SAC AE5042 Manuale utente
AE5042/AE5044/AE5046
LTE/4G READY AERIAL
INDOOR AMPLIFIER User Manual
CAUTION
Please read through this manual carefully before use. This
product is strictly for indoor use only, please install this product
in dry and cool environment and keep out of reach from children
and pets.
Please do not open cover, contain high
voltage. This product is not serviceable or
repairable by end user. Please return to
seller or professional when unit
malfunction.
INSTRODUCTION:
Thank you for choosing our indoor amplifier series. It is designed to amplify weak FM/DAB/TV aerial
from antenna and distribute to multiple outputs, ideal for domestic or commercial use to distribute
FM/DAB/TV/Sat signal to different room/area.
PRODUCT FEATURE:
- Separate dedicated inputs for VHF and UHF signal.
- Built in low noise high gain amplifier to boost weak signals from antenna.
- Built in mixer to give wide band VHF and UHF output.
- Built 4G filter to prevent interference from 4G mobile signal.
-Full max gain output to for further signal distribution installation.
- DC pass function allows installation for additional infra-red control for satellite receiver.
- Short circuit protection as well as surge and spike protection to ensure your TV/Hi-Fi is
protected from lightning strike.
SPECIFICATION:
QA-8203ULQA-8203UL QA-8203UL
A E 5 0 4 2
No of inputs
2
2
2
No of outputs
2
4
6
Frequency
response 47-230MHz
47-790MHz
Max output level 97dBµV 97dBµV 90dBµV
Gain per split
12dB
12dB
10dB
Noise
<3.8dB
<3.8dB
<3.8dB
Isolation
22dB
22dB
22dB
INSTALLATION:
Before install please ensure all devices to be connecting to the amplifier are switched off and
disconnected to the mains. The unit is designed to be connected via coax connector, f type adaptors
are supplied allows compatibility. At the back of the case there are two mount holes which allow unit
to be mounted on the wall.
Our indoor amplifier is designed to amplify weak signal and distribute to different destination.
For installation that is close to TV transmitter or any other form of radio transmitter or high power
source, may experience blocking or frozen picture screen. An attenuator will require tuning down
signal to suitable level for TV viewing.
AE5044 AE5046
470-790MHz 47-230MHz
470-790MHz 47-230MHz
470-790MHz
Receiving Range VHF/UHF VHF/UHF VHF/UHF
Below are some of the examples for installation:
This diagram shows AE5046 receiving TV signals from the Sat receiver and FM/DAB aerial and
distributes signals to 4 individual hi-fi and TV units. Indoor amplifier series is designed with DC pass
function. All 3 TV units can be set up with “Magic eye” (remote extension unit) to allow remote
control of Sat receiver when TV set is not at the same room as the Sat receiver. This can only be
done when connect the RF2 output to the UHF input of the amplifier.
Please note: only one sat channel can be viewed at any particular time from the Sat receiver. Indoor
amplifier series do not require setup to operate, for Sat receiver set up please refer to your Sat
receiver manual.
To further signal distribution set up
UH FDAB
220~240V
50Hz
It is also suitable for upgrade or replace existing UHF/VHF signal distribution unit, simply reconnect
existing connector from previous unit to the Indoor amplifier. Ensure the UHF aerial is connected to the
UHF input of the amplifier and FM/DAB aerial connected to the VHF input of the amplifier. For loft
distribution installation please ensure the unit is kept away from moist/water.
For TVs that are not compatible with digital TV channel will require a digital set top box for TV
viewing.
This product is classed as Electrical or Electronic equipment and should not be disposed
with other household or commercial waste at the end of its useful life. The goods must be disposed of
according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2016
UHF
DAB
Questo manuale è adatto per i seguenti modelli
3
Indice
Altri manuali SAC Amplificatore
