Rinnai RHFE-551FT Guida rapida
RHFE-551FT
FORCED FLUE HEATER
CUSTOMERS OPERATING
INFORMATION
AND
INSTALLATION INSTRUCTIONS
.‘I.
This appliance shall be installed in accordance with:-
Manufacturer’s Installation Instructions
Local Gas Fitting Regulations
Municipal Building Codes
GANZ Installation Code for Gas Burning Equipment
Any other relevant Statutory Regulation
This appliance must be installed, serviced and removed by an
Authorised Person. Rinnai
wp
GAS SPACE HEATERS
( CONTENTS
CUSTOMERS OPERATING INFORMATION .............................. 1
Important Points ....................................................................... 5
Guarantee Information ................................................................ 7
Safety Devices .......................................................................... 8
Care of your RHFE-551FT ........................................................... 9
Pre Service Check .................................................................... 10
INSTALLATION INSTRUCTIONS .......................................... 11
Location .............................................................................. 12
Sleeve and Manifold Installation ................................................... 15
Fitting Unit .......................................................................... 17
Testing ............................................................................... 18
Installation Check ................................................................... 19
Dimensions ........................................................................... 20
Wiring Diagram ..................................................................... 21
Specifications ..................................................................... Back Cover
Service Contact Points ................................ ..I ....................... Back Cover
Voumard Coax Installations ...................... See Instructions supplied with flue set
I
( FEATURES OF RHFE451FT
1. Input 22MJ/ h, output approximately 18MJ/ h, suitable for both domestic and
commercial applications.
2. 3 step automatic heat control with electrdnic thermostat, the fan is also controlled by
the thermostat.
3. Ignition is electronic.
4. The integral humidifier tray can be ftied with water as required to raise the humidity
level in the room.
5. Air for combustion is taken from the outside and the flue product is exhausted outside,
keeping the room air clean.
6. Warm air is discharged at the bottom of the heater, this improves air distribution.
7. Only one 80 mm diameter hole is required in the wall for flue installation.
This heater must be installed correctly by an authorised person, and the installation must
conform with local regulations. The installation must also comply with the instructions
supplied by Rinnai.
Your RHFE-551FT has been approved by the NZ Gas Association,
GANZ Approval Number 369
Please keep these instructions in a safe place for future reference.
CUSTOMERSOPERATINGINFORMATION
For trouble free operation, please read the following information carefully:-
For your convenience the controls on your new Rinnai RHFE-551FT are situated behind a
hinged cover on the top right hand side of the heater.
All necessary adjustments to the operation of the Rinnai RHFE-551FT can be made with
these controls.
CONTROL PANEL
Number
diagam Control Function
a ON -
cl
OFF& ~ Main Switch:
Turns the unit on and off
a 0 0 -;$- “ON” Indicator Lamp (Green):
Indicates that the heater is in the “ON” mode.
0 0 +- 0 COMBUSTION Indicator Lamp (Red):
Indicates that the burner is alight.
@I ;+- 0 0 TIMER Indicator Lamp (Green):
Indicates that the timer is in use.
0
TEMPERATURE Thermostat Control:
For Room Temperature Adjustment.
8
Timer:
Allows you to programme the heater to come on
after a pre-selected delay, for example in the morning
or before you come home from work.
-l--
1 CUSTOMERS OPERATING INFORMATION
H IGNITION (Not using Timer)
Make sure the timer is in the “ON”
position.
n To Ignite Main Burner
Push the main switch down to switch it
“ON”. ON * -
OFF 1 0
The green indicator lamp will glow.
The heater will light in about 15 seconds,
and the red indicator lamp will glow.
If the heater does not light, check that the
temperature control is set to a high enough
setting.
TEMPERATURE
.
n To Increase Room Temperature
Slide the temperature control towards the
“HI” position. The burner has 3 settings,
“OFF”, “LO”; “HI” and will automatically
modulate between these settings to keep
the room temperature constant. It is quite
normal for the burner to go out auto-
matically during operation. When the
burner goes out, the red combustion lamp
goes out, but the green operation lamp
stays alight.
The fan speed will also modulate according
to the room temperature.
TEMPERATURE
n To Decrease Room Temperature
Slide the control towards the “LO”
position.
The heater may go out completely, and
come on again when the room temperature
has dropped to the selected level.
TEMPERATURE
-2-
1 CUSTOMERS OPERATING INFORMATION
e mam swi o the “OFF”
position. The fan will continue to run until
the heater is cool.
Do not turn the heater off by unplugging
it from the power point.
If the main switch is in the “ON” position
and the operation lamp is out, the unit is
in Lockout (automatic shut off). This does
not apply when timer is in use.
To re-set, switch off, wait 10 seconds, then
switch on again.
No “Operation”
Indication
Set timer
hours delay which you require.
For example if you are going to bed at 11
p.m. and need the heater to warm the
room at 7 a.m. slide the control to 8 hrs.
Turn the heater on (Push main switch)
Set the thermostat
Turn ON
(The timer moves back towards the “ON”
position indicating the remaining delay
time.) TIMER INDICATOR
GLOWS
After the pre-selected delay, the operation
lamp will glow. The burner will light
automatically in about 15 seconds and the
heater will maintain the pre-set room
TEMPERATURE
Thermostat
The burner will go out and the fan will
stop when the heater is cool.
The heater will relight after the pre-selected
delay.
CUSTOMERS OPERATING INFORMATION
So that you can humidify the air your
RHFE-551FT is fitted with an enamelled
tray behind the air outlet. To fill the tray,
open the door as shown in the diagram
and pour water into the tray using the
spout built into the door.
The air will be humidified as it passes over
the water in the tray. DO NOT FILL
THE TRAY WHILST THE UNIT IS IN
OPERATION. CLOSE THE DOOR
AFTER FILLING. The RHFE-551FT is
a very high efficiency appliance, during
operation a small amount of water is
produced in the flue tubes, this drains into
the enamel tray. It is quite normal for a
small quantity of water to remain in the
bottom of the tray. If you are using the
humidifier, it will need filling about once
a day during the heating season.
Do not force door open too far.
Close door during operation.
To protect the fan from dust and lint, the
RHFE-55 1FT is fitted with 2 fan filters.
They are located at the top, rear of the
unit. To clean, pull the filters out of the
unit and remove dust with a soft brush or
a vacuum cleaner. Replace filters after
cleaning, Weekly cleaning is recommended
during the heating season.
WOUTSIDE FLUE
On cold days steam may be discharged from the flue outlet, this is normal with a high
efficiency appliance and does not indicate any fault.
The heater and its flue must be installed correctly by an authorised person, and the
installation must conform to all local regulations.
The installation also must comply with the instructions supplied by Rinnai.
This heater must be serviced, installed and removed by an authorised person.
No parts or functions should be modified or permanently removed from the heater or its
flue.
-4-
IMPORTANT POINTS
Do not use for any other purpose except
heating.
x
Do not allow curtains or other flammable
materials to come into contact with the
heater
Do not store flammable products near the
unit.
These clearances should be maintained at
all times.
15Omm iI
50mm
c=
-1 m-
Keep flammable materials, trees shrubs
etc. away from flue terminal.
.(., Flue Terminal
Supervise children near heater Do not allow young children or the infirm
to sleep directly in front of the heater
-5-
1 IMPORTANT POINTS
Do not allow children to ‘post’ articles in
the louvres.
Do not spray aerosols on the heater whilst
it is in operation.
Do not sit on this heater.
Do not place any articles containing liquids
on top of the heater.
Do not place articles on or against the
heater.
-6-
GUARANTEE INFORMATION
H RINNAI GUARANTEE OF QUALITY
As a purchaser of a high quality Rinnai Product, we provide you with the following
guarantee on your new RHFE-551FT. J
All parts
FREE PARTS
1 year
The benefits conferred by this guarantee are in addition to all other rights and remedies in
respect of the product which you have under the Trades Practices Act.
Please record below:
Your Retailer:
Address:
Date Of Purchase:
Your Installer:
Address:
Phone:
Installer’s Licence No.
Phone:
Date Of Installation:
The installer is responsible for your heater’s correct installation. (There is no need to post
this guarantee back to Rinnai. Simply keep it in a safe place as your record.)
-7-
1SAFETY DEVICES
Overheat Switch:
This device automatically cuts the gas off if the heater exceeds a predetermined tempera-
ture. This is normally caused by an obstruction in front of the louvres, or a blocked fan
filter.
If this switch operates, turn the unit off, remove the obstruction (clean filters) let the
unit cool off before re-operating.
Fusible Link
Backs up the overheat switch. If the fusible link cuts the unit off, a service call by an
authorised person is required to replace the link.
Flame Failure Device
If the flame goes out during operation this device cuts the unit off (lockout). To reset,
turn the unit off, then on again.
Fan Switch
Turns the fan on automatically when the heat exchanger warms up and off when it cools
down. This helps to prevent cold draughts and adds to the unit’s efficiency.
-8-
Altri manuali per RHFE-551FT
1
Indice
Altri manuali Rinnai Stufa
Rinnai
Rinnai Sapphire Manuale utente
Rinnai
Rinnai RCE-460PTR Manuale utente
Rinnai
Rinnai Efficiency HD250i Manuale utente
Rinnai
Rinnai RCE-592ACPA Istruzioni per l'installazione e il funzionamento
Rinnai
Rinnai REH-311FT(B) Manuale utente
Rinnai
Rinnai ENERGYSAVER RHFE-308FTR Manuale utente
Rinnai
Rinnai FS35ETRBL/US Scheda tecnica
Rinnai
Rinnai ORH15SR Manuale utente
Rinnai
Rinnai Graduate MkII Manuale utente
Rinnai
Rinnai Avenger 25 Manuale utente
Rinnai
Rinnai rhfe-556ftp Manuale utente
Rinnai
Rinnai FC510 Manuale utente
Rinnai
Rinnai Energysaver RHFE-1004FDT Istruzioni operative
Rinnai
Rinnai RCE-329A Guida rapida
Rinnai
Rinnai Energysaver RHFE-556T Manuale utente
Rinnai
Rinnai RHE1S40N Manuale utente
Rinnai
Rinnai Avenger 25 Plus Manuale utente
Rinnai
Rinnai ASPIRATION RHFE-750ETR Manuale utente
Rinnai
Rinnai RHFE-557FT Manuale utente
Rinnai
Rinnai ORH15S Manuale utente
Manuali Stufa popolari di altre marche
Empire Heating Systems
Empire Heating Systems WCC65 Manuale utente
Wetekom
Wetekom 92 86 43 Manuale utente
Desa
Desa SPC170-F Manuale utente
Watlow
Watlow Watrod Electric Tubular Heaters Manuale utente
Haverland
Haverland ECO-DRY GPS Series Manuale elenco delle parti
Stelpro
Stelpro ASILVC2060 Series Manuale utente