Samsara SC11 Manuale utente
For more details on mounting or additional technical information, visit the
Connected Sites knowledge base at samsara.com/support
1x
1x
4x
4x 2x 1x
1x 1x 1x
INSTALL GUIDE — FMS
GUIDE D’INSTALLATION — FMS
INSTALLATIONSANLEITUNG — FMS
GUÍA DE INSTALACIÓN — FMS
GUIDA ALL’INSTALLAZIONE — FMS
INSTALLATIEGIDS — FMS
Dome IP Site Camera
SC11
samsara.com/support 2
T10 5.5 ~ 6.4 mm
TOP VIEW
4
1 2
3
Remove lid with the Torx driver
provided.
Attach cable gland if using outdoors
or in a wet environment.
Verify camera is powered before
mounting.
If necessary, install drywall anchors
using the alignment sticker. Feed
the ethernet cable through the
middle opening of the back plate,
then fasten the back plate to the
mounting surface using the
provided screws.
samsara.com/support 3
Add Cameras
TOP VIEW
0 ~ 352º
0 ~ 352º
56
7a 7b
When your camera is plugged into
the network, add the camera to your
dashboard by going to Devices >
Cameras > Add Cameras. You can
identify your camera in the results via
the serial and/or MAC address
printed on the camera's box.
Once added, confirm the camera is
positioned correctly by viewing it in
the mobile app or dashboard. The
next steps demonstrate the different
axes you can use to adjust the
camera's field of view.
Optional: Twist camera base to
rotate.
Optional: Tilt lens. May need to rotate
180º to tilt in the reverse direction.
samsara.com/support 4
T10
TOP VIEW
0 ~ 75º
Tilt Arm
TOP VIEW
9
7c 8
Optional: Rotate aperture where
needed.
This is the top of the camera and
should be mounted with this side up.
Once the aperture is properly
aimed, use the Torx driver to
secure the lid.
Altri manuali Samsara Telecamera di sicurezza
