Reechcraft Bronco Manuale di istruzioni

OPERATOR’S SAFETY MANUAL

4023034

™

Bronco by ReechCraft

It is very important that you read, understand and obey the contents of

this manual! Keep it with the all-terrain scaffold at all times.

The purpose of this manual is to provide safe and proper operating procedures for

anyone utilizing the benets of this all-terrain scaffold.

Because we at ReechCraft, Inc. are always working to improve our products,

processes and procedures, we reserve the right to make changes without prior

notice. Please contact us at ReechCraft for updated information.

This is the Safety Alert Symbol. It is used throughout this manual and on the all-terrain

scaffold to alert you to potential personal injury hazards. Understand and obey all safety

messages that correspond with this symbol to avoid possible injury or death.

INDICATES AN IMMINENTLY HAZARDOUS SITUATION AND IF NOT AVOIDED

WILL RESULT IN SERIOUS INJURY OR DEATH. THIS DECAL WILL HAVE A

RED BACKGROUND.

INDICATES A POTENTIALLY HAZARDOUS SITUATION. IF NOT AVOIDED,

COULD RESULT IN SERIOUS INJURY OR DEATH. THIS DECAL WILL HAVE

AN ORANGE BACKGROUND.

INDICATES A POTENTIALLY HAZARDOUS SITUATION THAT IF NOT AVOIDED,

MAY RESULT IN MINOR OR MODERATE INJURY. IT MAY ALSO ALERT AGAINST

UNSAFE PRACTICES. THIS DECAL WILL HAVE A YELLOW BACKGROUND.

SAFETY ALERT SYMBOLS

AND SAFETY SIGNAL WORDS

www.reechcraft.com/bronco

™

www.reechcraft.com/bronco 888-600-6160 3

THIS PRODUCT MUST COMPLY WITH ALL SAFETY RELATED BULLETINS.

CONTACT REECHCRAFT, INC. OR THE LOCAL AUTHORIZED REECHCRAFT

REPRESENTATIVE FOR INFORMATION REGARDING SAFETY RELATED

BULLETINS WHICH MAY HAVE BEEN ISSUED FOR THIS PRODUCT.

REECHCRAFT MUST BE NOTIFIED IMMEDIATELY IN ALL INSTANCES WHERE

OUR PRODUCTS HAVE BEEN INVOLVED IN AN ACCIDENT INVOLVING

BODILY INJURY OR DEATH OF PERSONNEL OR WHERE SUBSTANTIAL

PERSONAL PROPERTY DAMAGE OR DAMAGE TO THE REECHCRAFT

PRODUCT HAS OCCURRED.

FORWARD

FOR:

• Accident Reporting

• Product Safety Publications

• Current Owner Updates

• Product Safety Questions

• Standards and Regulations Compliance Information

• Questions Regarding Special Applications

• Questions Regarding Product Modiﬁcations

CONTACT:

Technical Safety and Engineering Department

845 34th St N

Fargo, ND 58102

Toll Free: 888-600-6160

E-mail: customer[email protected]

Bronco by ReechCraft

REVISION LOG

Original Version of Manual..................................................................May 1, 2019

TABLE OF CONTENTS

SECTION - INFORMATIONAL

FOREWORD ........................................................................................................ 2

SAFETY ALERT SYMBOLS & SAFETY WORDS.............................................. 2-3

CONTACT ........................................................................................................... 3

REVISION LOG.................................................................................................... 4

SECTION - 1 - SAFETY PRECAUTIONS........................................................... 6

1.1 GENERAL .................................................................................................... 6

1.2 PRE-OPERATION ........................................................................................ 6

Operator Preparedness ..................................................................... 6

Work Site Inspection ......................................................................... 7

All-Terrain Scaffold Inspection........................................................... 7

1.3 OPERATION ................................................................................................ 8

General .............................................................................................. 8

Fall Hazards....................................................................................... 8

