Raymarine STV37 Istruzioni per l'installazione
INSTALLATION & OPERATION
INSTRUCTIONS
STV37 / STV45
Safety notices
Warning: Product installation and
operation
This product must be installed and operated in
accordance with the instructions provided. Failure to
do so could result in personal injury, damage to your
boat and/or poor product performance.
Caution: Power supply protection
When installing this product ensure the power source
is adequately protected by means of a suitably-rated
fuse or automatic circuit breaker.
Caution: Use correct lifting point
When lifting the antenna unit, always lift from the base
plate. Do NOT use the antenna cover or damage to
the cover could occur.
Caution: Do not damage connectors
Take care to avoid damage to the connectors
underneath the antenna base plate when moving the
unit. Do NOT use these connectors to lift the unit.
Caution: Remove transit packing
Before installing or operating the product, open the
antenna unit cover and remove the foam transit
packing inserts from the unit base.
Caution: Antenna coating
Do NOT paint or apply any other finish to the antenna
This could degrade performance beyond
acceptable limits.
Please carefully read and follow the installation, operating and
maintenance procedures, to ensure optimum performance.
Geographic location
Your STV system will operate in various geographic regions,
dependant upon the type of satellite signal available.
Broadly speaking dierent regions around the globe use either
circular or linear polarization for DVB satellite broadcasts. Each
signals.
Some examples of regions using circular and linear polarization
are below.
Circular polarization:
• North America
Linear polarization:
• Europe
• Australia
• New Zealand
• China
• Middle East
For further assistance please refer to your regional satellite service
providers or Raymarine technical support.
Changing location
If you change your area of operation, you may need to arrange for
•Adjust the antenna low noise block (LNB) as appropriate for the
area in which you are operating.
• Update the region information using your control unit (ACU) or a
PC running the GUI software.
• Ensure that your satellite receivers (IRDs) will operate and receive
DVB broadcasts at your new location.
Important: Please refer all servicing / component replacement to
authorized Raymarine agents.
Satellite coverage
Up to date coverage maps and satellite information may be found
on the appropriate website of your satellite service provider.
Television reception
For full functionality of your STV System, you must subscribe to the
relevant service(s) from the appropriate service provider(s). Full
details of service providers are given.
EMC installation guidelines
Raymarine equipment and accessories conform to the appropriate
Electromagnetic Compatibility (EMC) regulations, to minimize
electromagnetic interference between equipment and minimize the
eect such interference could have on the performance of your
system
Correct installation is required to ensure that EMC performance is
not compromised.
For optimum EMC performance we recommend that wherever
possible:
• Raymarine equipment and cables connected to it are:
– At least1m(3ft)from any equipment transmitting or cables
carrying radio signals e.g. VHF radios, cables and antennas.
STV unit is configured to receive either Linear or Circular polarized
modification to your STV system.
In the case of SSB radios, the distance should be increased
to7ft(2m).
– More than 2 m (7 ft) from the path of a radar beam. A radar
beam can normally be assumed to spread 20 degrees above
and below the radiating element.
• The product is supplied from a separate battery from that used
for engine start. This is important to prevent erratic behavior
and data loss which can occur if the engine start does not have
a separate battery.
• Cables are not cut or extended, unless doing so is detailed in
the installation manual.
Note: Where constraints on the installation prevent any of
the above recommendations, always ensure the maximum
possible separation between dierent items of electrical
equipment, to provide the best conditions for EMC performance
throughout the installation
Productdisposal
DisposeofthisproductinaccordancewiththeWEEEDirective.
The Waste Electrical and Electronic Equipment (WEEE)
Directive requires the recycling of waste electrical and electronic
equipment. Whilst the WEEE Directive does not apply to some
Raymarine products, we support its policy and ask you to be aware
oow to dispose of this product.
Suppression ferrites
Raymarine cables may be tted with suppression f errites. These
are important for correct EMC performance. If a ferrite has to be
removed for any purpose (e.g. installation or maintenance), it must
be replaced in the original position before the product is used.
