9 | Page
01/2019
RTI | Miravue VIP-1 Manual
4) The RTI | Miravue VIP-1 Web Interface
The settings that should be adjusted via the web interface are dependent on whether the VIP-1 will be used
with an RTI control system or not.
IMPORTANT NOTE: If an RTI control system is used, the VIP-1 settings are configured via the two-way driver in
the Integration Designer programming software and will overwrite settings made via the web interface.
Web Interface Settings:
•When using an RTI control system: WiFi settings, Audio Offset.
•Without an RTI control system: All VIP-1 settings are configured via web interface.
a. Accessing the Setup Web Interface
Wired
From a web browser, enter the VIP-1 transceiver's IP
address (displayed on a TV via the HDMl-out port). If no
DHCP server is found, the transceiver assigns a default IP
address. Before entering the IP address, make sure the
connecting device is configured to the same network
segment (e.g., IP range, subnet mask, gateway, etc.)
Default IP address: 192.168.8.1
Note:
If the VIP-1 transceiver's IP address is later configured
outside the IP range of the connected device (laptop,
tablet etc), the LAN settings must be re-configured to
the same network segment before continuing. If the
network settings cannot be determined, pressing the
“DEFAULT” button for 10 seconds on the VIP-1 will
reset unit back to the factory default, and the
networking will be set to DHCP.
VIP-1 HDMI Output Displayed on TV/Monitor
