Samsung Ubigate iBG2016 Manuale di programmazione

This manual is proprietary to SAMSUNG Electronics Co., Ltd. and is protected by copyright.

No information contained herein may be copied, translated, transcribed or duplicated for any

commercial purposes or disclosed to the third party in any form without the prior written consent of

SAMSUNG Electronics Co., Ltd.

TRADEMARKS

Ubigate iBG2016 is registered trademarks of SAMSNUG Electronics.

All other company and product names may be trademarks of the respective companies with which

they are associated.

This manual should be read before the installation and operation, and the operator should

correctly install and operate the product by using this manual.



This manual may be changed for the system improvement, standardization and other technical reasons

without prior notice.

For further information on the updated manual or have a question for the content of manual, contact

the homepage below.

Homepage: http://www.samsungen.com

Ubigate iBG2016 TroubleShooting Manual

GENERAL USER INFORMATION

RADIO FREQUENCY INTERFERENCE

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference in which case the user

will be required to correct the interference at his own expense.

FCC REQUIREMENTS

Thie equipment, the Ubigate iBG2016, complies with Part 68 of the FCC rules

and the requirements adopted by the ATCA. On the top of this equipment is a

label that contains, among other information, a product identifier in the format

US: A3LIS00BiBG2016. If requested, this number must be provided to the

telephone company.

UNAUTHORIZED MODIFICATIONS

Any changes or modifications performed on this equipment that are not

expressly approved in writing by SAMSUNG ELECTRONICS, CO., LTD.

could cause non-compliance with the FCC rules and void the user’s authority

to operate the equipment.

GENERAL USER INFORMATION

II © SAMSUNG Electronics Co., Ltd.

Allowing this equipment to be operated in such a manner as to not

provide for proper answer supervision is a violation of Part 68 of the

FCC’s rules.

TELEPHONE CONNECTION REQUIREMENT

A plug and jack used to connect this equipment to the premises wiring and

telephone network must comply with the applicable FCC Part 68 rules and

requirements adopted by the ATCA. A compliant telephone cord and modular

plug is provided with this product. It is designed to be connected to a compatible

modular jack that is also compliant. See installation instructions for details.

FCC Part 68

This equipment complies with Part 68 of the FCC rules. The FCC Part 68 label

is located on the bottom chassis panel. This label contains the FCC Registration

Number and Ringer Equivalence Number(REN) for this equipment. If requested,

this information must be provided to your telephone company.

Connection to the telephone network should be made by using standard

modular telephone jacks, type RJ-11C. The RJ-11C plug and/or jacks used

must comply with the FCC Part 68 rules.

CIRCUIT TYPE MODULE TYPE FACILITY

INTERFACE CODE NETWORK

JACK

LOOP START

LINE FXO-4M, FXO-2M

T1E1-2M, T1E1-1M

T1E1-4

02LS2

04DU9.DN

04DU9.1KN

04DU9.1SN

04DU9.1SN(PRI)

04DU9.DN

04DU9.1KN

04DU9.1SN

04DU9.1SN(PRI)

RJ11C

RJ48C

DID LINE FXS-4M, FXS-2M,

FXS-24

T1E1-2M, T1E1-1M

T1E1-4

02RV2.T

04DU9.BN

RJ11C

RJ48C

E & M TIE LINE E & M-2M, E & M-1M

T1E1-2M, T1E1-1M

T1E1-4

TL11M

04DU9.BN

04DU9-BN

RJ45S

RJ48C

Ubigate iBG2016 TroubleShooting Manual/Ed.00

RINGER EQUIVALENCE NUMBER

The REN is used to determine the number of devices that may be connected to

a telephone line. Excessive RENs on a telephone line may result in the devices

not ringing in response to an incoming call. In most but not all areas, the sum

of RENs should not exceed five(5.0). To be certain of the number of devices

that may be connected to a line, as determined by the total RENs, contact the

local telephone company. For earlier products, the REN is separately shown

on the label.

INCIDENCE OF HARM

If this equipment, the Ubigate iBG2016, causes harm to the telephone network,

the telephone company will notify you in advance that temporary

discontinuance of service may be required. But if advance notice isn’t

practical, the telephone company will notify the customer as soon as possible.

Also, you will be advised of your right to file a complaint with the FCC if you

believe it is necessary.

CHANGES TO TELEPHONE COMPANY EQUIPMENT OR

FACILITIES

The telephone company may make changes in its facilities, equipment,

operations or procedures that could affect the operation of the equipment.

If this happens the telephone company will provide advance notice in order for

you to make necessary modifications to maintain uninterrupted service.

