Samsung SCC-C7478 Manuale utente

SCC/SNC-C7478 Installation Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

SCC/SNC-C7478

Installation Guide

36x PTZ Dome Camera

Connection for power

RJ-45 Connection

7. Pull retractable safety cable

from bottom of camera and

insert into hook, inside upper

housing.

(figure 7a)

1. Remove junction box cover with supplied hex tool to view inner connection block.

(figure 1a)

Inner connection block exposes connections for power, video, alarm input/output as well

as dip switches for selecting camera ID, protocol, baud rate and termination.

(figure 1b)

See

manual for proper settings.

2. Attach wall mount to wall with supplied anchor bolts and make connections.

Inner Box connections

*Note for RS-485 Connection:

GVI uses solid colored wire to represent posi-

tive (+) and striped wire for negative(-) polar-

ity. Regardless of the wire color you choose

make sure polarity matches on oth ends of

the connection

Cable connection for dome. Connect

cable from mount into upper housing

Inside view of upper housing

3. Remove camera mechanism from upper housing.

(figure 3a)

4. Use Teflon tape (included) to wrap around pipe fitting.

(figure 4a)

5. Attach safety cable to neck of mount.

(figure 5a)

6. Attach other end of safety cable to housing

(figure 6a)

and now screw in upper

housing to mount pole, bring in cable from pole mount and attach.

(figure 6b)

afety cable to mount

Teflon tape for tight connection

afety cable to housing

Retractable safety cable

SCC/SNC-C7478 Installation Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

9. Attach fan and heater cables inside upper housing and attach dome cover safety

cable.

(figure 9a)

10. Return PTZ camera mechanism into upper housing by pressing the

two black handles until camera mechanism snaps into

place.

(figure 10a)

11. Close the dome cover by matching the arrow markers. Be sure internal

cabling does not obstruct camera’s movement.

12. Orientation of housing my be adjusted by rotating the ring on which the

safety cable is attached.

(figure 12a)

Completed mounted camera

Fan/heater cable

afety Cable

10a

12a

Remove plastic covering carefully and power dome with 24 VAC 2.5 amps

SCC/SNC-C7478 Installation Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

SNC-C7478 Setup Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

IP Setup Guide

36x PTZ IP Dome Camera

SNC-C7478

1. Plug the included cross-over cable into the RJ-45 jack located inside the

inner connection block.

(figure 1a)

2. Plug the other end of the cross-over cable into the RJ-45 jack on back of

your computer.

(figure 2a)

3. From included CD, run the application titled IPInstaller. This will open a

window and scan your computer to locate the default IP address and subnet

mask assigned to the IP dome.

(figure 3a)

4. Once camera has been identified within the window, you may view the default IP settings by first selecting

(clicking) the camera entry in the window, then choosing Manual Set in the lower right of the IPInstaller

window. Make note of the camera IP Address and the Subnet

Mask. You will refer to these in future steps.

(figure 4a)

After

these values have been viewed and written down, you may can-

cel from the Manual Setting window and you may exit the

IPInstaller.

5. Next you will need to set your computer with a static IP address

as well as set your Subnet Mask to the same value as the IP PTZ

Dome Camera. (Subnet Mask value from previous step)

6. From your computer’s Control Panel go to Network and Internet Connections. Enter Network Connections

so that you are able to view all available Network Connections. Your screen should look similar to the

figure below.

(figure 6a)

SNC-C7478 Setup Guide

SAMSUNG | GVI Security, Inc

Phone: 972-245-7353 • Toll Free: 888-595-2288 • Fax: 972-245-7333

www.samsung-security.com

v.11.19.08

7. Double click on Local Area Connection to bring up the Local Area Connection Status

box.

(figure 7a)

Click Properties in the lower left corner to display Local Area Connection

Properties.

8. From the Local Area Connection Properties window, double click

Internet Protocol (TCP/IP) to display Internet Protocol (TCP/IP)

Properties.

(figure 8a)

9. Choose the option for Use the Following IP Address and type an

IP address that begins with 192.168.1. but use a number other

than the ending number assigned to the camera. (number must fall

between 1 and 255)

(figure 9a)

10. Type the subnet mask, this number must be the same as the

camera’s subnet mask, then choose OK at the bottom of the Inter-

net Protocol (TCP/IP) Properties box.

11. You may now close out of the Network Connections window.

12. After the above steps have been completed you may now use Microsoft’s Internet Explorer to enter the

camera’s setup menu.

13. Open an Internet Explorer window. In the address bar at the top of the window type HTTP:// followed by

the IP address assigned to your camera. (This value was obtained in step 4)

(figure 13a)

14. See users manual for full explanation of menus and

settings.

15. Once you have finished with camera setup and have

exited from browser, be sure to go back into your

network settings and return all of your settings to

normal.

Accessing the Camera Menu from Internet Explorer

13a

Altri manuali per SCC-C7478

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Samsung Telecamera di sicurezza

Samsung

Samsung iPolis SNP-6200RH Manuale utente

Samsung

Samsung HCD-E6070R Manuale utente

Samsung

Samsung SCC-C9302 Manuale utente

Samsung

Samsung SCC-B5203 Manuale

Samsung

Samsung SCC-641 - 22x Zoom Smart Dome Camera Manuale utente

Samsung

Samsung SCP-3370TH Manuale utente

Samsung

Samsung SID-500 Manuale utente

Samsung

Samsung iPolis SNP-5200H Manuale utente

Samsung

Samsung SND-5080 Manuale utente

Samsung

Samsung SIR-4260V Manuale utente

Samsung

Samsung SCV-2080R Series Manuale utente

Samsung

Samsung SCZ-2430 Manuale utente

Samsung

Samsung SDC-313A Series Manuale utente

Samsung

Samsung SCC-B9372 Manuale utente

Samsung

Samsung SNH-V6430BNH Manuale utente

Samsung

Samsung SNB-2000P Manuale utente

Samsung

Samsung iPolis SNP-5200 Manuale utente

Samsung

Samsung SPU-3750T Manuale utente

Samsung

Samsung SNO-7082R Manuale utente

Samsung

Samsung SCP-2120 Manuale utente

Samsung

Samsung SNP-6201 Manuale utente

Samsung

Samsung SCC-B2303(P) Manuale utente

Samsung

Samsung SCC-B5223 Manuale utente

Samsung

Samsung SCP-3430H Manuale utente

Manuali Telecamera di sicurezza popolari di altre marche

Okina USA

Okina USA SIR36-870VF650LP Manuale utente

Divio

Divio NDR155PA Manuale utente

Canon

Canon VB-C500D Manuale utente

Easy Access

Easy Access EasyGuard Manuale utente

Vivotek

Vivotek FD9389-EHV-v2 Manuale utente

TUYA

TUYA COSMO W2 Manuale utente

Eusso

Eusso UNC7500-IR Guida all'installazione

urmet domus

urmet domus 1096/204 Manuale utente

VC VC20 series Manuale utente

Axis

Axis Q1614 Manuale utente

ieGeek

ieGeek DD201 Manuale utente

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuale utente

Vicon

Vicon V662-D-1 Istruzioni operative

Grundig

Grundig GCH-K0274P Manuale utente

Lorex

Lorex VANTAGE LBC7032 Manuale utente

4xem

4xem WPT Manuale utente

Vitek

Vitek VTC-C544 Manuale utente

Lumens

Lumens VC-A50PNW Manuale utente