Roksan Audio OXYGENE Manuale utente

OWNER’S MANUAL

OXYGENE INTEGRATED AMPLIFIER

Introduction

Congratulations on your new Oxygene Integrated Amplifier. You have

made an excellent choice!

All ROKSAN products are designed, engineered and manufactured in the

United Kingdom. They are thoroughly tested before shipment in order

to provide you the best musical satisfaction and a lasting value. We have

gone to every length to ensure that your amplifier will be easy to operate,

enabling you to enjoy your music immediately.

We do, however, recommend that you read these instructions carefully.

Your experience will benefit from knowing the details of operation of your

new Oxygene Integrated Amplifier.

Unpacking

Carefully lift the amplifier out of the box and make sure not to scratch the

fine surfaces.

Pleasesaveallthepackaginginadryplaceforfutureuse.Shouldyourunitever

require transporting, it is strongly advised to do so in the original packaging.

Repair and servicing agents will insist on the original packaging. Your

warranty may be affected, if an alternative packaging is used and transport

damage is caused due to inadequate packaging.

General Safety Precautions

Read instructions

All the safety and operating instructions should be read carefully before the

unit is operated.

Retain Instructions

The safety and operating instructions should be retained for future

reference.

Heed warnings

All warnings on the equipment and in the operating instructions should be

adhered to.

Water and moisture

Theunitshouldnotbeusednearwater–forexample,nearabathtub,washbowl,

kitchensink,laundrymachine,inawetbasementornearaswimmingpooletc.

Note: Liquids should never come into contact with this product.

Heat

The unit should be situated away from heat sources such as radiators, heat

registers, stoves, direct sunlight or other components that produce heat.

Ventilation

The unit should be placed in a well ventilated environment and not be

obstructed by soft furnishings such as bedding, sofas, on rugs or carpets, or

similar surfaces that may block the vent openings, it is not advised to placed

in cabinets, cupboards or bookcases where ventilation is limited.

Non-use periods

Unplug the unit from the mains outlet when left unused for longer periods

of time e.g. a vacation period.

INSTALLATION

Installation

Keep power switched off when connecting or disconnecting the unit to

other components. This will prevent unpleasant and loud noises coming

from the loudspeakers and avoid the risk of damage to the equipment.

Power cord

The separate power cord supplied connects to the AC power socket on the

rear panel. Make all other connections before fitting the mains power cord.

ON/OFF

Press the ON/OFF button, underneath and to the right front side of the

Oxygene Integrated Amplifier to power it up. When switching the unit off

please reduce the volume level to less than 20.

Standby

The Oxygene products do not have a standby function. This is because

we constantly strive to make our products environmentally friendly; and

the best way to save on electricity is to turn off the unit when not in use.

Many audio products require a long warm up period in order to perform at

their best. This is not the case with the Oxygene series as these units have

been designed using the latest digital technology.

Service and repairs

All service and repair work must be performed by a qualified technician,

authorized by ROKSAN. The warranty will become void, if the unit has been

modified or tampered with.

Mains Voltage

The Oxygene Integrated Amplifier is factory set for a specific voltage and

will only work with that voltage (±10%). The correct AC mains voltage is

printed on the label situated at the bottom of the unit.

Make sure your AC mains voltage is correct before connecting the unit.

four versions of the Oxygene Integrated Amplifier are available:

• 100 V 50/60 Hz

• 115 V 50/60 Hz

• 240 V 50/60 Hz

• 230 V 50/60 Hz.

In case you move to a country that has a different AC supply voltage,

contact your ROKSAN dealer or the authorized distributor for a professional

conversion to the new supply voltage.

Loudspeakers

The rear panel of the Oxygene Integrated Amplifier has one pair of safety

banana output sockets on either side. Please make sure not to short the

wires when you connect your loudspeakers. Please use the special Roksan

safety plugs for the loudspeaker cables.

Subwoofers

The Oxygene Integrated Amplifier has two RCA output connectors L/R

labeled “OUT”. These can be used for connecting active subwoofers. The

signal is volume regulated – known as a pre-out signal. This output can also

General

Receiver

The remote receiver is located behind the 3 small holes on the front top

right corner of either amplifier or CD player.

Display and Dimmer

The Oxygene display has three brightness modes; Bright, Dim & off.

When selecting any function either by remote control or touch of “LESS”,

“IS” or “MORE” on the unit, the display will go bright to acknowledge

contact allowing for functions to be selected. The dot matrix display will

appropriately show “VOLUME” or “LINE INPUT”.

Batteries

The Oxygene’s minimalist remote carries two (2) CR 2430 button type

batteries. To replace the battery access is achieved via the rear panel;

remove four small screws, lift rear panel and carefully remove battery. Insert

new battery taking care that the + (positive) is facing up as before. Replace

rear panel and tighten screws until they stop turning, do not over tighten.

be used for adding an amplifier for another room, or for bi-amping.

Cables

Please use the ROKSAN interconnects & loudspeaker cables. As better

components and systems are developed, it becomes increasingly important

to avoid the limitations of inferior system interconnections and cables.

