Safe Fleet LMU Controller Manuale utente

For LMU Models 26 and 27

LMU Controller

Installation Guide

— THIS PAGE LEFT INTENTIONALLY BLANK —

LMU Controller

Table of Contents

Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Kit Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Complete Installation Record.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Install LMU Controller Antenna. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Install LMU Controller. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8

LMU Controller LEDs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Operation Status.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Set Up LMU Controller in vMax Live Plus.. . . . . . . . . . . . . . . . . . . . . . . . . . . 11

Login and Launch.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

Troubleshooting.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

Specications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15

Appendix. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

Customer Service.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

Product Information.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16

Warranty And End-User License Agreement.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16

LMU Controller

Overview

Use this guide to install and set up the Location Messaging Units LMU 26 and LMU 27 Controller.

The LMU Controller provides vehicle tracking to view in vMax Live Plus 5.0 for users on Sprint, Verizon, and Rogers cell

networks.

This guide provides instruction for installing the LMU Controller by itself or with a DVR. To work with a DVR, the DVR needs

to have rmware version 2.0 or higher.

This installation must be performed by a professional with approval from Seon Design.

Overview

The required and optional contents of a typical installation package are shown below. The actual contents of your installation

package may vary, depending on the options selected.

• 20 pin cable, including power harness and

fuses

• Quick Install Guide

• LMU Controller

Kit Contents

• Alarm Button with extension cable and 4

crimps

• Antenna (GPS/Cellular)

• GPS extension cable (optional, with DVR

install)

• Aux1 to GPS adaptor cable (optional, with DVR

install)

LMU Controller

Installation

1. From Seon or the customer, the installer gets an Installation

Record (see sample below) with the Device ID column populated.

The Device ID is the 10 digit ESN number on the LMU Controller

label.

2. Fill in the rest of the Installation Record elds for the bus

installation

Installation

Complete Installation Record

LMU Controller

Installation

Install LMU Controller Antenna

1. Identify a suitable location for the antenna on the inside of the windscreen.

The antenna must be installed on the inside of the front windshield out of the way of the driver’s view.

The 10 foot antenna cables attach to the LMU Controller’s GPS and Cellular antenna connectors.

IMPORTANT 

• The antenna cable length is 10 feet long and cannot be extended. This may limit the location options for

the LMU Controller.

• Use only the supplied antenna. Antennas from other manufacturers will not work with the LMU Controller.

2. Using the supplied alcohol wipe pad, clean the window surface where the antenna will be installed.

3. Peel the protective cover from the foam backing on antenna.

4. Be careful not to touch or allow any foreign material to come in contact with the exposed adhesive.

5. Attach the antenna to the window.

• Do not attach within the wiper sweep area.

• Do not attach to windows that can open.

6. Run the cables to the intended LMU Controller location.

LMU Controller

Installation

Install LMU Controller

1. Select an LMU Controller modem installation location that meets the following requirements:

CAUTION: Installation Requirements 

• The LMU Controller must be installed within the range of the Antenna cable distance.

• Install within the vehicle, close to the DVR if possible.

• Install where LEDs can be seen if necessary.

• Install in the front of the vehicle.

• Route the wiring and cables away from sharp edges that might damage the insulation.

• Avoid sharp bends in the cable.

Installation Requirements

Location Choose a dry location with easy access to the electrical panel and cable connections to mount the

LMU Controller.

Check that the LMU Controller location is within the maximum reach of the antenna cable.

Install the LMU Controller away from any place where tampering with the device or cable connections

may occur.

Surface Do not mount the LMU Controller to a plastic panel or other surface that is subject to constant

vibration.

Clearance Allow sufcient clearance of at least six (6) inches in front of the LMU Controller and two (2) inches

on each side for easy access and removal of cable connectors and ports.

Allow sufcient clearance behind the LMU Controller for antenna and power cables.

Harnesses Provide enough slack on the power cable to prevent any force from being exerted on the connectors.

A single 4-inch diameter loop is sufcient.

2. Using the supplied alcohol wipe pad, clean the vehicle surface where the LMU Controller will be installed.

3. Peel the protective cover from the velcro backing on the LMU Controller. Be careful not to touch or allow any foreign

material to come in contact with the exposed adhesive.

4. Attach the LMU Controller to the vehicle.

5. Connect all power, alarm, GPS, and Stop Arm cabling to the LMU Controller 20 pin harness using the following

diagram.

LMU Controller

Installation

3 wires

3A Battery Negative (black)

Vehicle + 12/24V (red)

Black wire from pin 16 to black on

extension cable and Alarm button.

