Pulsar VX32 Manuale utente

INSTRUCTION MANUAL FOR WATCH CALIBRE

VX32

THIS PRODUCT CONTAINS A BUTTON BATTERY

If swallowed or placed inside any part of the body, the battery can

cause severe or fatal injuries within 2 hours or less.

Button batteries are hazardous whether new or used. Keep batteries

out of reach of children.

If you think the battery may have been swallowed or placed inside

any part of the body, seek immediate medical attention. Contact the

Australian Poisons Information Centre immediately on 13 11 26

(New Zealand 0800 764 766) for 24 / 7 fast, expert advice.

ENGLISH

ANALOGUE WATCHES

SCREW DOWN CROWN

[for models with screw down crown]

1 Turn Crown counterclockwise until you no

longer feel the threads turning.

2 Crown can be pulled out.

Unlocking the crown

1 Push Crown back in to normal position.

2Turn Crown clockwise while pressing it lightly

until tight.

Locking the crown

* When using the watch in water:

Before using the watch in water, be sure the crown is screwed in completely.

Do not operate the crown when the watch is wet or in water.

English

HOW TO START THE MECHANICAL WATCH (Cal. Y621)

1 Pull out to the rst click.

2 Turn to show the previous day’s date.

3 Pull out to the second click.

TIME/CALENDAR SETTING FOR MODELS WITH

DATE CALENDAR

To initially start your watch, swing it from side to side in a horizontal arc

for about 30 seconds.

* If the watch is worn daily, PULSAR's automatic mechanism will wind the mainspring

automatically through normal wrist movement.

TIME SETTING FOR MODELS WITHOUT CALENDAR

CROWN

1 Pull out.

2 Turn to set the time.

3 Push back.

CROWN

English

4 Turn until the desired date appears.

* Turn Crown to advance Hour and Minute hands.

5 Turn to set the time.

6 Push back in to normal position.

TIME/CALENDAR SETTING FOR MODELS WITH DAY AND DATE CALENDAR

1 Pull out to the rst click.

2 Turn to show the previous day’s date.

3 Turn in the opposite direction to show

the previous day of the week.

For Cal. PC33, turn clockwise to set

the date only.

4 Pull out to the second click.

WED

CROWN

5 Turn until the desired date and day appears.

* Turn Crown to advance Hour and Minute hands.

6 Turn to set the time.

7 Push back in to normal position.

English

Notes on time setting:

1 When setting Minute hand of a quartz watch, advance it a few minutes

ahead and then turn it back to the exact time.

2 If your watch has three hands, pull out Crown all the way when Second

hand points at 12 o’clock. After adjusting the time, push Crown back in to

normal position in accordance with a time signal for "00" seconds.

Notes on calendar setting:

1The date will change gradually between 9:00 P.M. and 4:00 A.M. Therefore, do

not change the calendar during this time period. Otherwise, it may not change

properly. If it is necessary to set the calendar during that time period, ﬁrst

change the time to any time outside it, set the calendar and then reset the

correct time.

2 If your watch has a bilingual day calendar, choose the desired language.

When the day shifts automatically to the next day, the other language will

appear temporarily.

3 When setting the hour hand, check that AM/PM is correctly set.

The watch is so designed that the calendar changes once in 24 hours.

Turn the hands past the 12 o’clock marker to determine whether the time is

set for the A.M. or P.M. period. If the calendar changes, the time is set for

the A.M. period. If it does not change, the time is set for the P.M. period.

English

l As the battery is inserted at the factory to check the function and performance

of the watch, its actual life once in your possession may be less than the

specied period.

l When the battery expires, be sure to replace it as soon as possible to prevent

any malfunction.

l We recommend that you contact an AUTHORIZED PULSAR DEALER for

battery replacement.

Day setting for Cal. PC33

At the second click position, turn the hands clockwise and counter-

clockwise repeatedly between 11:15 p.m. and 3:45 a.m. to select the

desired day and language.

