This section provides information regarding communication interfaces
supported by this product.
USB Slave Port:
1. USB Slave, compliant with USB 2.0 specification, self-powered device.
2. Connector used: Micro USB Type B Female connector.
USB Host Port:
1. USB Host, compliant with USB 2.0 specification
2. USB Host can be used to transfer logged data and historical alarm to
USB memory stick.
3. USB Host can handle only USB memory stick devices and can source
current up to 150mA only.
Connector used: Standard USB Type a Female connector.
COM1/COM2: RS232/ RS5485
DB9 Female (COM2)
Ethernet Port
1. Fully compliant with IEEE 802.3 / 802.3u standards.
2. 10/100 Mbps support.
3. Connector used: Standard shielded RJ-45 female jack with in-built
speed and link activity indication LEDs.
Cable Diagrams:
PC to unit programming cable: RS232 Pinout
WARNING:
-> This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D
or non- hazardous locations only.
-> WARNING –EXPLOSION HAZARD –Do not disconnect equipment unless
power has been removed or the area is known to be non-hazardous.
-> WARNING –EXPLOSION HAZARD - Substitution of components may impair
suitability for Class I, Division 2.
-> WARNING - CAUTION, Battery May Explode If Mistreated. Do Not Recharge,
Disassemble or Dispose of in Fire.
-> The list of materials used in the construction of these devices with name of
sealed device - generic name of the material and the supplier's name and type
designation.
-> It is recommended that the user periodically inspect the sealed devices
used, for any degradation of properties and Replace the device if any
degradation is found.
Renu Electronics Pvt. Ltd® reserves the right to change or discontinue
specifications and features without prior notice.
CONTROL DRAWING NO# CNTL/DWG/FP4043/0318 VER.NO.:1.00
2 Wire RS485 connections:
4 Wire RS485 connections:
Earthing
The optimum method for Earthing electronic equipment is to earth
it separately from other high-power systems, to earth more than one
unit of electronic equipment with a single-point earth. The Earthing
marked terminal (see below) is provided on the unit.
[Note: Do not use an earth that has an unstable impedance, such as
painted screws or earth subject to vibration.]
16 Digital Inputs, 16 Digital Outputs (14
PNP, 2 outputs can be configured for PWM)
16 Digital Inputs, 14 Digital Outputs (12
Relay, 2 outputs can be configured for
PWM)
12 Digital Inputs, 12 Digital Outputs (10
PNP, 2 outputs can be configured for
PWM),
12 Digital Inputs, 12 Digital Outputs (10
Relay, 2 outputs can be configured for
PWM), 2 Analog Inputs (Voltage / Current)
12 Digital Inputs, 10 Digital Outputs (8 PNP,
2 outputs can be configured for PWM),
2 Analog Inputs (Voltage / Current), 1
Analog Output (Voltage / Current)
12 Digital Inputs, 10 Digital Outputs (8
Relay, 2 outputs can be configured for
PWM), 2 Analog Inputs (Voltage / Current),
1 Analog Output (Voltage / Current)
8 Digital Inputs, 8 Digital Outputs (6 PNP, 2
outputs can be configured for PWM),
4 Analog Inputs (Universal), 1 Analog
Output (Voltage / Current)
8 Digital Inputs, 8 Digital Outputs (6 Relay,
2 outputs can be configured for PWM),
4 Analog Inputs (Universal), 1 Analog
Output (Voltage / Current)
