Recoil SL1779 Manuale utente

SL1779

Underseat Active Slim 7" X 9" Subwoofer

with Passive Radiators

User Manual

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

Introduction

WARNING

Please read this OWNER'S MANUAL thoroughly to familiarize yourself with each

control and function. We hope that your new underseat active subwoofer

SL1779 will give you many years of listening enjoyment. In case of problems

when installing your subwoofer, please contact support@recoilaudio.com.

• DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY FROM

SAFELY DRIVING YOUR VEHICLE. Any function that requires your prolonged

attention should only be performed after coming to a complete stop. Always

stop the vehicle in a safe location before performing these functions. Failure to

do so may result in an accident.

• KEEP THE VOLUME AT A LEVEL WHERE YOU CAN STILL HEAR OUTSIDE NOISES

WHILE DRIVING. Excessive volume levels that obscure sounds such as emergen-

cy vehicle sirens or road warning signals (train crossings, etc.) can be danger-

ous and may result in an accident. LISTENING AT LOUD VOLUME LEVELS IN A

CAR MAY ALSO CAUSE HEARING DAMAGE.

• DO NOT DISASSEMBLE. Doing so may result in an accident, fire or electric

shock.

• USE THIS PRODUCT FOR MOBILE 12V APPLICATIONS. Use for other than its

designed application may result in fire, electric shock or other injury.

• USE THE CORRECT AMPERE RATING WHEN REPLACING FUSES. Failure to do so

may result in fire or electric shock.

• DO NOT BLOCK VENTS OR RADIATOR PANELS. Doing so may cause heat to

build up inside and may result in fire.

• MAKE THE CORRECT CONNECTIONS. Failure to make the proper connections

may result in fire or product damage.

• USE ONLY IN VEHICLES WITH A 12 VOLT NEGATIVE GROUND. Failure to do SO

may result in fire, etc.

This symbol means important instructions.

Failure to heed them can result in serious injury or death.

CAUTION

This symbol means important instructions.

Failure to heed them can result in injury or property damages.

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

CAUTION

• HALT USE IMMEDIATELY IF A PROBLEM APPEARS. Failure to do so may cause

personal injury or damage to the product. Return it to our Service Center for

repairing.

• HAVE THE WIRING AND INSTALLATION DONE BY EXPERTS. The wiring and instal-

lation of this unit requires special technical skill and experience. To ensure

safety, always contact the dealer where you purchased this product to have

the work done.

• USE SPECIFIED ACCESSORY PARTS AND INSTALL THEM SECURELY. Be sure to use

only the specified accessory parts. Use of other than designated parts may

damage this unit internally or may not securely install the unit in place. This may

cause parts to become loose resulting in hazards or product failure.

• ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED BY A SHARP METAL

EDGE. Route the cables and wiring away from moving parts (like the seat rails)

or sharp or pointed edges. This will prevent crimping and damage to the wiring.

If wiring passes through a hole in metal, use a rubber grommet to prevent

the wire's insulation from being cut by the metal edge of the hole.

• BEFORE WIRING, DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMI-

NAL. Failure to do so may result in electric shock or injury due to electrical

shorts.

• DO NOT ALLOW CABLES TO BECOME ENTANGLED IN SURROUNDING OBJECTS.

Arrange wiring and cables in compliance with the manual to prevent obstruc-

tions when driving. Cables or wiring that obstruct or hang up on places such as

the steering wheel, gear lever, brake pedals, etc. can be extremely hazardous.

• DO NOT SPLICE INTO ELECTRICAL CABLES. Never cut away cable insulation to

supply power to other equipment. Doing so will exceed the current carrying

capacity of the wire and result in fire or electric shock.

• DO NOT DAMAGE PIPE OR WIRING WHEN DRILLING HOLES. When drilling holes

in the chassis for installation, take precautions so as not to contact, damage or

obstruct pipes, fuel lines, tanks or electrical wiring. Failure to take such precau-

tions may result in fire.

•DO NOT USE BOLTS OR NUTS IN THE BRAKE OR STEERING SYSTEMS TO MAKE

GROUND CONNECTIONS. Bolts or nuts used for the brake or steering systems (or

any other safety-related system), or tanks should NEVER be used for installations

or ground connections. Using such parts could disable control of the vehicle

and cause fire etc.

• KEEP SMALL OBJECTS SUCH AS BOLTS OR SCREWS OUT OF THE REACH OF

CHILDREN. Swallowing them may result in serious injury. If swallowed, consult a

physician immediately.

