PYROD PFC2150 Manuale utente
PFC2150
51 cm color television
OWNER S MANUAL
Please read this manual carefully before using this TV set and keep it
for future reference.
Telefix Help Line Number:
1300 366 144
PFC2150
CON WA
Congratulations on you purchase of a new Electronics Australia Product!
This product has a one year warranty from the date of purchase. Please NOTE: This Warranty
is valid with a proof of purchase. Subject to the conditions of this warranty an authorized
service centre will perform the necessary repairs on this product without charge for the
period of 1 year from date of purchase.
This warranty only applies to products sold by Certified Electronics Australia P/L dealerships.
The warranty will void if service performed by an unauthorized service agent or dealership.
Proof of purchase must be presented when warranty service is requested.
This warranty is valid only if the product has been installed and maintained according to the
manufacturers manual and recommendations pertaining to normal use and reasonable care.
This product warranty covers this product for normal domestic use ONLY and does NOT
cover or accept warranty claims for accidents, misuse, neglect, alteration, unauthorized
repair, fire, floods or any damage caused by natural disasters. The authorized service centre
reserves the right to determine whether the fault has been caused by manufacturing defects
or failure of any component or material in this product.
WARRANTY
WARRANTY SERVICE
Telefix Help Line Number:
1300 366 144
Send or bring the product to your local authorized service centre.
Please Note: You are responsible for all freight charges to & from your
nearest authorized service centre.
NO WARRANTY SERVICE WILL BE PERFORMED WITHOUT PROOF OF PURCHASE
CONTENTS
Before Operation
Basic operation
Warning and cautions.................................................................................1
Installation...................................................................................................2
Aerial connection........................................................................................2
Preparation of the remote control...............................................................2
Function buttons and external sockets.....................................................3
Front panel of the TV set...........................................................................3
Rear panel of the TV set.............................................................................3
Using the remote control............................................................................4
Switching the TV set on/off........................................................................5
Watching TV ................................................................................................6
Watching TV program................................................................................6
Program swap and auto scan functions.....................................................7
Searching channel.......................................................................................8
Full automatic mode.................................................................................8
Semi-automatic search..............................................................................9
Manual fine tune......................................................................................10
Program skip ...........................................................................................11
Convenient picture and sound control functions...................................12
Multiple picture modes ...........................................................................12
Black stretch and noise reduce................................................................13
Mute and Fade ........................................................................................14
Time functions............................................................................................15
Clock setting and timer on/off functions................................................15
Sleep timer and program preset ...........................................................16
Setup function .........................................................................................17
Screen saver and Calendar.....................................................................17
AVL .........................................................................................................18
Organise function......................................................................................19
Seting the lock...........................................................................................20
DVD Operation
Basic Playback..........................................................................................22
Advanced Playback...................................................................................23
Special Function .......................................................................................24
DVD System Setup....................................................................................25
Playable Discs...........................................................................................29
Disc Protection and DVD Characteristics...............................................30
Others
Connection to the external audio and video equipment.......................31
Troubleshooting guide .............................................................................32
Specifications............................................................................................33
Warning and cautions
1. When you clean the TV set, please
pull out the power plug from AC outlet.
Don't clean the cabinet and the
screen with petrol, paraffin or other
powerful solvents. Permanent damage
will result !
4. Do not place the TV set near rain or
moisture as it may cause an electric
shock, or the TV set to catch fire. The
TV set must only
be used in dry in
door locations.
5. The back cover must only be
removed by a registered electrical
service person. Removing the back
cover may result in electric shock, fire
or damage to
the TV set.
3. Don't place the
TV set in direct
sunlight or near a
heat source.
6. If the TV set is not going to be used
for a long time, or there is a severe
thunder & Lighting storm, we
recommended that the TV set be
disconnected you disconnect the TV
set from the AC power outlet and
remove the aerial plug.
Cleaning the tube
If the picture tube require cleaning, disconnect the power and use a dry
soft cotton cloth. Do not use any cleaner or abrasive cloths.
2. In order to prolong the life of the
product, please use in a well
ventilated location. Leave a 10cm gap
around it. Do not
obstruct air flowwith
soft furnishings
above or beneath.
OUT
IN
VIDEO
L R
AUDIO
COAXIAL
Installation
Aerial Connection
If the picture is not clear or snowy, we recommend that you use an outdoor
aerial.In different places, the suitable antenna type and position are different.
Preparation for the remote control
Battery installation Tips for remote operation
Remove the battery cover. !When the remote control will not be used
for a long period of time or when the
batteries are worn out, remove the
batteries to prevent leakage.
! Do not throw the batteries into fire.
Dispose of used batteries at your local
recycling centre.
! Do not drop, dampen or disassemble
the remote control.
Insert two size AA batteries matching
the +/-polarities of the battery to the +/-
marks inside the battery compartment.
!
!
