Samsung VR30T80 Series Manuale utente
Jet Bot
User manual
VR30T80**** Series
• For full manual, Scan QR code or access online at https://www.samsung.com
• Before operating this unit, please read the instructions carefully.
• For indoor use only.
2
04
01
07
02
06
05
03
04
08
09
04
03
02
01
06
08
05
09
04
07
03
01
02
Top
01
Obstacle Sensor
02
Power switch
03
LiDAR Sensor
04
Dustbin
05
Start/stop button
06
Docking (Recharging)
button
07
Status Indicator
08
Docking sensor window
09
Upper Cover
Bottom
01
Charging Pin
02
Brush
03
Brush Cover
04
Cliff Sensor
05
Roller
06
Battery Cover
07
Driving Wheel
08
Spin Brush
09
Brush Cover Lock
Docking Station
01
Charging Terminal
02
Charging Signal
Transmitter
03
Power cord groove
Docking Station Pre-motor Filter: 2units
(Inside the product: 1unit,
Spare: 1unit)
Spin Brush: 2units
(Inside the product: 1unit,
Spare: 1unit)
Battery Charger/
Power cord
Boundary Markers User Manual
Accessories may differ depending on the models.
• For the normal use of the Jet Bot’s functions,
the SmartThings connection is required.
3
1 2
0.5 m
(1.6 ft)
0.5 m
(1.6 ft)
1 m
(3.3 ft)
3
A
4
B-1
12
B-2
1 2
3
1
4
B
ONOFF
5
C
1 2
3 4
5 6
7 8
1
C-1
24H
6
C
C-2
1 2
3 4
C-3
7
C-5
C-4
2
1
C
English
English8
Operation and maintenance
A. Installation
NOTE
• Install the Docking Station in a place where
the floor and wall are level.
• If the Battery Charger cord is too long for
the installation environment, coil the power
cord around the cable management post,
then put it in the fixing groove at the rear
of the Docking Station.
• If you reinstall the Docking Station to a
new position of 45 degrees or 1 m (3.3 ft)
or more from the previous installed place,
recreate the map using the SmartThings
App. (If you use the existing map, some
places may not be cleaned.)
B. Using the Jet Bot
B-1 Charging the Jet Bot
Charging
• Open the upper cover of the Jet Bot and
remove the white gasket.
• Remove the yellow gasket attached to the
power switch at the side of the Jet Bot and
press the power switch to turn the Jet Bot
on.
• Place the Jet Bot on the Docking Station
manually to start charging.
- Make sure the charging terminals on
the Jet Bot and the Docking Station are
aligned.
• Check the charging status.
- When charging starts, the Status Indicator
of the Jet Bot turns on (red, orange, or
yellow depending on charging progress),
it rises gradually, and changes to green
when the charging is complete.
Docking (Recharging)
• You can return the Jet Bot to the Docking
Station while cleaning to recharge.
- Press the [ ] on the Jet Bot or use the
SmartThings App to select the recharging
function.
B-2 Starting cleaning
• Press the [ ] on the Jet Bot to start
cleaning in Auto Clean.
• Press the [ ] on the Jet Bot to stop
operation while cleaning.
- When pressing the [ ], the Jet Bot
returns to the Docking Station and starts
charging.
C. Cleaning the Jet Bot
Before maintenance work, you should turn off
the power switch at the side of the Jet Bot.
C-1 Emptying and cleaning the Dustbin
• Remove the dust on the filter and the
Dustbin, clean them with water, and dry
completely in the shade.
C-2 Cleaning the brush
C-3 Cleaning the Sensor Window
• Wipe the Sensor Window with a soft cloth.
C-4 Cleaning the Driving Wheel
C-5 Cleaning the Spin Brush
• If curl or deformation occurs, Cover the
Spin Brush with a hot steamed cloth for
10seconds, then wipe the Spin Brush.
• For detailed methods of use
and cleaning, refer to the QR
code.
English
English 9
Safety information
• Before operating the appliance, please read
this manual thoroughly and retain it for
your reference.
• Because the following operating instructions
cover various models, the characteristics
of your vacuum cleaner may differ slightly
from those described in this manual.
Caution/Warning symbols used
WARNING
Indicates that a danger of death or serious
injury exists.
CAUTION
Indicates that a risk of personal injury or
material damage exists.
Other symbols used
NOTE
Indicates that the following text contains
additional important information.
