Raytec RAYMAX WARRIOR Manuale utente

illuminators installation guide

LUX WARRIORMAX and

This installation guide provides instructions for installing the RAYMAX Infra-Red and

RAYLUX White-Light WARRIOR series of explosion protected illuminators.

1. Safety Instructions

2. Installation

3. Maintenance

4. Technical Speciﬁcation

5. Trouble Shooting

Version 4.0

Important information

• TheWARRIORseriesofexplosionprotectedilluminatorsarespecialistdevices,

certiﬁed for use in speciﬁc operating environments.

• Theunitsmustbeinstalledinaccordwiththeseinstructions,mustbecorrectly

certiedforthespecicoperatingenvironmentandmustbeinstalledbysuitably

qualiﬁed personnel.

• Ifyouhaveanyqueriesabouttheinstallationorthecerticationoftheunit–please

contactRaytecforimmediateassistanceandadvice.

Overview

1.Safetyinstructions

1. ReadthisleaetcarefullybeforecommencingtoinstalltheWARRIORunitandretainit

forfutureuse.Installationcanonlybecarriedoutbysuitablyqualiedpersonnel.

2. Checkthecerticationtoensurethatthemainssupplyandtheambienttemperature

presentissuitablefortheunitbeinginstalled.

3. IftheWARRIORunitistobeinstalledinareasofhighvibration,pleaseconsultRaytec.

4. The WARRIOR unit housing is constructed from marine grade aluminium and

polycarbonate. The end user must ensure that these materials are suitable for the

atmospheretheWARRIORunitwillbeinstalledin;Zone1andZone2Hazardousareas.

5. The incoming mains cable should not exceed a temperature rise of 61˚C above

theambientconditions;selectsuitablecableandcablegland.You must use ATEX

approvedcableandglandse.g.M25,foradviceonsuitableglandsandcablesplease

contactRaytec

Specicationssubjecttochangewithoutnotice.

Installationtobecarriedoutbysuitabletrainedandqualiedpersonnel.

Isolatemainsbefore

removing cover

Installinawell

ventilated area

Donotcontinually

stare at lamp

1.5m

2. Installation

Mount WARRIOR Unit

1. TomeettherequirementsofcerticationaMINIMUMof2xingpointsmustbeused,

thexing/xingpointsmustbesuitablefortheconditionsofuse.

2. Theunitmayhavebeensuppliedwithanintegratedphotocell.Careshouldbetaken

whenpositioningtheunittoensurethesensorisnotshielded,isnotpointingdirectly

atanotherlightsourceandismonitoringthegeneral,prevailinglightconditions.

3. TheWARRIORilluminatorandthe mounting bracket is suppliedtogetheras a unit.

Theboltsinthesideofthehousingshallberemovedandusedtosecurethebracketto

theWARRIORhousing.Itisveryimportantthattheredbrewashersarettedbetween

theWARRIORhousingandthemountingbracket.Theunitmustbealignedrstbefore

securingthebracket.Theunitcanbemountedhorizontallyorverticallyallowingthe

unittopointup/downorleft/right.

267

R30

120

R15

5 x

HOLES 9

100

281

250

245

202

2 x M20 ENTRIES

COMPLETE WITH

IEC Ex APPROVED

STOPPER PLUGS

EXTERNAL

EARTH/GROUND

POINT

135

Power Connections

1 2 3 4 5 6 7 8 9 10 11 12

Terminal Loop

(colour may vary)

MAINS

INPUT

MAINS

LOOPING

OUTPUT

(OPTIONAL)

LAMPS (LED)

OUTPUTS

(OPTIONAL)

PHOTOCELL

INPUT

(OPTIONAL)

Terminal Pins

Wiring Label

Terminal

Cable Crimp

(colour may vary)

Terminal

Block

Weidmüller

WHITEWHITE

BLACKBLACK

BLACK

RED

BLUE

BROWN

GREEN/YELLOW

Photocell Black

(-ve)

Red

(+ve) N L E

WiretheMainscableintotheterminalblock.Provisionhasbeenmadeforthisandidentied

astheE(Earth/Ground),L(Live)andN(Neutral)terminals.Therearetwopairsofcontacts

foreachofthesetofacilitateamainscablethatcanbeloopedinandoutoftheunit.

4. Installershouldearth/groundtheunitseparately.

5. Connectwirestomainssupply;

Blue=Neutral

 Brown=Live

 Green/Yellow=Earth/Ground

6. Iftheunitisopenedforanyreason,disconnectmains.

For 24V version only – Must not be used on a Centre Tapped Earth Transformer

power supply

Additional important information

Note: Torque = Newton Metre (Nm)

7. All WARRIOR units have terminal blocks suitable for 4mm2 live, neutral and earth/

ground.

8. Wheninstallingtheunitthespecialconditionsforsafeuseshouldbeadheredto–

i. Exceptforinternalwiring,notmorethanonesingleormultiplestrandleadshallbe

connected into either side of any terminal, unless multiple conductors have been

joinedinasuitablemanner,e.g.twoconductorsintoasingleinsulatedcrimpedboot

lace ferrule.

ii. Leadsconnectedtotheterminalsshallbeinsulatedfortheappropriatevoltageand

thisinsulationshallextendtowithin1mmofthemetaloftheterminalthroat.

iii. Allterminalscrews,usedandunused,ontheWARRIORterminalblock(typeBkIECEx

SIR05.0035Uterminalblock)shallbetighteneddowntobetween0.5Nmand0.7Nm.

iv. The WARRIOR terminal hey shall only be installed and wired with cable within a

temperature range of -10°C to 80°C.

v. Whencross-connectingcombsareusedontheterminalstherelevantconditionsof

certicationIECExSIR05.0035UandIECExSIR05.0037Ushallbeapplied.

vi. Cableentryholesshallbettedwitheitheranappropriatelycertiedcableglandor

appropriatelycertiedblankingelement.Theseshallprovideandmaintainaminimum

enclosureingressprotectionofIP66orIP67asappropriate.

vii. IntheunlikelyeventofthefailureofanLED,theassemblymustbereplaced;contact

Raytecforassistance.