English

l Loss/gain (monthly rate) is less than 15 seconds (20 seconds for some

calibres) at normal temperature range (5°C ~ 35°C)(41°F ~ 95°F).

lThe battery is not rechargeable. Never attempt to recharge it, as this

may cause battery leakage or damage to the battery.

CAUTION

lDo not remove the battery from the watch.

lIf it is necessary to take out the battery, keep it out of the reach of

children. If a child swallows it, consult a doctor immediately.

lNever short-circuit, tamper with or heat the battery, and never expose

it to re. The battery may burst, become very hot or catch re.

WARNING

English

WATER RESISTANCE

lNon-water resistant

lWater resistance (5 bar)*

If “WATER RESISTANT 5

BAR” is inscribed on the

case back, your watch is

designed and manufactured

to withstand up to 5 bar and

is suitable for swimming, yachting and

taking a shower.

I f “ WATER RESISTANT 10

BAR”, “WATER RESISTANT 15

BAR” or “WATER RESISTANT

20 BAR” is inscribed on the

case back, your watch is

Water resistance (10 bar/15 bar/20 bar)*

designed and manufactured to with-

stand up to 10 bar/15 bar/20 bar and

is suitable for taking a bath, shallow

diving, but not for scuba diving.

We recommend that you wear a PULSAR

Diver’s watch for scuba diving.

If “WATER RESISTANT” is

not inscribed on the case

back, your watch is not water

resistant, and care should

be taken not to get it wet

If “WATER RESISTANT” is

inscribed on the case back,

your watch is designed and

manufactured to withstand up

to 3 bar, such as accidental

lWater resistance (3 bar)

contact with splashes of water or rain, but

it is not designed for swimming or diving.

as water may damage the movement. If

the watch becomes wet, we suggest that

you have it checked by an AUTHORIZED

PULSAR DEALER or SERVICE CENTER.

English

* Before using the water resistance 5, 10, 15 or 20 bar watch in water, be sure the

crown is pushed in completely.

Do not operate the crown when the watch is wet or in water. If used in sea water,

rinse the watch in fresh water and dry it completely.

* When taking a shower with the water resistance 5 bar watch, or taking a bath with

the water resistance 10, 15 or 20 bar watch, be sure to observe the following:

•Do not operate the crown when the watch is wet.

•If the watch is left in warm water, a slight time loss or gain may be caused.

This condition, however, will be corrected when the watch returns to normal

temperature.

NOTE:

Pressure in bar is a test pressure and should not be considered as corresponding to

actual diving depth since swimming movement tends to increase the pressure at a

given depth. Care should also be taken on diving into water.

TEMPERATURES

and 35°C (41° F and 95°F).

Temperatures over 60°C or 140°F

(50°C or 122°F for some calibres)

[for analogue quartz watch

only]

Your watch works with

stable accuracy within a

temperature range of 5° C

may cause battery leakage or shorten

the battery life.

Do not leave your watch in very low

temperatures below –10° C (+14° F)

for a long time since the cold may

cause a slight time loss or gain.

However, the above conditions will

be corrected when the watch returns

to normal temperature.

Indice

Manuali Orologio popolari di altre marche

Pandora

Pandora WATCH2 Manuale utente

Casio

Casio QW-4343 Manuale utente

Suunto

Suunto X6 Manuale utente

Seiko

Seiko N830 Manuale utente

MotionX

MotionX 365 Manuale utente

Garmin

Garmin VENU SQ 2 Manuale utente

QCY

QCY Watch GTC Manuale utente

Canyon

Canyon Cindy CNE-KW41WP Manuale utente

Esq

Esq Watches Guida all'installazione

Crane

Crane AA5-CDSM-3A Manuale utente

Timex

Timex W-214 Manuale utente

DETOMASO

DETOMASO MATERA Manuale utente

Geemarc

Geemarc Watch N Shake Manuale utente

LORUS

LORUS W590 Manuale utente

STENLILLE

STENLILLE Actío Manuale utente

Casio

Casio 5594 Manuale utente

Sinn

Sinn HUNTER'S WATCH 3. Edition Manuale utente

Slazenger

Slazenger SLZ800 Manuale utente