Respirex MFC 180042 Manuale utente
Product Manual
MFC Inator/Deator
2© MFC International
Technical Data
Safety Instructions
Instructions for Use
Repairs
3
4
5
6
WARNING: Carefully read this manual before operating the
MFC Inator/Deator.
NOTICE: The manufacturer takes no responsibility for the
consequences of actions not complying with the instructions
given in this manual.
Index
3
© MFC International
Technical Data
Technical Data 110V 240V
Product Code 180042 180041
Construction All Steel All Steel
Motor 8.0 Peak HP (Two Motors) 8.0 Peak HP (Two Motors)
Airow 58,000 ft/min 58,000 ft/min
Fan 2 Stage Dual Fan 2 Stage Dual Fan
Voltage 120V CE Approved 240V CE Approved
Watts 2160 Watts 2160 Watts
Current Draw 18 Amps 9 Amps
Hose 1.5/5ft x 1.5” Heavy Duty Hose 1.5/5ft x 1.5” Heavy Duty Hose
Nozzle Nozzle and Bayonet Connector Nozzle and Bayonet Connector
Cable 3.6m/12ft Heavy Duty 3.6m/12ft Heavy Duty
Plug 16A 110V 4h OP44 Plug 13 Amp UK or 2 Pin European
Filter Foam Filter Washable Foam Filter Washable
Dimensions 550 x 260 x 165 mm 550 x 260 x 165 mm
Weight 7.65 kg 7.65 kg
Warranty 12 Months 12 Months
The MFC Inator/Deator can be used for rapid ination/deation of our inatable product
range from water rescue products to our larger inatable shelters.
The inator/deator comes tted with a robust outer steel casing, two heavy duty commercial
motors and a twin fan motor assembly which ensures 100% duty cycle for continuous
ination/deation.
WARNING: Carefully read this manual before operating the MFC Inator/Deator.
4© MFC International
Safety Instructions
When using the MFC Inator/Deator, these safety instructions should always be followed:
1. For use on nominal 120/240 volt circuits in the UK & Europe (depending on version
purchased).
2. The Inator/Deator is tted with a 16 amp plug (for 110V version) or 13 amp plug (for
240V version).
3. Always wear eye protection when using your Inator/Deator.
4. DO NOT use without the lter in place - it will void your warranty.
5. Switch o at the switch/s before connecting the plug or unplugging.
6. DO NOT leave the unattended when plugged in. Unplug it when not in use and before
servicing.
7. DO NOT pull or carry by the lead, use the lead as a handle or pull the lead around sharp
edges or corners. Keep exible lead away from heated surfaces.
8. DO NOT unplug by pulling the lead. To unplug, grasp the plug, not the lead.
9. DO NOT handle the plug or appliance with wet hands.
10. Avoid electric shock, do not use on wet surfaces, do not expose to rain, store indoors.
11. DO NOT use with damaged lead or plug. If appliance is not working as it should, has
been dropped, damaged, left outdoors, or dropped into water, return it to an electrical
service shop.
12. DO NOT use with any opening blocked: keep free of dust, leaves & anything that may
reduce air ow.
13. Never point at any part of your body or another person’s body.
14. Store the Inator/Deator inside & keep it out of the reach of children – it is not a toy.
15. Use only as described here. Use only the manufacturer’s attachments.
16. Disassembly voids warranty without prior consent.
5
© MFC International
Instructions for Use
Instructions for Use
1. Lubricate the inside of the hose cu with a moist cloth and then twist the cu over
the inlet /outlet collar and then nip up the clamp by hand.
2. Before connecting the plug to the electricity supply ensure that the toggle switch/s
is/are in the o position.
3. DO NOT LEAVE unattended when turned on - unplug when not in use.
4. DO NOT OVER INFLATE as this could cause an explosion!
5. Disassembly voids warranty without prior consent, with the exception of removal of
the air inlet housing to inspect / clean or replace the lter.
6. Inspect and clean or replace the foam lter to prevent motors overheating.
7. To inspect, clean or replace the lter remove the 4 screws securing the inlet housing.
WARNING: Using the Inator/Deator with a blocked lter will overheat the motor
and void the warranty.
6© MFC International
Repairs
Repairs
As a general rule, repairs/damaged products will need to be assessed in two
categories:
a) that which is repairable at the base, or b) serious damage that will need to be
repaired by MFC International.
If in doubt as to the extent of the damage and the level of repairs necessary,
please contact the MFC service department on +44 (0)1443 433 075.
WARNING: Repairs may only be carried out by the manufacturer, or people
certied by MFC International Ltd.
.
7
© MFC International
MFC International
Naval Yard
Tonypandy
Rhondda Cynon Ta
CF40 1JS
T. +44 (0) 1443 433 075
www.mfc-international.com
A Respirex International Limited Group Company SA-MA115-01
Questo manuale è adatto per i seguenti modelli
1
Indice
