RDL DRA-35R Manuale utente
ACCESSORIES
Model DRA-35R
RACK-UP DIN Rail Adapter
The DRA-35R provides DIN rail mounting for any RDL RACK-UP® module, allowing full access to the front and
rear panels of the mounted modules. The DRA-35R attaches to a 35 mm DIN Rail.
Front Rear
With Product Installed
(Available Separately)
RDL •659 6th St. •Prescott, AZ., USA 86301 •(928) 443-9391 •FAX (928) 443-9392 •www.rdlnet.com
STEP #1
Attach the DRA-35R to the DIN rail with the included
screws.
ACCESSORIES
Model DRA-35R
RACK-UP DIN Rail Adapter
891-5174A
STEP #2
Start the screws into the bottom of the RACK-UP but do not
install them all the way.
STEP #3
Secure the RACK-UP to the DRA-35R chassis by sliding the
unit rearward so that the screws seat into the mounting
holes and tighten the screws.
If desired use the rectangular cut outs in the chassis to secure
wiring with hook and loop fastener or wire-ties. The smaller
holes can be used for ground wire attachment.
(Bottom View)
Radio Design Labs Technical Support Centers
U.S.A. (800) 933-1780, (928) 778-3554; Fax: (928) 778-3506
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
NOTE: When installing a RACK UP product that is in a
plastic box start by removing the screws from the back
of the RACK UP. Bend the tabs on the mounting unit up
at a 90° angle. Secure the unit to the mounting chassis
using the screws.
Installation/Operation
Declaration of Conformity available from rdlnet.com.
Sole EMC specications provided on product package.
Specications are subject to change without notice.
Altri manuali RDL Rack e supporto