Aux 1

Cable Harness

and Connector

TL/TX/TH/NH16

GPS socket

LMU Controller Connections

Typical System Setup, with optional DVR Connections

Ignition (white)

LMU

to GPS

Adaptor

Cable

Power harness (red, black, white wires)

LMU Controller, Harness LED end

Comm LED

GPS LED

1x5 Microt

connector

2x2 Microt

connector

DVR

option

Pin 1

Pin 11

Pin 10

Pin 20

NOTE: Aux 2 connector

and other harness

wires not mentioned

here are not used.

GPS4 Cable

Pin 16 Alarm Button

(black wire, active low)

Pin 3 Stop Arm

(blue wire, active high)

3.5 mm

GPS

Connector

GPS &

Cellular

Antenna

LMU Controller, Antenna end

2.5 mm

Comm

Connector

MX/DX:

GPS socket

on Smart-Link

Orange wire from pin 12 to red on

extension cable and Alarm button.

Pin 12 Alarm Button

(orange wire, active low)

6. Clip the 1x2 Microt connector from the end of the alarm button extension cable.

7. Connect the alarm button’s red and black wires to the extension cable’s red and black wires with the supplied crimps.

8. If the LMU Controller is being connected to a DVR, connect the AUX 1 connector from the LMU Controller 20 pin

harness to the supplied 060-1012 adapter cable, which connects to the GPS Extension cable, which connects to the

DVR’s GPS socket.

IMPORTANT 

If the DVR has a GPS4 unit installed, the GPS4 unit can be removed. The LMU Controller replaces GPS4

functionality on the DVR.

LMU Controller

LMU Controller LEDs

9. Run the harness cabling and the GPS and Cellular cabling to the intended LMU Controller location.

10. Connect the GPS and Cellular connectors to the LMU Controller.

11. Connect the 20 pin harness to the LMU Controller.

12. Tie off unused wires from harness.

LMU Controller LEDs

Operation Status

Once the 20 pin harness is connected to the LMU Controller, this will have power.

The LMU Controller is congured to provide vehicle tracking and live video streaming information to vMax Live Plus users.

LEDs on the LMU Controller indicate operation status and display operation mode conditions as described below.

LED Status Indicators

Comm LED - Orange Condition GPS LED - Green Condition

Off Modem Off Off GPS Off

Slow Blinking Comm On - Searching Slow Blinking GPS On

Fast Blinking Network Available Fast Blinking GPS Time Sync

Fast Blink to Solid Registered - no Inbound Acknowledgment Solid GPS Fix

Solid Registered - Inbound Acknowledgment

LMU Controller

Set Up LMU Controller in vMax Live Plus

On the installation record, nd the provided Fleet ID, username (default: admin), and password (default: password) to log

into www.vmaxlive.net.

a. Enter your Fleet ID (provided by Seon).

b. Click Continue. If conrmed, a similar User and

Password window appears.

c. Enter your User ID and your Password.

d. Click Login.

TO SET UP THE DVR AND LMU CONTROLLER

1. In vMax Live Plus, in the main view, click Integrations.

CAUTION: Password Security 

The default password is “password”. For security purposes, Seon recommends that the user default login and

system settings passwords should be changed. Seon is not responsible if the password is lost or forgotten.

Indice

Altri manuali Safe Fleet Controllori

Safe Fleet

Safe Fleet FoamPro Accumax II Fury Guida

Manuali Controllori popolari di altre marche

Digiplex

Digiplex DGP-848 Istruzioni operative

YASKAWA

YASKAWA SGM series Manuale utente

Sinope

Sinope Calypso RM3500ZB Manuale utente

Isimet

Isimet DLA Series Style 2 Manuale di installazione

LSIS

LSIS sv-ip5a Manuale utente

Rockwell Automation

Rockwell Automation 1769-L31 Manuale utente

Airflow

Airflow Uno hab Manuale utente

ABB

ABB ACS580-01 drives Manuale utente

Panasonic

Panasonic GM1 Series Manuale utente

Emerson

Emerson SW93 Manuale utente

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuale utente

Panasonic

Panasonic FP? Positioning Unit RTEX Manuale utente

Samson

Samson Type 5824 Manuale di servizio

Alpha IP

Alpha IP MIOB 21001 Manuale utente

Siemens

Siemens OpenAir GMA 1 Series Manuale utente

Surecom

Surecom SR-629 Manuale utente

Fishman

Fishman TriplePlay Manuale utente

Regulus

Regulus SRS1 T Manuale utente