Use only ferrites of the correct type, supplied by Raymarine
authorized dealers.
Connections to otherequipment
Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment
using a cable not supplied by Raymarine, a suppression ferrite
MUST always be attached to the cable near the Raymarine unit.
• Raymarine specified cables are used.
Technical accuracy
To the best of our knowledge, the information in this document was
correct at the time it was produced. However, Raymarine cannot
accept liability for any inaccuracies or omissions it may contain. In
addition, our policy of continuous product improvement may change
specifications without notice. As a result, Raymarine cannot accept
liability for any differences between the product and this document.
Introduction to Raymarine STV
Raymarine STV37 / STV45 is a digital satellite antenna system
designed specifically for all types of vessels (anchored or transit)
to automatically identify, track and capture satellite signals from
the Digital Video Broadcasting (DVB: the international standard for
digital TV transmissions) compatible satellites.
In details, Raymarine STV37 / STV45 has Wide Range Search (WRS)
algorithm, which minimizes the search time during initialization, and
Dynamic Beam Tilting (DBT) technology, which dynamically shapes
the antenna beam to utilize stabilization. While tracking the target
satellite, DBT technology uses a high-performance, constantly
adjusting sub-reflector which allows the antenna to remain relatively
still, eliminating the constant whine of stepper motors while staying
locked on to the satellites.
The STV37 / STV45 has a built-in GPS system which enhances the
speed of satellite signals acquisitions. In addition, the “Auto Skew”
variant of the STV45 provides the embedded auto skew angle
control system to maintain the optimal signal strength and increase
the quality of satellite receptions in weak satellite single coverage
area.
Introduction
Raymarine Satellite TV Antenna Systems Introduction
Features of Raymarine STV37 / STV45
Enjoy satellite broadcasts at sea
Raymarine STV37 / STV45 is the most modern antenna
system that enables you to receive a high quality
broadcasting signal at sea, where the atmospheric and
environmental condition are very harsh. This fully automatic
control system allows you to simply turn the power switch
on, and have crystal clear, high quality satellite television in
motion or at anchor.
High quality antenna
High tech parabolic antenna technology has been adopted
for this antenna system, which is optimal for marine
conditions. This enables you to receive the optimal signal
level even when it is raining or snowing.
Fast and ecient search for the satellite
The WRS (Wide Range Search) algorithm allows for the
antenna system to search the satellite within the shortest
amount of time and to detect the satellite signal under any
position and with any directional movement of the vessel.
Easy installation and outstanding reliability
Raymarine STV37 / STV45 uses only one RF cable for
installation. This makes installation easy. Power, RF and
data signals transfer from the antenna to the ACU through
this single cable. In addition, Raymarine STV37 / STV45
provides highly reliable system through the implementation
of a modularized design, and the usage of strictly proven
components.
Built-in GPS
The built-in GPS system enhances the speed of acquisition
of the satellite signal and provides Raymarine STV37 / STV45
even higher performance.
Ethernet Port for management
The Ethernet Port on the rear panel of the ACU enables
direct and simple network connection between a PC and
the ACU. By connecting to ISP or the modem linked with
VSAT systems, Raymarine STV37 / STV45 can be monitored,
controlled, and diagnosed remotely from anywhere,
anytime through the TCP/IP protocol. This not only can save
tremendous time but also save the cost generated from the
hundreds of routine maintenance activities such as operating
firmware upgrades, tracking parameters resets, and system
diagnostic.
Wireless Connectivity and Aptus mobile
The built-in WiFi enables the ACU to be wirelessly
connected. Any kind of wireless devices such as PCs,
laptops and smartphones can be used to connect to the ACU
and monitor, control and change the settings of the system
wirelessly. The Aptus mobile app is available for download
to access the ACU via Wi-Fi and operate the antenna from
iPhone, iPad or other network devices. iPhone and iPad are
registered trademarks of Apple Inc.
