
As shown in [Picture B], insert a nipple, attached to 0.5m silicone tube,
into the ‘OUT’ part (left-hand side) of the nipple holder.
As shown in [Picture C], insert a nipple, attached to 1m silicone tube,
into the ‘IN’ part (right-hand side) of the nipple holder.
As shown, water flows out of the left silicon tube, and comes into
the right silicon tube.
Assemble the cap onto the pump body.
Please make sure silicone tubes do not get jammed in the cap.
Connect the APS power cable onto the power inlet at the back of the
pump body.
Please refer to booklet manual page 16 for how to assemble the APS
with the incubator.
Turning direction
of the motor
This part will be
factory pre-assembled.
7cm +0.2/-0
A
Direction of the
water in-flow
(assemble with the
water container)
Direction of the
water out-flow
(assemble with
the incubator)
* Complaint Department : 82-55-337-2561
Attach the cut parts of the silicone tube onto the nipples on either side
of the APS unit.
Please note that pumping performance
will be reduced if the silicone tube
isn’t fitted tightly onto the nipple,
or if the tube length is different from
[Picture A].
B
Cross
Section
0.5m
Assemble
‘OUT’ part
1m
Assemble
‘IN’ part