Range Master LEIHDS120SC Manuale di istruzioni
LEIHDS120SC/
Users Guide
&
Installation Instructions
CONTENTS
IMPORTANT SAFETY INFORMATION Installation Page 2
Child Safety 2
Maintenance and service
YOUR APPLIANCE
OPERATING INSTRUCTIONS Cooker Hood Controls 4
To Operate 5
Recirculation 5
Extraction 5
MAINTENANCE AND CLEANING Metal Grease Filters 6
Charcoal Filter 6
Lighting 7
Cleaning 7
INSTALLATION INSTRUCTIONS Technical Information 8
ELECTRICAL CONNECTION Elecrical Requirements 9
Electrical Connection 9
INSTALLING THE CHIMNEY HOOD Components 10
Installation Requirements 10
Clearance Heights 11
Fitting the Wall Brackets 11
Drilling the Holes 1 12
Fixing the Canopy 12
Ducting 1
Recirculation 1
Fitting the Recirculation Ducting 1
Fitting the Telescopic Chimney 14
1
These arnings are provided in the interests of safety. Ensure that you understand
them all before installing or using this appliance. Your safety is of paramount importance.
If you are unsure about the meaning of any of these arnings contact the Helpline.
•INSTALLATION
•Any installation work must be
undertaken by a qualified electrician or
a competent person.
•This hood must be installed in
accordance with the installation
instructions and all measurements
must be adhered to.
•If the cooker hood is installed for use
above a gas appliance then the
provision for ventilation must be in
accordance with the latest edition of
the Gas Safety Codes of Practice and
the Gas Safety (Installation & Use)
Regulations, the Building Regulations
issued by the Department of the
Environment, the Building Standards
(Scotland) (Consolidated) Regulations
issued by the Scottish Development
Department.
•The fan motor of this cooker hood
incorporates a cut-out device which will
operate if the cooker hood is installed
below the minimum height
recommended under the section
‘Clearance Height’, or if the motor
becomes overheated. If the cut-out
device is activated, switch off the fan
motor and allow the cooker hood to
cool. The cut-out device will reset itself
when the fan motor has cooled
significantly.
•It is dangerous to alter the
specifications or modify this product in
any way.
•When installed between adjoining wall
cabinets the wall cabinets must not
overhang the hob.
IMPORTANT SAFETY INFORMATION
•If the room where the cooker hood is to
be used contains a fuel burning appliance
such as a central heating boiler then its
flue must be of the room sealed or
balanced flue type.
•If other types of flue or appliances are
fitted ensure that there is an adequate
supply of air to the room.
•The ducting system for this appliance
must not be connected to any existing
ventilation system that is being used for
any other purpose.
•Do not install above a cooker with a high-
level grill.
•CHILD SAFETY
•This appliance is designed to be operated
by adults. Children should not be allowed
to tamper with the appliance.
•DURING USE
•This product is for domestic use only.
•Never leave frying pans unattended during
use as overheated fats and oils might
catch fire.
•Never do flambé cooking under this
cooker hood.
•Do not leave naked flames under the
cooker hood.
2
IMPORTANT SAFETY INFORMATION
•MAINTENANCE AND SERVICE
•This appliance can be a hazard if the
grease filters and charcoal filters are not
cleaned and replaced as recommended.
•Always insist on genuine RANGEmaster
spare parts.
•Under no circumstances should you
attempt to repair the appliance yourself.
Repairs carried out by inexperienced
persons may cause injury or more
serious malfunction. In the event of your
chimney hood requiring service contact:
RANGEmaster Helpline: 0845 603
5312, or
Consumer Services: 0870 789 5107
OPERATING INSTRUCTIONS
The chimney hood is designed to extract
unpleasant odours from the kitchen, it will
not extract steam. The appliance can be
installed to recirculate or extract
contaminated air.
COOKER HOOD CONTROLS
The chimney hood functions are controlled
by four push buttons located centrally on
the front of the canopy.