Tipping Hazards ................................................................................ 8

Electrocution Hazard ......................................................................... 9

SECTION - 2 - PREPARATION & INSPECTION ............................................. 10

2.1 PERSONNEL REQUIREMENTS ................................................................ 10

Operator Requirements................................................................... 10

Operator Responsibilities ................................................................ 10

2.2 PREPARATION, INSPECTION & MAINTENANCE ..................................... 11

Pre-Start Inspection ........................................................................ 11

2.3 DAILY WALK-AROUND INSPECTION....................................................... 12

Walk-Around Inspection Components ............................................ 13

2.4 FUNCTION CHECK ................................................................................... 14

Function Check Items ..................................................................... 14

SECTION - 3 - ALL-TERRAIN SCAFFOLD OPERATION ............................... 15

3.1 GENERAL .................................................................................................. 15

3.2 ALL-TERRAIN SCAFFOLD DESCRIPTION ............................................... 15

3.3 ALL-TERRAIN SCAFFOLD SET-UP........................................................... 16

Getting Started ................................................................................ 16

3.4 WEIGHT DISTRIBUTION ........................................................................... 17

www.reechcraft.com/bronco 888-600-6160 5

3.5 PLATFORM CONFIGURATION.................................................................. 17

SECTION - 4 - EMERGENCY PROCEDURES................................................ 18

4.1 INCIDENT NOTIFICATION......................................................................... 18

SECTION - 5 - GENERAL SPECIFICATIONS ................................................. 19

5.1 INTRODUCTION........................................................................................ 19

5.2 DECAL CONTENTS & LOCATION............................................................. 19

5.3 ALL-TERRAIN SCAFFOLD SPECIFICATIONS .......................................... 20

SECTION - 6 - SERVICE & MAINTENANCE................................................... 22

6.1 MAINTENANCE SAFETY PRECAUTIONS ................................................ 22

General ............................................................................................ 22

Maintenance Safety......................................................................... 23

6.2 PREPARATION, INSPECTION & MAINTENANCE ..................................... 24

General ............................................................................................ 24

Preparation, Inspection & Maintenance .......................................... 24

Pre-Start Inspection ........................................................................ 24

Frequent & Pre-Delivery Inspection................................................. 24

Annual All-Terrain Scaffold Inspection ............................................ 25

6.3 PREVENTIVE MAINTENANCE & INSPECTION SCHEDULE ..................... 25

Inspection & Maintenance Codes ................................................... 25

6.4 SERVICING & MAINTENANCE GUIDELINES............................................ 26

General ............................................................................................ 26

Safety & Workmanship .................................................................... 27

Cleanliness ...................................................................................... 27

6.5 DECAL REPLACEMENT............................................................................ 27

All-Terrain Scaffold Log ................................................................... 28

SECTION - 7 - WARRANTY............................................................................. 30

7.1 NORTH AMERICAN END-USER LIMITED WARRANTIES......................... 30

TABLE OF CONTENTS

Bronco by ReechCraft

This section is the starting point for establishing habitual precautions for safe

operation of the all-terrain scaffold. This manual is your guide in developing a daily

routine that focuses on safety and proper maintenance of the all-terrain scaffold

prior to each use. A maintenance program must be established and conducted by a

qualied person to ensure the all-terrain scaffold is in safe working condition before it

is operated.

Before operating the all-terrain scaffold, the operator shall:

1. Read, understand and obey the operating instructions and safety rules in

this manual.

2. Obey all labels, warnings and instructions located on the all-terrain scaffold.

3. Be sure that all occupants of the all-terrain scaffold wear appropriate

personal protection equipment (PPE) for the conditions.

If there are any questions regarding safety, training, maintenance, inspection,

application or operation of the all-terrain scaffold, please contact ReechCraft.