Built-in automatic skew angle control system (STV45 Only)
The automatic skew control system allows Raymarine STV45
to maintain the optimal skew angle at all times and ensure
maximum level of satellite signal level receptions.
Raymarine’s environmental test standards certified
These standards are much severer than a typical
experienced marine equipment condition. All testes
performed with one unit through all continued sequences.
Raymarine standards meet LR and DNV standards as
well as EN60945.
Basic System Configuration
For your satellite TV system to function properly, the
system will have to be connected with all of the provided
components as shown on the right (Refer to the next chapter
‘Installation’ in this manual for more detailed connection
instructions). Separate purchase of a satellite receiver and a
TV is required.
Note: STV37 can only be connected to one receiver.
Note 2: Dish and Bell TV users please refer to the separate
Dish MIM Installation and User Manual.
Figure 01 : Basic Configuration with 2 Receivers
Raymarine Satellite TV Antenna Systems
The components of the Raymarine STV37 / STV45 are
designed as a modular system so that it is suitable for simple
installation on all types of vessels.
System Components
Antenna Unit
The antenna of Raymarine STV37 / STV45 is comprised of the
following components for optimum search and satellite signal
reception.
•Mechanical Unit – manipulates the antenna to receive the
optimal satellite signal, regardless of the movement of the
vessel.
• Control Unit – controls mechanical operation of the antenna.
•RF Unit – transmits the optimum satellite signal to the
receiver.
•Radome – protects the antenna from the severe marine
environment.
Installation
Figure 02 : Radome
Antenna Control Unit (ACU)
The Antenna Control Unit (ACU) provides the power to the
antenna and controls the various settings of the antenna.
The digital VFD (Vacuum Fluorescent Display) allows for easy
operation of the ACU, even in the dark.
The functions of the ACU are as follows:
• Controls the antenna system
• Provides power to the antenna unit
• Monitors the antenna status
• Changes the target satellite
• Set up the user environment
• Set the current GPS information
• Set satellite information
• Move antenna manually
• Perform self-diagnosis of the antenna
• Set up the interface with a PC
Figure 03 : Front & Rear of ACU
Front
Rear
Antenna Control Unit
Raymarine Satellite TV Antenna Systems
Installation Kit
Contains the items required for securing the antenna unit and
ACU to the vessel.
Other Components
No Components Size Qty
1 ACU Table Mounting Bracket - 2EA
2 RF Cable (ACU to Antenna) 49ft (15m) 1EA
3 RF Cable (ACU to Receiver) 10ft (3m) 1EA
4 DC Power Cable 33ft (10m) 1EA
5 PC Serial Cable 6ft (1.8m) 1EA
6 NMEA Connector AK950-2 1EA
7 Power Connector AK950-3 1EA
8 Hex Bolt M8x35L 5EA
9 Tapping Screw ø4x16L 5EA
ø3x8L 5EA
10 Flat Washer M8 5EA
11 Spring Washer M8 5EA
12 Aptus CD - 1EA
13 User Manual - 1EA
14 Mounting Template STV37 1EA
STV45
15 Quick Installation Guide - 1EA
Figure 05 : List of the Supplied Parts
Figure 04 : Installation Bolt Kit
Hex.Bolt
5
Hex. Nut
5
Spring Washer
5
Flat Washer
5
Antenna
Item
Qty
ACU
Item
Qty
Size
Self-Tapping Screw
5
(M4 X 16L)
Machine Screw
5
(M3 X 8L)
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Raymarine Antenna
Manuali Antenna popolari di altre marche
Alfa Network
Alfa Network APA-L01 Manuale utente
Naval
Naval PR-422CA Manuale utente
Feig Electronic
Feig Electronic ID ISC.ANTH200/200 Series Manuale utente
TERK Technologies
TERK Technologies TV44 Manuale utente
Directive Systems & Engineering
Directive Systems & Engineering DSE2324LYRMK Manuale utente
HP
HP J8999A Manuale utente