BUTTON L- Turns the worktop lighting
On and Off.
YOUR APPLIANCE
BUTTON V1 - Turns the fan On and Off at
the low speed setting. This is
an ideal speed when cooking
for long periods as the
continuous flow of air is
particularly quiet.
BUTTON V2 - Medium speed, suitable for
most normal operating
conditions. This speed gives
an excellent ratio between
treated air when the hood is
recirculated and the level of
noise.
BUTTON V3 - High speed, suitable for
removing strong odours when
frying or simmering for long
periods.
4
TO OPERATE
Select the required fan speed and light if
required.
To obtain the best performance when cooking
it is advisable to switch the chimney hood on
for a few minutes before you start cooking
and leave it running for about 15 minutes after
finishing.
RECIRCULATION
In the recirculation mode contaminated air
enters the chimney hood through the grease
filter cassettes. The air is cleaned as it passes
through the charcoal filter and is passed out
through grilles in either side of the chimney
stack into the kitchen.
EXTRACTION
In the extraction mode contaminated air
enters the chimney hood through the grease
filter cassettes and is passed out through
ducting into the atmosphere.
When used in the ducting mode
the charcoal filter is not required.
Never do flambé cooking under
this chimney hood.
When using a gas hob under this
chimney hood never leave the
burners uncovered hile the
hood is in use or hen the pans
have been removed.
The grease filters and the
charcoal filter should be cleaned
and replaced as recommended or
more frequently if the hood is
used consistently over 4 hours
per day.
OPERATING INSTRUCTIONS
5
Regular maintenance and cleaning ill ensure good performance and reliability, hile
extending the orking life of the hood. Special attention should be paid to the grease
filter cassettes and the charcoal filter hen the hood is used in the recirculation mode.
Before carrying out any mainte-
nance or cleaning isolate the cooker hood
from the mains supply.
METAL GREASE FILTERS
The grease filters absorb grease and dust
during cooking to help keep the chimney hood
clean inside, and should be cleaned every
month with normal usage or more frequently
if the hood is used consistently over 4 hours
per day.
Remove the metal grease filter
cassettes one at a time, by pressing the
release catch towards the rear of the hood
as illustrated opposite. When replacing the
filters ensure that the handle faces forwards.
The metal grease filters can be washed in a
dishwasher or by hand using a mild detergent
or liquid soap.
CHARCOAL FILTER
In the recirculation mode the activated
charcoal filter absorbs smells and unwanted
odours.
The charcoal filter cannot be cleaned or
regenerated and must be replaced every four
months, or more frequently if the hood is used
consistently over 4 hours per day.
To replace the charcoal filter, first
remove the metal grease filters and press
against the plastic retaining clips to remove
the charcoal filter as illustrated opposite.
We recommend that you wear rubber gloves
when removing the charcoal filter as the filter
will be saturated in grease. Put the filter into
a polythene bag or container so that the
grease and dirt cannot spill onto clothing of
furnishing.
MAINTENANCE AND CLEANING
THIS APPLIANCE CAN BE A
POSSIBLE FIRE HAZARD IF THE GREASE
FILTERS ARE NOT CLEANED AND THE
CHARCOAL FILTERS REPLACED AS
RECOMMENDED.
Replacement charcoal filters may be
purchased by returning the enclosed order
form, or by telephoning 01803 296155 if you
wish to pay by credit card
6
LIGHTING
The canopy is fitted with three 20W halogen
spotlamps. If one of the spotlamps fails to
function check that the two pins are correctly
inserted into the lamp holder.
To replace a spotlamp remove the two
screws, which secure the lens retaining ring
and glass lens as illustrated. Take care to
ensure the lens and retaining ring are
supported while removing the screws. Extract
the spotlamp from the lamp holder by pulling
gently.
Replacement spotlamps are specified 2 0V
20W.
When replacing the spotlamps, make sure
that the two pins are correctly inserted in the
lamp holder, and then replace the glass lens
and retaining ring.
