4
Troubleshooting
If the dishes are not warm enough, make sure:
• the appliance is on.
• the right temperature has been set.
• the heat openings are not covered by large dishes or
soup-plates.
• the dishes have been warmed for a long enough time.
The crockery does not heat up.
Check whether, you can hear the noise from the fan or not. If
you can hear the noise from the fan:
• there could be problem with the heater element.
• if you cannot hear the noise from the fan: There could
be problem with the fan. - or the mains fuse has blown.
The crockery is too hot.
• there could be faulty on temperature control.
The on/o switch does not light up when the appliance is
switched on.
• there could be defective on the indicator light of the
switch
Location of Warming Drawer
Before connecting the appliance to the mains supply make
sure that the voltage and frequency correspond to the rating
on the data plate. This data must be complied with in order to
avoid the risk of damage to the appliance. Consult a qualied
electrician if in any doubt.
The plate warmer may only be built in combination with
those appliances quoted by the manufacturer as being
suitable. The manufacturer cannot guarantee trouble free
operation if the appliance is operated in combination with
appliances other than those quoted by the manufacturer as
being suitable.
When building in the plate warmer in combination with
another suitable appliance, the plate warmer must be tted
above a xed interim shelf in the housing unit to ensure that
the housing unit can support both its weight and that of the
other appliance.
The warming drawer may be installed in a kitchen/kitchen
diner but NOT in a room containing a bath or shower.
This appliance is designed for domestic cooking only. Use for
any other purpose could invalidate any warranty or liability
claim.
The kitchen should be dry and have eective ventilation
according to the existing technical provisions.
The mains lead behind the warming drawer must be placed
in such manner to avoid touching the back panel of the oven
because of the heat it develops during operation.
Remove all packaging materials (foils, articial foam, nails,
etc) away from children as they present potential danger.
Electrical Connection
The appliance is supplied with a power cord and plug for
connection to a 220-240 V mains supply.
The voltage, rated load and plug rating are given on the data
plate. Please ensure these matches the household mains
supply.
Connection should be made via a switched socket which
is easily accessible after installation. For extra safety it is
advisable to install a residual current device (RCD), with a trip
current of 30 mA. Do not connect via an extension lead.
WARNING THIS APPLIANCE MUST BE EARTHED
The wires in the mains lead are coloured in accordance with
the following code:
• Green/ yellow = earth
• Blue = neutral
• Brown = live
As the colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifying
the terminals in your plug proceed as follows when is
necessary to change the plug:
The wire which is coloured green and yellow must be
connected to the terminal in the plug which is marked with
the letter E or by the earth symbol or coloured green or
green and yellow.
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