300 twin-lead cable
Antenna adapter
75 coaxial cable
Plug
AC power socket
Aerial input
75 standard
coaxial type
Note:
* It is recommended that a 75 ohm coaxial antenna is used to avoid
interference.
*To avoid interference from electrical signals, do not bind the antenna
cable together with any mains lead.
(Not supplied)
(Not supplied)
22
Function Buttons and External Sockets
Rear panel of the TV set
Front panel the TV set
Stop
OUT
IN
VIDEO L R
AUDIO
Audio left channelinput terminal
Audio right channelinput terminal
Audio left channeloutput terminal
Audio right channeloutput terminal
Antenna input socket
Video input terminal
Video output terminal
COAXIAL
COAXIAL
Using the Remote Control
Stand By
DVD Open/close
Calendar
Scan
TV Time Menu
Mute
Former Program
Call Screen Display
Program Number
(Not available)
TV/AV Exchange
Digital Selector
TV/DVD
Volume/Channel Selection
MENU
Exit Screen Display
Picture Mode
DVD STOP
(Not available)
DVD SETUP
DVD PAUSE/STEP
DVD FAST REVERSE
DVD FAST FORWARD
DVD MENU
DVD NEXT
DVD PREVIOUS
DVD REPEAT
DVD PLAY/ENTER
DVD A-B REPEAT
DVD Cursor Move button
DVD SLOW
DVD ANGLE
DVD SEARCH
DVD Audio
DVD TITLE
DVD PROGRAM
DVD CALL
DVD SUBTITLE
Zoom
DVD 10+
Child Lock
(Not available)
Buttons on the remote control
UP
DOWN
LEFT RIGHT
POWER TIME OPEN/CLOSE
SCAN SWAP CALL MUTE
1234
5678
9900-/---/--
TV/AV
TV/DVD
P+
P-
V- V+
MENU
EXIT P.STD
STOP SETUP PAUSE/STEP
REV FWD .PREV NEXT
D.MENU REPEAT A-B
PLAY/ENTER SLOW
ANGLE TITLE/PBC SEARCH
AUDIO
SUBTITLE
D.CALL
CALENDAR
PROGRAM ZOOM
10+
H.LOCK
4
AUTO
BG
Switching on/ off the TV set
Switching the TV set on/ off
Switching the TV set on/ off
2 If the indicator is lighting in red, press the button
on the remote control again.
Note
1 When you can't operate the TV set with a
remote control, you can turn it pressing
the P+ on the TV set (Child Lock must
be turned off).
on by
/- buttons
2 If you want to change to standby mode,
press down the button on the remote
control. Press again to switch back on.
3 If you want to fully switch off the power supply
for the TV set, please press the power switch
button on the front panel.
Auto switch off function
POWER
This section explains the use of the power button and remote handset
to turn your unit on and off.
1 Press the AC power switch on the front of the
TV. The power indicator will light.
If transmissions are finished for the day, the
Automatic Power Off feature will put the TV to
standby automatically. The Automatic Power
Off feature will not operate in AV mode or
when the background is set to off (see page
17).
P+
P-
V- V+
MENU
P+
P-
V- V+
MENU
Watching TV
Watching TV programs
How to select TV program
Select the desired program
Select the desired sound
You can watch a TV program on a channel which has been tuned to a broadcast.
1 Using number buttons
2 Using the P+/- buttons
Press the P+button to increasechannel number.
Press the P-button to decreasechannel number.
Press the V-/+ buttons on the remote or the front of the
TV set to adjust the volume level. The range is 0~100. When
the volume buttons are pressed the volume level is
displayed automatically on the TV screen.
Directly enter thechannel number withthe numeric keypad
on the remotecontrol.
Toselect channel numbersbetween 10 ~99 press [-/--]button
and enter thetwo digit channelnumber
Toselect channel numbersbetween 100 ~218 press [-/--]button
twice and enterthe 3 digitchannel number
How to select the menu
Press the MENUbutton and
the menus willappear at the
bottom of thescreen. The
PIC icon willinitially be
flashing. Each subsequent
press of themenu button
will highlight SOU(sound),
FUN (function), TUN
(tuning) icons respectively.
Press the P-button to display
the appropriate menu.PressEXIT to exit.
1234
5678
9900
18
AUTO
BG
8
AUTO
BG
18
AUTO
BG
Watching TV continued
Press the SWAP button to select thechannel you were watching previously.
Auto scan functionscans through all programs in memory including those with
"skip" set to"off" (see "Program skip" on page 13).
Program swap and auto scan functions
Program swap
Auto program scan
1 Press the SCAN button to
scan through all the memorised
TV programs. The scan will
pause for about 2 seconds on
each channel.
2 If you want to stop the
function during auto tunning,
simply press the SCAN button
again.
SWAP
SCAN
Press the SWAP button to
select the channelyou were
watching previously.
1
AUTO
BG
BROWSE
2
BROWSE
3
BROWSE
1
AUTO
BG
BROWSE
Indice
Altri manuali PYROD TV