FAILURE TO COMPLY WITH THE SAFETY PRECAUTIONS LISTED IN THIS

MANUAL COULD RESULT IN ALL-TERRAIN SCAFFOLD DAMAGE, PROPERTY

DAMAGE, PERSONAL INJURY OR DEATH.

1.1 General

SECTION 1

SAFETY PRECAUTIONS

Operator Preparedness

• Do not operate this all-terrain scaffold until the operator has read and fully

comprehends the Operator’s Safety Manual of the all-terrain scaffold.

• Only competent personnel may operate the all-terrain scaffold.

• Read, fully comprehend and obey all DANGERS, WARNINGS, CAUTIONS

and operating instructions on the all-terrain scaffold and in this manual.

• Only use this all-terrain scaffold in a manner which is within the scope of the

intended application set by ReechCraft.

1.2 Pre-Operation

Figure 1-1 Read your manual

www.reechcraft.com/bronco 888-600-6160 7

• All operating personnel must read, comprehend and obey all applicable

employer, local and governmental regulations as they pertain to the safe

operation of the all-terrain scaffold.

Work Site Inspection

• The operator is to take measures to identify and avoid all hazards in

the work area that will affect the safe operation of the all-terrain scaffold.

All-Terrain Scaffold Inspection

• Before all-terrain scaffold operation, perform walk around inspections and

function checks. Refer to Section 2 of this manual for further instructions.

• No one shall operate the all-terrain scaffold until it has been inspected,

serviced and maintained according to the requirements in this manual.

MODIFICATION OR ALTERATION OF ALL-TERRAIN SCAFFOLD SHALL BE

MADE ONLY WITH PRIOR WRITTEN PERMISSION FROM THE MANUFACTURER

• Do not operate any all-terrain scaffold on which the safety decals or

instruction placards are missing or illegible.

• Avoid any build up of debris on platform oor. Keep mud, oil, grease and

other slippery substances from footwear and the platform oor.

SECTION

SAFETY PRECAUTIONS

Bronco by ReechCraft

1.3 Operation

SECTION

1SAFETY PRECAUTIONS

General

• Do not use the all-terrain scaffold for any purpose other than positioning

personnel, their tools, equipment and materials.

• Never operate an all-terrain scaffold that is not working properly. If a

malfunction occurs, contact ReechCraft.

• Unless in an emergency, do not allow personnel to tamper with the

all-terrain scaffold from the ground with personnel on the platform.

• The operator shall not mount the platform unless the bearing surface is

stationary and capable of supporting the intended load.

Fall Hazards

• Before operating the all-terrain scaffold, make sure the back leg is in the

proper position. Be sure the platform is properly placed on the all-terrain

scaffold unit before mounting.

• Keep both feet rmly positioned on the platform at all times. Never use

ladders, boxes, steps, planks or any other item on the platform to provide

additional height for greater reach.

• Always use extreme caution when mounting or dismounting the platform.

• Always maintain three points of contact with the all-terrain scaffold. “3 point

contact” means using two hands and one foot or two feet and one hand at

all times while mounting or dismounting the platform.

Tipping Hazards

• Be sure the bearing surface is solid, stationary and capable of supporting

the intended load.

• Before mounting the platform, ensure that all locking pins are fully engaged.

• Check the back leg label to be sure the horizontal line is parallel to the

ground and the vertical line is plumb.

www.reechcraft.com/bronco 888-600-6160 9

SECTION

SAFETY PRECAUTIONS

• Before using the all-terrain scaffold on oors and other surfaces, check

allowable capacity of the surfaces.

• Never exceed the maximum platform capacity. Distribute loads evenly on

platform.

Electrocution Hazard

• This all-terrain scaffold is not insulated and will not provide protection from

contact or proximity to electrical current.

• Maintain distance from electrical lines, apparatus or any energized (exposed

or insulated) parts according to the Minimum Approach Distance (MAD) as

shown in Table 1-1.

