Regent Control Systems FRT 7721 Manuale utente
2
3
4
N0
NC
C
RELAY 1
FRT 7442
R
REGENT CONTROL SYSTEMS (I) PVT Ltd
R1
Technical Specification
FRT 7442
TIMER/COUNTER
REGENT CONTROL SYSTEMS
Page - 1
MADE IN INDIA
OPERATING MANUAL
UTR 7442
Helpline : +91 9624004123
0 1 2 3
0 1 2 3
N0
NC
C
L
N
1
5
6
7
8
9
10
11
12
13
14
RELAY 2
CONNECTION
CARE
R
REGENT CONTROL SYSTEMS (I) PVT LTD
MADE IN INDIA
SET
TIME
Notes:
1). For safely purpose, key function are designed in such a way that operator will not go into
detailed parameter setting (Previously Set) function. In this situation, in LOCK parameter,
YES has to be selected. If previously set parameters are to be changed, then any operator
has to select NO.
2). POWER ON () : Timer starts counting as soon as it gets start pulse.
3). By default Cycle ON Mode is provided.
.
R2
FRT 7721
UPPER:- 4 Digit 7 seg 0.56” ,red LED Display
LOWER :- 4 Digit 7 Seg 0.4”, Green Diplay
72 x 72 x 85 mm
68 x 68 mm
Micro switch Input
2 Relay, 1 C/O contact,230V AC, 5A, 12V DC Buzzer
100V to 250V AC, 50 / 60Hz, Approx 4VA
IP - 65 ( Front side) As per IS/IEC 60529:2001
Micro Switch
I/P
BUZZER
+
_
Page - 2
MADE IN INDIA
Helpline : +91 9624004123
Parameter MODE
press key
o n u s
- - -
press key
f r d
9 9 9 9
r e v
9 9 9 9
press key to
set Password
h o l d
9 9 9 9
press key
press key to
Working
1), Turn ON instrument. SET time according to your requirement.
2). In running mode, upper display indicates current TIME value and lower display shows SET
time value. Relay ON controls depends on set time.
3). Relay operation is according to ON delay mode.
4) To start the timer press start pulse Key. forward time and reverse time run after hold time according
to set by user. After reaching the total time the buzzer will on.
MODEL A
72mm 72mm 44mm 66mm 3mm 85mm
BC
D E
F
DIMENSIONS
Mechanical Installation
1) Prepare the panel cutout with proper dimensions as show above.
2) Fit the unit into the panel with the help of clamp given.
3) The equipment in its installed state must not come in close proximity to any heating source,
caustic vapors, oils steam, or other unwanted process by products.
4) Use the specified size of crimp terminal (M3.5 screws) to wire the terminal block. Tightening the
screws on the terminal block using the tightening torque of the range of 1.2 N.m.
5) Do not connect anything to unused terminals.
F
E
C
D
B
A
REGENT CONTROL SYSTEMS (I) Pvt Ltd
R2
TIME
SET TIME
press key to
set Reverse time, range :- 0 -9999 sec.
t o t i
9 9 9 9
press key
press key to set total time
range :- 0 -9999 min.
press key to save and Exit
press key to
set HOLD time, range :- 0 -9999 sec.
Indice
Altri manuali Regent Control Systems Banco cassa
