Introduction 1
1.0 Introduction
This document describes how to assemble the iDimension 100.
Manuals can be viewed or downloaded on the Rice Lake Weighing Systems distributor site at
www.ricelake.com
Warranty information can be found on the website at www.ricelake.com/warranties
1.1 Sa f ety
Safety Symbol Definitions
Indicates a potentially hazardous situation that, if not avoided, could result in serious injury or death, and
includes hazards that are exposed when guards are removed.
Indicates a potentially hazardous situation that, if not avoided, may result in minor or moderate injury.
Indicates information about procedures that, if not observed, could result in damage to equipment or
corruption to and loss of data.
Safety Precautions
Do not operate or work on this equipment unless you have read and understand the instructions and
warnings in this manual. Contact any Rice Lake Weighing Systems dealer for replacement manuals.
Proper care is your responsibility.
General Safety
Failure to heed may result in serious injury or death.
Electric shock hazard!
• Pluggable equipment must be installed near an easily accessible socket outlet.
• Always disconnect from main power before performing any work on the device.
• Check the power cable for damage regularly and replace it immediately if it is damaged.
• On the side of the device, maintain a clearance of at least 1.5 inches in order to prevent damage to the cable.
Do not allow minors (children) or inexperienced persons to operate this unit.
Do not operate without all shields and guards in place.
Do not place fingers into slots or possible pinch points.
Do not use this product if any of the components are cracked.
Do not make alterations or modifications to the unit.
Do not remove or obscure warning labels.
Keep hands, feet and loose clothing away from moving parts.
Do not use in hazardous areas.
Do not open the scanning head. The warranty and certification is void if this stipulation is ignored. The device may only be
opened by authorized persons.