State of California Proposition 65 Warning
(US only)
WARNING
This product contains chemicals known to the
State of California to cause cancer and birth
defects or other reproductive harm.
L i - i o n
For battery recycling go to
call2recycle.org
or call 1-800-822-8837
Failure to meet these requirements could
cause damage to the internal parts of the
vacuum and void your warranty.
General
• Do not allow to be used as a toy. Close
attention is necessary when used by or near
children.
• Use only as described in this manual.
• Do not operate the Jet Bot or the Docking
Station if it has been damaged in any way.
• If the vacuum cleaner is not working as it
should, has been dropped, damaged, left
outdoors, or dropped in water, return it to a
customer care center.
• Do not handle the Docking Station or the
Jet Bot if your hands are wet.
• Use only on dry, indoor surfaces.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should not clean or perform
maintenance on the vacuum without adult
supervision.
• Move the cords of other appliances so they
are not in the area that is to be cleaned.
• Do not operate the vacuum in a room where
an infant or child is sleeping.
• Do not operate the vacuum in an area
where there are lit candles or fragile objects
on the floor.
• Do not operate the vacuum in a room that
has lit candles on furniture that the vacuum
may accidentally hit or bump into.
• Do not allow children to sit on the vacuum.
• Do not use the vacuum on a wet surface.
• If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in
order to avoid a hazard.
Docking Station
• Do not modify the polarized plug to fit a
non-polarized outlet or extension cord.
• Do not use outdoors or on wet surfaces.
• Unplug the Docking Station from the outlet
when not in use and before servicing.
• Use only the Docking Station supplied by
the manufacturer to recharge.
English
English10
• Do not use with a damaged cord or a plug
or a loose power outlet.
• Do not pull or carry by the cord, use the
cord as a handle, close the door on the
cord, or pull the cord around sharp edges
or corners. Keep the cord away from heated
surfaces.
• Do not use extension cords or outlets with
inadequate current carrying capacity.
• Do not unplug by pulling on the cord. To
unplug, grasp the plug, not the cord.
• Do not mutilate or incinerate batteries as
they will explode at high temperatures.
• Do not attempt to open the Docking Station.
Repairs should only be carried out by a
qualified customer care center.
• Do not expose the Docking Station to high
temperatures or allow moisture or humidity
of any kind to come into contact with the
Docking Station.
• Do not charge the non-rechargeable
batteries with the Docking Station.
Jet Bot
• Do not pick up hard or sharp objects such
as glass, nails, screws, coins, and etc.
• Do not use without a filter in place. When
servicing the unit, never put fingers or
other objects into the fan chamber in case
the unit accidentally turns on.
• Do not put any objects into openings.
Do not use with any openings blocked;
keep openings free of dust, lint, hair, and
anything that may reduce air flow.
• Do not pick up toxic materials (chlorine
bleach, ammonia, drain cleaner, etc.).
• Do not pick up anything that is burning or
smoking, such as cigarettes, matches, or hot
ashes.
• Do not use to pick up flammable or
combustible liquids such as gasoline or use
in areas where they may be present.
• Also do not use in:
- Locations with candles or desk lamps on
the floor.
- Locations with unattended fires (fire or
embers).
- Locations with distilled alcohol, thinner,
ashtrays with burning cigarettes, etc.
• Do not use the Jet Bot in an enclosed
space filled with vapors given off by oil
based paint, paint thinner, moth proofing
substances, flammable dust, or other
explosive or toxic vapors.
• Leaks from battery cells can occur under
extreme usage or temperature conditions.
If the liquid gets on the skin, wash quickly
with water. If the liquid gets into the eyes,
flush them immediately with clean water
for a minimum of 10 minutes. Seek medical
attention.
Power related
WARNING
• Please prevent any risk of electric shock or
fire.
- Do not damage the power cord.
- Do not pull the power cord too hard or
touch the power plug with wet hands.
- Do not use a power source other than
100-240 V~and also do not use a multi-
outlet to supply power to a number of
devices at the same time. (Do not leave
the cord carelessly on the floor.)
- Do not use a damaged power plug, a
power cord or a loose power outlet.
• Clean dust or any foreign matter on the pin
and the contact part of the power plug.
- There is a risk of electric shock or
malfunction.
Safety information
Altri manuali per VR30T80 Series
1
Questo manuale è adatto per i seguenti modelli
1
Indice
Lingue:
