03-TM-0046 Page 9 of 13
2.5.9. Replace the battery end cap and install the three 4-40 brass
machine screws. Tighten until the cap flange contacts the body or leaves
less than a 0.003 inch (0.076 mm) gap. Use hand force only on the
brass screws. Clean beacon exterior of excess O-ring grease.
2.5.10. Perform operational test of beacon as outlined in Section 2.1.
3.0 Returning Product for Service
When shipping a product back to RJE from either inside or outside
the United States, the following instructions will help ensure the
equipment arrives with the minimum possible delay. Any deviation
from these instructions increases the potential for delay.
Step 1 - Get a Return Authorization
The best way to make sure RJE is aware of your intentions to ship
equipment is to obtain a Return Material Authorization (RMA)
before sending the shipment. Return Material Authorizations are
issued by Sales Administration or Customer Service and are used
to notify us of your needs in advance of arrival so we can provide a
faster turnaround. When requesting a Return Material
Authorization, please give us the following information.
•What is being shipped (include the serial number)
•When you plan to send the shipment
•What problem(s) need correction
•When you need the instrument returned
When the Return Material Authorization is issued, we will tell you
the RMA number. Please include this number on all packages and
correspondence.
Mark the Package(s)
To: RJE International, Inc. (RMA Number)
15375 Barranca Parkway, Suite B107
Irvine, California 92618
