption of network terminal, current and power voltage;
if it is 12V device, please select 15V power supply; refer to the power supply table, confirm if the
voltage meet the requirement after transmission;
if it is 24V device, please select 24V power supply;refer to the power supply table, confirm if the
voltage meet the requirement after transmission;
if it is PoE power supply, please select 48V 0.5A power supply, and make sure the ethernet
transmission distance is in 100 meters;
3) Connect power supply unit’s RJ45 with switch, and DC connector with power supply, then the
network cable connect with the RJ45-F;
4) In terminal device, connect the power receiving unit’s RJ45-M with network port, and DC power
connector with power, network cable connect with the RJ45-F;
5) Network terminal work normally.
) ,
Installation Step
This ethernet power supplies include apower supply unit and apower receiving unit, it uses in
10/100M network, it transfers the power for the remote device over Cat5/5e/6cable. This product
use 4,5,7,8pin to transfer power, the distance can up to 50 meters. At the same time ,the output
voltage is 15V,24V,48V optional. Besides, work with 4ch or 8ch power distribution wire. The
product can make various combination to save the cost and wiring .The product is widely used in
security surveillance monitor and network engineering, It'seasy application and stable function,
this product is widely used in security surveillance monitor and network engineering sites.
1) Please use standard Cat5e/6 cable to guarantee the power and ethernet transmission distance!
2) The product is passive, without stable voltage, current limit and control power circuit. Please select
the power according to the terminal device consumption,(refer to the voltage table）, and avoid to
damage the device!
Note
12
Injector Diagarm
Splitter Diagram
R 45-F
R 45-F
R 45-M
R 45-M
Power-F
Power-M
J
J
JJ
Pin Signal
1 Data
2 Data
3 Data
4 +Power
5 +Power
6 Data
7 -Power
8 -Power
Mid-Span
Cat5/5e/6
Power Supply Unit
Power Receiving Unit
Power15V
IP Camera
Network Switch
Power Input
Ethernet
Application 1 Single Channel Power Supply：
Network Switch
Power Input
Ethernet
DC15V
+
-
Power Distributrion Wire Power Input
IP Camera Power receiving Unit
Power Supply Unit
Cat5/5e/6
Application 2 Multi Channel Powr Supply：
Apply in 10/100M network, provide power for the terminal device in 0--50 distance;
Adopt Mid-Span:1,2,3, 6 pin to transfer ethernet; 4,5,7,8pin to transfer power;
According to the terminal device consumption, it can select 15V,24V,48V, at the same time is
related with the distance;
Multi power supply can use at the same time via power distribution wire;
Provide power for IP camera, wireless AP, IP telephone.
Feature
DCoE-01
DC over Ethernet
DCoE-01 DC over Ethernet