CLEANING
We recommend the chimney hood is cleaned
using a damp cloth wrung out in warm soapy
water using a mild liquid household cleaner.
Never use excessive amounts of
ater hen cleaning, in particular
around the control buttons.
Never use thinners or products
containing alcohol, as they ill
damage the painted or bright metal
finish.
Never use abrasive cleaning
materials, or scouring pads in
particular hen cleaning painted or
bright metal finish.
MAINTENANCE AND CLEANING
7
It is dangerous to alter the specifications or attempt to modify this chimney
hood in any ay.
TECHNICAL INFORMATION
DIMENSIONS CANOPY: Height 60mm
Width 1198mm
Depth 490mm
CHIMNEY: Height - Upper Chimney 215mm
Lower Chimney 740mm
Width 00mm
Depth 260mm
ELECTRICAL SUPPLY VOLTAGE: ~50Hz 2 0V
POWER CONSUMPTION: 200W
FAN: 140W
SPOTLAMPS: x20W 60W
PERFORMANCE SPEEDS
CAPACITY m /h* 550
CAPACIITY m /h** 690
PRESSURE PA 40
INPUT W 200
NOISE LEVEL dBA*** 67
*IEC 61591 method for cooker hoods in evacuation mode - ** IEC 61591 method with free delivery - ***IEC
60704-2-1 method
Note: CE Marking certifies that this appliance complies ith the requirements
laid do n in EEC directive 89:336 (Electromagnetic compatibility) and
subsequent modifications and Lo Voltage directive 72/23/E.
INSTALLATION INSTRUCTIONS
8
ELECTRICAL REQUIREMENTS
Any permanent electrical installation must
comply with the latest I.E.E. Regulations and
local Electricity Board regulations. For your
own safety this should be undertaken by a
qualified electrician e.g. your local Electricity
Board, or a contractor who is on the roll of
the National Inspection Council for Electrical
Installation Contracting (NICEIC).
ELECTRICAL CONNECTION
Before connecting to the mains supply
ensure that the mains voltage corresponds
to the voltage on the rating plate inside the
cooker hood.
This appliance is fitted with a core mains
cable and must be permanently connected
to the electricity supply via a double-pole
switch having mm minimum contact gap on
each pole. A Switched Fuse Connection Unit
to BS.1 6 Part 4, fitted with a Amp fuse, is
a recommended mains supply connection
accessory to ensure compliance with the
Safety Requirements applicable to fixed
wiring instructions.
This appliance conforms to BS.800:1988 and
EEC Directive No. 78 08 regarding
suppression of radio and television
interference.
ELECTRICAL CONNECTION
THIS APPLIANCE MUST BE EARTHED
9
Altri manuali Range Master Cappa di ventilazione
Range Master
Range Master ZEST HOOD Manuale utente
Range Master
Range Master RM60000 SERIES Manuale
Range Master
Range Master 63000 Series Manuale utente
Range Master
Range Master RMDD3004 Manuale utente
Range Master
Range Master RMG1H60SG Manuale utente
Range Master
Range Master 64000 series Manuale utente
Range Master
Range Master 61000 Series Manuale utente
Range Master
Range Master HI-LITE HLTHDS90 Manuale utente
Range Master
Range Master RM51000 Series Manuale utente
Range Master
Range Master RMHDT110SS Manuale di istruzioni
Range Master
Range Master RMPE Manuale utente
Range Master
Range Master HI-LITE HLTHDS90 Manuale utente
Range Master
Range Master 63000EX Series Manuale utente
Range Master
Range Master GLX490 RM Manuale utente
Range Master
Range Master RMG2H60SS Manuale utente
Range Master
Range Master RM61000EX series Manuale utente
Range Master
Range Master RM65000 Series Manuale utente
Range Master
Range Master RMIP45 Manuale utente
Range Master
Range Master LEIHDC70BB Manuale utente
Range Master
Range Master RM51000 Series Manuale utente