• Maintain a clearance of at least 10 ft (3 m) between any part of the all-terrain

scaffold and its occupants, their tools and their equipment from any electrical

line or apparatus carrying up to 50,000 volts. 1 ft (.3 m) additional clearance is

required for every additional 30,000 volts or less.

• The minimum safe approach distance may be reduced if insulating barriers

are installed to prevent contact, and if the barriers are rated for the voltage

of the line being guarded. These barriers shall not be part of (or attached

to) the all-terrain scaffold. The minimum safe approach distance shall

be reduced to a distance within the designed working dimensions of the

insulating barrier. This determination shall be made by a qualied person

in accordance with employer, local or governmental requirements for work

practices near energized equipment.

Table 1-1 Minimum Approach Distances (M.A.D.)

VOLTAGE RANGE

(PHASE TO PHASE)

MINIMUM SAFE APPROACH

DISTANCE - FEET (METERS)

0-50KV 10 (3)

Over 50KV to 200KV 15 (5)

Over 200KV to 350KV 20 (6)

Over 350KV to 500KV 25 (8)

Over 500KV to 750KV 35 (11)

Over 750KV to 1000KV 45 (14)

NOTE: This requirement shall apply except where employer, local or governmental regulations are more

stringent.

Bronco by ReechCraft

2.1 Personnel Requirements

SECTION 2

PREPARATION & INSPECTION

This all-terrain scaffold is intended to be used as a personnel handling device and

must be operated and maintained by competent personnel only.

Anyone under the inuence of drugs, alcohol or are subjected to bouts of dizziness,

seizures or loss of physical control must not operate this all-terrain scaffold.

Operator Requirements

Before operating this all-terrain scaffold, the operator must read and comprehend

this manual.

The operator must be familiar with:

1. Use and limitations of the components of the all-terrain scaffold including

the specication requirements.

2. Instruction and warning decals on the all-terrain scaffold and in this manual.

3. Employer and government regulations.

4. Use of approved fall protection device (where applicable).

5. Sufcient mechanical aptitude and knowledge of the all-terrain scaffold to

recognize a component malfunction or a potential malfunction.

6. The safest means to operate the all-terrain scaffold where overhead and

ground hazards are present. These hazards include: overhead obstructions,

additional moving equipment, obstacles, depressions, drop-offs, etc.

7. A means to avoid unprotected electrical conductors.

8. The specic job requirements.

Operator Responsibilities

The exercise of good judgment, safety control, and caution in evaluating each

situation is the responsibility of the Operator. The Operator must stop using the

all-terrain scaffold in the event of a malfunction or other unsafe condition of the

all-terrain scaffold or job site.

Altri manuali per Bronco

Indice

Altri manuali Reechcraft Scala

Reechcraft

Reechcraft Bronco Manuale utente

Manuali Scala popolari di altre marche

ADVANCED SIMRACING

ADVANCED SIMRACING ASR6 Manuale utente

Batavia

Batavia GIRAFFE AIR Manuale utente

Millennium

Millennium L-220-SL Manuale utente

Louisville

Louisville AA2210 Manuale utente

wibe

wibe TMR Guida utente

BESSLER

BESSLER 20 Manuale utente

Branach

Branach TerrainMaster Manuale utente

TUBESCA-COMABI

TUBESCA-COMABI 02271 105 à 115 Manuale utente

KTL

KTL 24392909 Manuale

Penguin

Penguin ICE LADDER Manuale utente

KRAUSE

KRAUSE 1103 Series Manuale utente

Tractel

Tractel skysafe Istruzioni utente

AFIX

AFIX FAST FIX Manuale utente

Wenger

Wenger Fixed Height Stairway 2-Step Manuale utente

KRAUSE

KRAUSE 1212 Manuale utente

fakro

fakro LWS-P 22/47 Manuale utente

FACAL

FACAL Euro Stilo Manuale

SHEDorize

SHEDorize Stepladder/Rake/Cord Rack Manuale utente