4. Technical Speciﬁcation

Input Voltage 100-254VAC

 24VAC/DCversionavailable

Consumption 60Wmax

Power Factor >0.95

Mains Frequency 50/60Hz

IP Rating 66/67

Weight 6kg

Dimensions 250x165x145mm

ATEX and IECEx Zone1&Zone2:

Rating II2GDExembII

Protection / Certiﬁcation

IECEx Cert.

ExembIICT4Gb

ExtIIICT103°C

DbIP66/67

Tamb-20°Cto+50°C

ATEX Cert.

II2GD

ExembIICT4Gb

ExtIIICT103°C

DbIP66/67

Ta=-20°Cto+50°C

WARRIOR Speciﬁcation

3. Maintenance

1. IsolatetheWARRIORunitfromthemainssupplyandallowtocoolbeforecarryingout

anymaintenancework.

2. IntheunlikelyeventofthefailureofanLED,theassemblymustbereplaced;contact

Raytecforassistance.

3. ItisessentialthatallWARRIORunitsaremaintainedinaccordancewiththerequirements

of the EN60079-17standard: (Electrical apparatus for explosive gas atmospheres –

otherthanmines).

4. IMPORTANT. No modications are permitted to the unit, all spare parts must be

purchased from the manufacturer, unauthorized modications or spare parts will

invalidate certiﬁcation.

5. ELECTROSTATIC CHARGING HAZARD-Plasticcomponentsmaybecleanedwith

watercontainingasmallamountofdetergent,followedbyacleanwaterwash.Surplus

watercanbewipedoffplasticcomponents,buttheyshouldnotbewipedorpolished

withadryclothtoavoidabuild-upofstaticelectricity.

6. Disposalofpackaging,WARRIORunitandoldLEDassembliesshouldbecarriedout

inaccordancewithnationalregulations.

PART CODES & DISTANCES

RLW-200-10 RAYLUXWarrior,10° White-Light 120m(394ft)

RLW-200-30 RAYLUXWarrior,30° White-Light 65m(213ft)

RLW-200-50 RAYLUXWarrior,50° White-Light 45m(184ft)

5.Troubleshooting

1. EnsurethetwoLEDboardsarecorrectlywiredtoterminalblock.

Red to Red : Black to Black

2. EnsureMainsinputiscorrectlyconnected.

Earth/Ground to Yellow/Green : Live to Brown : Neutral to Blue

3. EnsureMainsInputisturnedonatthesource

PART CODES & DISTANCES

RMW2-200-10 RAYMAXWarrior,10° 850nm 150m(492ft)

RMW2-200-30 RAYMAXWarrior,30° 850nm 80m(262ft)

RMW2-200-50 RAYMAXWarrior,50° 850nm 56m(184ft)

RAYMAX WARRIOR: Infra-Red

RAYLUX WARRIOR: White-Light

UK / Europe

T: +44 (0) 1670 520055

F: +44 (0) 1670 819760

sales@rayteccctv.com

Americas (Toll Free)

T: +1 888 505 8335

ussales@rayteccctv.com

www.rayteccctv.com

WII/11/10.1

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Raytec Attrezzatura di illuminazione

Raytec

Raytec WARRIOR Manuale utente

Raytec

Raytec SPARTAN Series Manuale utente

Raytec

Raytec VARIO2 w8 Manuale utente

Raytec

Raytec PULSESTAR VTR4 Manuale utente

Raytec

Raytec vario2ip HYBRID Istruzioni per il montaggio

Raytec

Raytec PULSESTAR VTR6 Manuale utente

Raytec

Raytec RL F 25 Manuale utente

Raytec

Raytec PULSESTAR VTR Manuale utente

Raytec

Raytec SPARTAN HP series Manuale utente

Raytec

Raytec VARIO2 VAR2-i2-2 Manuale utente

Raytec

Raytec RAYMAX RM200 Manuale utente

Raytec

Raytec VARIO2 IP 16 Series Manuale utente

Raytec

Raytec SPX SPARTAN Manuale utente

Raytec

Raytec VARIO2 series Manuale

Raytec

Raytec VAR2 IPPOE i4-1 Manuale utente

Raytec

Raytec SPI WARRIOR Series Manuale utente

Raytec

Raytec SPARTAN SPX Series Manuale utente

Raytec

Raytec VARIO2 series Manuale utente

Manuali Attrezzatura di illuminazione popolari di altre marche

Brizo

Brizo 8SP-MU-4 Manuale utente

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuale utente

IKEA

IKEA BJÖRKSPIREA Manuale utente

Laserworld

Laserworld Evolution Series ES-400RGB Manuale utente

Alien

Alien RG STAR Manuale utente

EuroLite

EuroLite LED B-40 Manuale utente

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuale utente

Commercial Electric

Commercial Electric 54568141 Manuale utente

CREE LIGHTING

CREE LIGHTING 304 Series Manuale utente

Goobay

Goobay 49867 Manuale utente

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuale utente

Alkalite

Alkalite Krypton KT-81 Manuale utente

Clas Ohlson

Clas Ohlson GU10 Manuale utente

DTS

DTS DELTA 10 F Manuale utente

ring

ring Solar Steplight Manuale utente

One Stop Gardens

One Stop Gardens 57696 Istruzioni per il montaggio

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuale utente

SIREM

SIREM Swimeo A2 Manuale utente