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

SPECIFICATIONS

Sound

Power Output (RMS)

Frequency Response

Woofer

Diaphragm Size (Nominal)

Passive Radiators

Diaphragm Material

Surround

Amplifier

Power Output (RMS)

Low Pass Crossover

Accessories

Bass Remote Knob

Wire Harness

230 watts

34~ 400Hz

7" X 9"

4" X 6"

Polypropylene

Rubber

230 watts

30~150Hz

0.1-5.0V (RCA Input)

0.5-10.0V (Speaker Level Input)

Cable length: 5M

OFC 17' Power/2' Ground/8' Spaker Level Input/2' Remote Turn on

SERVICE CARE

• DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST. Avoid installing

the unit in locations with high incidence of moisture or dust. Moisture or dust

that penetrates into this unit may result in product failure.

• IMPORTANT NOTICE

This Subwoofer has been tested to comply with the limits for a Class B comput-

ing device in accordance with the specifications of Part 15 of FCC Rules. This

equipment generates and uses radio frequency energy, and it must be

installed and used properly in accordance with the manufacturer's instructions.

• For Customers in other Countries IMPORTANT NOTICE

Customers who purchase the product with which this notice is packaged, and

who make this purchase in other countries , please contact your dealer for

information regarding warranty coverage.

SERIAL NUMBER:

INSTALLATION DATE:

INSTALLATION TECHNICIAN:

PLACE OF PURCHASE:

• IMPORTANT

Please record the serial number of your unit in the space provided here and

keep it as a permanent record. The serial number plate is located on the rear

of the unit.

Input Sensitivity

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

INSTALLATION ( Fig.1) & ( Fig.2)

CAUTION

• Caution on connection terminals/parts

Keep electrically conductive objects away from the unit's terminals/parts

(power terminals, fuses, speaker input terminals, RCA connectors, etc.). Doing

so prevents a possible short circuit and damage to the unit.

MOUNTING

1. Attach the included mounting brackets to the SL1779 with the supplied

screws. (See to Fig. 1)

2. Once the brackets are mounted to the SL1779. Place the subwoofer in the

desired location within the vehicle. Before securing with screws, check to make

sure all screws can affix to a structurally solid surface while avoiding vehicle

wiring, components, etc. (See Fig. 2)

Note: For securing the mounting brackets to the vehicle, it may be necessary to

use longer screws (not included) to accommodate carpet thickness, etc.

NOTE:

To securely connect the ground lead, use an already installed screw on the

metal part of the vehicle (marked this is a good ground by checking continuity

to the battery (-) terminal. As much as possible connect all equipment same

ground point. These procedures will help eliminate noise.

ACCESSORIES

• Fuse(30A) ......................................................................................................

• Insert power cable ......................................................................................

• Remote control ............................................................................................

• Bracket ..........................................................................................................

• Screws ...........................................................................................................

• Brackets screws.............................................................................................

NOTE :

• For product improvement, specifications and design are subject to change

without notice.

CONNECTIONS (Fig.3)

Before making connections, be sure to turn the power off to all audio compo-

nents. Connect the red battery lead from the amp directly to the positive (+)

terminal of the vehicle's battery. Do not connect this lead to the fuse block.

To prevent external noise from entering the audio system.

• Locate the unit and route the leads at least 10 cm (3- 15/16") away from the

car harness.

• Keep the battery power leads as far away from other leads as possible.

• Connect the ground lead securely to a bare metal spot (remove any paint or

grease if necessary) of the car chassis.

• Your dealer knows best about noise prevention measures so consult your

dealer for further information.

1. Input/Power Connector

2. RCA Input Jacks

Connect these jacks to the line out leads on your headunit using RCA extension

cables (sold separately).

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

Mounting Bracket

Bracket Screws,

Remote Bass Level Knob

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

RCA Input System

Head Unit, etc (sold separately)

RCA Extension Cable (sold separately)

Note:

Power Mode

button must

be set to REM

(Button Out)

Front Left Speaker (White+)

Front Left Speaker (White/Black-)

Ground Lead (Black)

Front Right Speaker (Gray+)

Front Right Speaker (Gray/Black-)

Remote Turn-On Lead (Blue/White)

Battery Lead (Red)

FUSE 20A

Fig.3

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

3. Fuse (30A)

USE ONLY THE CORRECT AMPERE RATING WHEN REPLACING FUSES.

Failure to do so may result in fire or electric shock.