SERVICE CENTER

If trouble is experienced with the Ubigate iBG2016, please contact your local

office of SAMSUNG ELECTRONICS, CO., LTD. for repair or warranty

information. If the trouble is causing harm to the telephone network, the

telephone company may request that you remove the equipment from the

network until the problem is resolved.

FIELD REPAIRS

Only technicians certified on the Ubigate iBG2016, are authorized by

SAMSUNG ELECTRONICS, CO., LTD. to perform system repairs. Certified

technicians may replace modular parts of a system to repair or diagnose

trouble. Defective modular parts can be returned to SAMSUNG

ELECTRONICS, CO., LTD. for repair.

GENERAL USER INFORMATION

IV © SAMSUNG Electronics Co., Ltd.

GENERAL

Connection to party line service is subject to state tariffs. Contact the state

public utility commission, public service commission or corporation

commission for information.

Equipment With Direct Inward Dialing (‘DID’)

ALLOWING THIS EQUIPMENT TO BE OPERATED IN SUCH A

MANNER AS TO NOT PROVIDE FOR PROPER ANSWER

SUPERVISION IS A VIOLATION OF PART 68 OF THE FCC’S RULES

PROPER ANSWER SUPERVISION IS WHEN:

A) This equipment returns answer supervision to the Public Switched

Telephone Network(PSTN) when DID calls are:

 Answered by the called station

 Answered by the attendant

 Routed to a recorded announcement that can be administered by the

Customer Premises Equipment(CPE) user.

 Routed to a dial prompt

B) This equipment returns answer supervision on all DID calls forwarded to

the PSTN.

Permissible exceptions are:

 A call is unanswered

 A busy tone is received

 A reorder tone is received

Equal Access Requirements

This equipment is capable of providing users access to interstate providers of

operator services through the use of access codes. Modification of this

equipment by call aggregators to block access dialing codes is a violation of

the Telephone Operator consumers Act of 1990.

Ubigate iBG2016 TroubleShooting Manual/Ed.00

Electrical Safety Advisory

Parties responsible for equipment requiring AC power should consider

including an advisory notice in their customer information suggesting the

customer use a surge arrestor. Telephone companies report that electrical

surges, typically lightning transients, are very destructive to customer terminal

equipment connected to AC power sources. This has been identified as a

major nationwide problem.

MUSIC ON HOLD WARNING

In accordance with US copyright laws, a license may be required from

the American Society of Composers, Authors and Publishers(ASCAP)

or other similar organizations if copyright music is transmitted through

the Music on Hold feature.

SAMSUNG ELECTRONICS, CO., LTD. hereby disclaims any liability

arising out of failure to obtain such a license.

DISA WARNING

Lines that are used for the Direct Inward System Access feature must have the

disconnect supervision options provided by the telephone company.

As it is impossible to control who may access your DISA line it is

suggested that you do not turn this feature on unless you intend to

use it. If you do use this feature, it is good practice to frequently

change pass codes and periodically review your telephone records for

unauthorized use.

GENERAL USER INFORMATION

VI © SAMSUNG Electronics Co., Ltd.

SAFETY WARNING

High touch current earth connection essential before making

telecommunication network connection.

Energy Hazard-careful treatment is needed.

Every wire for communication should be larger than 26 AWG.

Double pole/neutral fusing.

UNDERWRITERS LABORATORIES

The Ubigate iBG2016 system has been tested to comply with safety standards

in the United States and Canada. This system is listed with Underwriters

Laboratories. The cUL Mark is separately shown on the label.

The following statement from Underwriters Labs applies to the Ubigate

iBG2016 System:

Separation of TNV and SELV - Pluggable A: ‘The separate protective

earthing terminal provided on this product shall be permanently

connected to earth.’(Instruction)

Separation of TNV and SELV - Pluggable B: ‘Disconnect TNV circuit

connector(s) before disconnecting power.’(Instruction)

Warning to service personnel: ‘CAUTION: Double pole/neutral fusing’

Ubigate iBG2016 TroubleShooting Manual/Ed.00

Telephone line cord: ‘CAUTION: To reduce the risk of fire, use only No.

26 AWG or larger(e.g., 24 AWG) UL Listed or CSA Certified

Telecommunication Line Cord’

Leakage currents due to ringing voltage - Earthing installation

instructions: ‘1.A supplementary equipment earthing conductor is to be

installed between the product or system and earth, that is, in addition to

the equipment earthing conductor in the power supply cord. 2.The

supplementary equipment earthing conductor may not be smaller in size

than the unearthed branch-circuit supply conductors. The equipment

earthing conductor is to be connected to the product at the terminal

provided, and connected to earth in a manner that ill retain the earth

connection when the power supply cord is unplugged. The connection to

earth of the supplementary earthing conductor shall be in compliance

with the appropriate rules for terminating bonding jumpers in Part K of

Article 250 of the National Electrical Code, ANSI/NFPA70 and Article

10 of Part 1 of the Canadian Electrical Code, Part 1, C22.1. Termination

of the supplementary earthing conductor is permitted to be made to

building steel, to a metal electrical raceway system, or to any earthed

item that is permanently and reliably connected to the electrical service

equipment earthed. 3.Bare, covered, or insulated earthing conductors are

acceptable.