OPERATION

“LESS IS MORE”

LESS IS MORE

Input select Touch “IS” once - then “LESS” or “MORE” to move

backward or forward between inputs.

Volume Up Touch “MORE”

Volume Down Touch “LESS”

The Oxygene Integrated Amplifier has 3 hidden switches incorporated

in the words “LESS IS MORE” on top of the cabinet. These three

switches/words control all basic functions of the integrated amplifier.

You will get familiar with the various commands after just a few minutes.

All functions can also be accessed via the Oxygene Remote Control (please

refer to the section about the Oxygene Remote).

Less is More Controls

When one makes contact with “LESS”, “IS” or “MORE” the display will

go bright to acknowledge contact allowing for function to be selected.

After three seconds of having been left idle the display

will go back to the previously chosen light intensity.

Simply touch “LESS” or “MORE” to adjust the volume down or up respectively

or to toggle between the different input channels.

Functions

1Press to adjust the intensity of the

display light :Bright, Dim & Light Off

2 Volume UP

3Volume DOWN

4 PLAY & PAUSE

5 Previous track & Fast reverse

6 Next track & Fast Forward

7EJECT CD

8 INPUT SELECT (Line1,2,3 & BT)

Oxygene Remote Control

Controls both the CD Player and the Integrated Amplifier.

Display

The dot matrix display on amplifier will respectively show “VOLUME” or

“LINE INPUT”.

Dimmer

The Oxygene display has three brightness modes; Bright, Dim & off.

Bluetooth

How to set up your Bluetooth devices

The Oxygene Integrated Amplifier is fitted with the latest Bluetooth aptX

technology.

In order to stream your music wirelessly from your Bluetooth devices to the

Oxygene Integrated Amplifier you need to first pair them to the Bluetooth

module in the Oxygene Integrated Amplifier. This is very easy and shouldn’t

take more than a few seconds.

Streaming from mobile phones and other BT enabled devices

Make sure the line input on the Oxygene Integrated Amplifier is at “BT”.

Activate Bluetooth on your Bluetooth device and search for devices. The

Oxygene Integrated Amplifier will be visible as “ROKSAN” on your mobile

phone. If asked for the code, please enter ‘0000’. Please note that the

Oxygene Integrated Amplifier will take a few moments to connect to your

mobile phone for the first time. When the Oxygene Integrated Amplifier

and the mobile phone have been paired you can play wirelessly at anytime

in the future without having to pair the devices again.

Altri manuali per OXYGENE

Indice

Altri manuali Roksan Audio Amplificatore

Roksan Audio

Roksan Audio Blak Manuale utente

Roksan Audio

Roksan Audio K3 Manuale utente

Roksan Audio

Roksan Audio M series --1 Manuale utente

Roksan Audio

Roksan Audio Kandy K2 Manuale utente

Roksan Audio

Roksan Audio Platinum STI308 Manuale utente

Roksan Audio

Roksan Audio K3 Manuale utente

Roksan Audio

Roksan Audio 5-CH AMPLIFIER Manuale utente

Roksan Audio

Roksan Audio Attessa Manuale utente

Roksan Audio

Roksan Audio Attessa Manuale utente

Roksan Audio

Roksan Audio K3 DAC Manuale utente

Roksan Audio

Roksan Audio M series --1 Manuale utente

Roksan Audio

Roksan Audio Caspian Manuale utente

Roksan Audio

Roksan Audio Caspian M series-1 Manuale utente

Roksan Audio

Roksan Audio caspian m2 Manuale utente

Roksan Audio

Roksan Audio Caspian Manuale utente

Roksan Audio

Roksan Audio Kandy KMA-2/3 Manuale utente

Roksan Audio

Roksan Audio K3 Manuale utente

Roksan Audio

Roksan Audio K3 Manuale utente

Roksan Audio

Roksan Audio PR15B Manuale utente

Roksan Audio

Roksan Audio OXYGENE Manuale utente

Roksan Audio

Roksan Audio Blak Manuale utente

Roksan Audio

Roksan Audio LIII Manuale utente

Roksan Audio

Roksan Audio CASPIAN RPP Manuale utente

Roksan Audio

Roksan Audio Kandy K2 Manuale utente

Manuali Amplificatore popolari di altre marche

ASTRO

ASTRO HVO V40 P Manuale utente

Marantz

Marantz SUPERSCOPE BLA-545 Istruzioni per il montaggio

NAD

NAD CI980 Manuale utente

Technics

Technics SE-CH770 Manuale utente

Harman Kardon

Harman Kardon HK6300 Manuale utente

NAD

NAD T975 Manuale utente

McIntosh

McIntosh MA6850 Manuale utente

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manuale utente

Viatron

Viatron Autrix Manuale utente

GME

GME GA9800 Manuale utente

Atlas

Atlas CP700 Manuale utente

Roland

Roland KC-1000 Manuale utente

Pyle

Pyle PFMRA350BW Manuale utente

Advantage

Advantage S-250 Manuale utente

IRT Electronics

IRT Electronics DVA-3007 Manuale utente

Dimavery

Dimavery BA-100 Series Manuale utente

Sony

Sony XM-S400D Manuale utente

Schertler

Schertler ROY X Manuale utente