4. Input/Power Wire Harness

5. Speaker Input Leads

These leads are input leads for use with head units not equipped with preamp

outputs. When not using the RCA Line Input connectors, you should connect

these wires to the speaker output leads of your head unit. The accepts input

from high power or standard power head units.

Note:

• Do not connect speaker leads together or to chassis ground.

• Use either RCA line level or speaker level inputs. Do not connect both at the

same time.

6. Battery Lead (Red)

Connect battery lead directly to BATT + Be sure to add a 30A fuse as close as

possible to the battery's (+) terminal.

7. Remote Turn-On Lead (Blue/White)

Connect this lead to the remote turn-on (positive trigger, (+) 12V only) lead of

your head unit.

Note:

If using speaker input level signal from the head unit, remote turn-on lead

connection is not necessary.

8. Ground Lead (Black)

Connect this lead securely to a clean, bare metal spot on the vehicle's chassis.

Verify this point to be a true ground by checking for continuity between that

point and the negative (-) terminal of the vehicle's battery. Ground all your

audio components to the same point on the chassis to prevent ground loops.

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

Front Left Speaker (White+)

Front Left Speaker (White/Black-)

Ground Lead (Black)

Front Right Speaker (Gray+)

Front Right Speaker (Gray/Black-)

Remote Turn-On Lead (Blue/White)

Battery Lead (Red)

FUSE 30A

Note: Connect to

each speaker

lead (splice) without

breaking the

connection between

the headunit and

the speaker.

Note: Connect toeach speaker

lead (splice) without breaking the

connection between the

headunit andthe speaker.

Right SpeakerLeft Speaker

Speaker level input system

Fig.3

UNDERSEAT ACTIVE SLIM SUBWOOFER SL1779

SWITCH SETTINGS (Fig. 4)

9. Phase switch 0oto 180o

Subwoofer output phase can be set to Subwoofer Normal 0o(Button Out) or

Subwoofer Reverse 180o(Button In).

10. Crossover Frequency Adjustment Knob (LP FILTER)

Use this control to adjust the crossover frequency between 50 to 150Hz.

11. Input Gain Adjustment Control

Note: If the Remote Bass Level Knob will be connected in your system, make

sure to rotate the knob fully clockwise (set to +") before making the input gain

adjustment.

Set the SL1779 input gain to the minimum position. Using a dynamic CD as a

source, increase the head unit volume until the output distorts. Then, reduce

the volume 1 step (or until the output is no longer distorted). Now, increase the

amplifier gain until the sound from the speakers becomes distorted. Reduce the

gain slightly so the sound is no longer distorted to achieve the optimum gain

setting.

12. Power Indicator

13. Remote Adjustment Knob

Turning the remote bass level knob towards (+) increases the overall subwoofer

level, while turning the bass level knob towards (-) decreases the overall

subwoofer level.

(Note: can be used without connecting the remote bass level knob. However,

overall subwoofer level cannot be adjusted from the listening position.)

Indication Color

Blue

None (LED is off)

Amplifier circuit is normal

Amplifier circuit is abnormal.

An electrical short has occurred,

or supply current is too high.

30A fuse may be blown.

Power supply voltage is too high.

Turn off the power supply and eliminate

the cause (replacethe 30A if necessary).

Then turn on the unit and verify that the

LED has turned on. If it remains off, turn

off the unit and consult your dealer.

Use the correct power supply voltage.

Status Solution

Indice

Altri manuali Recoil Subwoofer

Recoil

Recoil SWS10 Manuale utente

Manuali Subwoofer popolari di altre marche

Sony

Sony XS-AW8 Manuale utente

Sony

Sony XS-L836 Manuale utente

B&C Speakers

B&C Speakers 15 HPL 76W Manuale utente

Velodyne

Velodyne DD-18+ Manuale utente

Sonance

Sonance Cinema Series SUB 10-150 Manuale utente

Hifonics

Hifonics HW-12 Guida rapida

Magnat Audio

Magnat Audio ADR 130 BP Manuale utente

Blitz

Blitz BZP106 Manuale utente

Technics

Technics SB-AS500 Manuale utente

Lyngdorf

Lyngdorf BW-2 Manuale utente

Lyngdorf

Lyngdorf BW-3 Manuale utente

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Manuale utente

REL Acoustics

REL Acoustics Q Series Manuale utente

Pioneer

Pioneer Elite S-W1EX Manuale utente

L-Acoustics

L-Acoustics KIVA SB15M Guida rapida

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Manuale utente

KEF

KEF KUBE 200 Manuale utente

Yamaha

Yamaha SW500 Manuale utente