A covered or insulated conductor must have a continuous outer finish

that is either green, or green with one or more yellow stripes.’

Safety Instructions - Rack Mount ‘Rack Mount Instructions -

The following or similar rack-mount instructions are included with the

installation instructions:

A) Elevated OperatingAmbient - If installed in a closed or multi-unitrack

assembly, the operating ambient temperature of the rack environment may

be greater than room ambient. Therefore, consideration should be given to

installing the equipment in an environment compatible with the maximum

ambient temperature(Tma) specified by the manufacturer.

B) ReducedAir Flow - Installation of the equipment in a rack should be

such that the amount of air flow required for safe operation of the equipment

is not compromised.

GENERAL USER INFORMATION

VIII © SAMSUNG Electronics Co., Ltd.

C) Mechanical Loading - Mounting of the equipment in the rack should be

such that a hazardous condition is not achieved due to uneven

mechanical loading.

D) Circuit Overloading - Consideration should be given to the connection

of the equipment to the supply circuit and the effect that overloading of

the circuits might have on overcurrent protection and supply wiring.

Appropriate consideration of equipment nameplate ratings should be

used when addressing this concern.

E) Reliable Earthing - Reliable earthing of rack-mounted equipment

should be maintained. Particular attention should be given to supply

connections other than direct connections to the branch circuit(e.g., use

of power strips).’

Altri manuali per Ubigate iBG2016

Indice

Altri manuali Samsung Router di rete

Samsung

Samsung SCH-LC11 Manuale utente

Samsung

Samsung AHT-E300 Manuale utente

Samsung

Samsung Connect Home Pro ET-WV533 Manuale utente

Samsung

Samsung Connect Home Pro ET-WV520 Manuale utente

Samsung

Samsung iES4028FP Manuale utente

Samsung

Samsung SCC-RC130 Manuale utente

Samsung

Samsung MagicLAN SWL-2200U Manuale utente

Samsung

Samsung 5G CPE Manuale utente

Samsung

Samsung DCS-VIP Manuale utente

Samsung

Samsung SmartThings Wifi ET-WV525 Manuale utente

Samsung

Samsung DIR-640LA1 Manuale utente

Samsung

Samsung iES4028F Manuale di programmazione

Samsung

Samsung SmartThings Wifi ET-WV525 Manuale utente

Samsung

Samsung Ubigate iBG1003 Manuale utente

Samsung

Samsung 5G CPE Manuale utente

Samsung

Samsung Ubigate iBG1000 Manuale utente

Samsung

Samsung iES4028FP Manuale utente

Samsung

Samsung Ubigate iBG2006 Manuale utente

Samsung

Samsung DCS-Compact II Manuale utente

Samsung

Samsung Connect Home Pro ET-WV531 Manuale utente

Samsung

Samsung DIR-518L Manuale utente

Samsung

Samsung MWR-SH00N Manuale utente

Samsung

Samsung Ubigate iBG1000 Manuale utente

Samsung

Samsung Connect Home Pro ET-WV530 Manuale utente

Manuali Router di rete popolari di altre marche

Allnet

Allnet ALL0333AU Manuale utente

HomeSeer

HomeSeer HT-SEL Manuale utente

Sercomm

Sercomm Genesis OC3505D Manuale utente

Billion

Billion BIPAC 5102 Series Manuale utente

TP-Link

TP-Link TD-8817 Manuale utente

Motorola

Motorola MR1900 Manuale utente

Digi

Digi IX14 Manuale utente

Cisco

Cisco NCS 540 Manuale

XAVi

XAVi X8821e Manuale utente

BEC

BEC 6200WZL Manuale utente

MikroTik

MikroTik hAP ac3 Series Manuale utente

Korenix

Korenix JetNet 5428G Series Manuale utente

NETGEAR

NETGEAR FS526T - Switch Manuale utente

Korenix

Korenix JetNet 5710G Series Manuale utente

Automated Logic

Automated Logic ZN551 Manuale del proprietario

Cisco

Cisco ASR 1000 Series Manuale dell'operatore

EnGenius

EnGenius ESR-9710 Manuale utente

Cisco

Cisco 805 Series Istruzioni operative e di sicurezza