Feature
1.Four kinds of charging current could be ajusted(250mA /500mA/700mA /1000mA)；
2.It can intelligent reccognize many kinds of batteries and charge, discharge, or test any combination of any size,
any capacity Ni-Mh / Ni-Cd / Cylindrical lithium battery.
3.Eevery battery has a separate LCD display to show charging or discharging parameters and test parameters,
including current (mA)/ capacity(mAh)/ voltage(V)/ time(h)/ inner resistance(mR);
4.Under charging model, you can charge batteries with different charging current. After full charging it will show the
parameters of full charging. +“FULL”+“End”；
5.Under discharging model, you can discharge batteries with different discharging current. After full discharging it
will show the parameters of full discharging.
6.Test model:Firstly, full charge the batteries-- turn to discharge automatically, after full discharge it can test the
battery capacity and then turn to charge again--it will show FULL after full charging;
7.Line 2 battery slot Charger、
Discharger、
TEST three models can be divided into groove independence at the same
time；
Button (MODE) description
The charger has two function keys (MODE, CURRENT) use simple and convenient;
Function keys :
1. mode key（MODE）Mode
Conversion Settings function in the work state: short press Option slot "MODE" -℃ trough, "CURRENT" -℃ slot
button, enter the desired slot battery settings; press 3S press "mode" or "CURRENT" button to access the function
setting status. Then press the function "mode" button, you can switch Charger, Discharger, TEST three modes;
2.Current key（CURRENT）
2.1 In working condition by short election groove "MODE" -℃ trough, "CURRENT" -℃ slot button, enter the
desired battery status query slots;
2.2 When you enter Setup mode Press "CURRENT" key. For regulating the functions of the charge current:
250mA, 500mA, 700mA, 1000mA or discharging current size: 250mA, 500mA;
operational mode
1 Charge Mode（charging mode）
1.1 When the charger is powered on, the LCD screen all the characters in the charger was full three seconds, 3
seconds will check whether the battery charger connected, if there is no battery in the display Null, if the battery is
placed too bad will display Null, if rechargeable batteries into default after 8 seconds to 250mA charge current; in
charge default screen mode and display the working status of charging the battery;
1.2 When the battery charger placed in three seconds the system automatically enters the charging current selection
mode, the screen displays the current default "250mA", in which eight seconds to select the period by CURRENT
250mA / 500mA / 700mA / 1000mA current charging system 8 seconds after locking your current selection to
recharge the battery, if within 8 seconds, did not make the set, then the system automatically 250mA current to
charge the battery, and the battery symbol will be "Happy" Happy way from left to right . At this current will not be able
to change, to change, you need to reset the battery mode;
1.3 During charging, you can short press the Mode button (MODE) or current key (CURRENT) See the grooves
voltage (mV) / current (mA) / capacity (mAh) / time (h) / resistance (mR) /, after the battery is fully charged, the
charge will show the complete data, also shows charge + end (end of charge) and a battery symbol full grid;
Remark:
Users should pay attention to the rechargeable battery maximum charging current, if not rapid charging, we
recommend charging 250mA, this is the safest and most beneficial to the battery;
