Sangean UCR-100 Manuale utente

381R901-A

UCR-100

Operating instruction

Mode d’emploi

Instruccions de manejo

Gebruiksaanwijzing

Bedienungsanleitung

FMDIGITALTUNINGUNDER

CABINET CLOCK RADIO

RADIO-REVEILFMNUMERIQUE

DEDESSOUSD’ELEMENT

RADIO-RELOJ CON

SINTONIZACIÓNDIGITALDEFM

DIGITALE WEKKER MET

DIGITALEFMTUNING

(VOORBEVESTIGING

ONDER KASTPLANK)

UKW-UNTERBAURADIO

MIT WECKER

Important safety instructions

1. Read and understand all safety and operating instructions before

the radio is operated.

2. Retain instruction: The safety and operating instructions should

be retained for future reference.

3. Heed warnings.All warnings on the appliance and operating

instructions should be followed.

4. Follow all operations and use instructions.

5. Water and moisture: The appliance should not be used near

water. Do not use near a bathtub, washbowl, laundry tub,

kitchen sink, wet basement, swimming pool, etc.

6. Unplug the radio from theAC power outlet before cleaning.

Use only a damp cloth for cleaning the exterior of the radio.

Clean the radio only with dry cloth.

7. Do not place the radio on an unstable cart, stand, bracket or

table. The radio may fall, causing serious personal injury and

damage to the radio.

8. Ventilation: This radio should be situated so that its

location or position does not interfere with its proper ventilation.

For example, the radio should not be used on a bed, sofa, rug or

other soft surfaces that may block the ventilation openings.

It should not be placed in a built-in situation like a cabinet that

may reduce air flow through the ventilation openings.

9.Don’t install near any heat sources such as radiators,

heat registers, stoves, or other apparatus (include amplifiers)

that produce heat.

10. Don’t install defeat the safety purpose of the polarized or

grounding-type plug. A polarized plug has two blades with one

wider than the other. A grounding-type plug has two blades and

a third grounding prong. The wide blade or the third prong are

provided for your safety. If the provided plug doesn’t fit into

your outlet, consult an electrician for replacement of the

obsolete outlet.

11. Power sources: The radio should be operated only from the

type of power source indicated on the marking label. If you are

not sure of the type of power supply to your home,

consult your radio dealer or power company.

12. Power cords: The power cord should be positioned so it is not

walked on, pinched, or items placed on top of it. Pay particular

attention to cords at plugs, convenience receptacles, and the

point where they exit from the unit. Unplug the power cord by

gripping the power plug, not the cord. Operate the radio using

only the current type of power source indicated. If you are not

sure of the type of power supply to your home, consult your

dealer or local power company.

13. Do not overload wall outlets or extension cords. This can result

in a risk of fire or electrical shock. Never insert objects of any

kind into the radio through opening. The objects may touch

dangerous voltage points or short out parts. This could cause

a fire or electrical shock.

14. Only use attachment/accessories specified by the manufacture.

15. If the radio is left attended and unused for long periods of time,

unplug it form the wall outlet. This will prevent damage caused

by lightning or power line surges.

16. If the radio is left unattended and unused for a long period

of time, remove the batteries. The batteries may leak and

damage furniture of your radio.

17. Do not attempt to service the receiver yourself. Removing the

cover may expose you to dangerous voltage, and will void the

warranty. Refer all servicing to authorized service personnel.

18. Object and Liquid Entry-Never push objects of any kind into this

radio through opening as they may touch dangerous voltage

points or short-out parts that could result in a fire or electric

shock. Never spill liquid of any kind of product.

19. The appliance should be serviced by qualified service

personnel when:

The power supply cord or the plug has been damaged.

Objects have fallen or liquid had been spilled into the radio.

The radio has been exposed to rain or water.

The radio does not appear to operate normally or exhibits a

marked change in performance.

The radio has been dropped, or the enclosure damaged.

Installing the appliance

Your clock radio is designed for substructure-installment under

shelves, kitchen cupboards etc. The speaker must point

downwards and be unobstructed to offer the best possible sound

quality. Please don’t install this appliance close to stove or other

cooking appliance so that is not subjected to damaging steam.

The clock radio is to be mounted in the desired position with the

bracket , on the appliance. To simplify the installment,

the bracket can be removed from the appliance by loosening the

two knurled screws and from the appliance. We recommend

using the following helpful trick for the installment, to enable the

mounting of the bracket without having to measure:

1. Stick a piece of industrial strength adhesive tape on the left and

right sides of the bracket.

2. Press the appliance against the surface where it is to

be installed.

3. Without letting go of the appliance, remove the two holding

screws and and remove the radio carefully from the

bracket .

4. Now you can screw on the bracket with the four screws.

5. Slide the radio onto the bracket and tighten the knurled

screwdriver to tighten screw and .

6. Completely unwind the short-wave cable antenna.

Fasten the antenna onto the underside of the cupboard or

shelf with a reliable adhesive tape.

Installment material (with delivery):

4 short screws

4 long screws

4 spacers

Control Keys

Tuning Up and Down

Clock Set

Radio Alarm

Buzzer Alarm

Timer

Power

Volume Up andDown

AUX IN

TimeAuto Setting switch

Presets

F-type FM antenna connector

Power jack

LCD display

Clock set

Hour and minute digits

Preset memory

Alarm time

Timer

Buzzer alarm

Radio alarm

Time Auto Setting

Auto Off

Operation

Time Manual Setting (if there is no automatic setting)

1. After the radio is plugged in the power, the display shows ‘ -:—‘

2. Touch the key and hold for 2 seconds, and the display

flashes the hour digits.

3. Touch the and keys to adjust the hour.

4. Touch the key and the display flashes the minute digits.

5. Touch the and keys to adjust the minute.

6. Touch the key again to complete the time setting.

Time Auto Setting

When the radio is off, touch and hold the key for 2 seconds.

The display will flash . And the clock will be set automatically.

When the clock is not corrected by Time Auto Setting yet,

the radio will operate theAuto Time Setting function for

15 minutes in every hour.

When the clock is corrected by Time Auto Setting already,

the radio will operate theAuto Time Setting function for

6 minutes in every hour.

When the Time Auto Setting signal is not good enough, open the

DCF/AUX IN cover to switch 1 to 2, or 2 to 1. This switch

controls the direction of TimeAuto Setting receiving.

Alarm Operation

There are 2 ways of alarm, which are Buzzer alarm and Radio

alarm. The initial Buzzer alarm time is 7:00. The initial Radio alarm

time is 6:00.

Alarm setting:

1. Touch the key (or ), to check the Buzzer alarm time

(or Radio alarm time). The display will show back the present

time after 7 seconds. Or you can touch the same key to go

back to the present time.

2. While the display is showing the alarm time (after the key or

is touched), touch the key for 2 seconds to enter

the alarm time adjustment.

3. Now the hour digits are flashing. Touch the key and

to adjust the hour.

4. Touch the key then the minute digits are flashing.

Touch the key and to adjust the minute.

5. If you are setting the Buzzer alarm, press the key to

complete the setting. If you are setting the Radio alarm,

touch the set key, adjust the alarm radio frequency by touching

the TUNINGUP/DOWN keys, then press the key to

complete the setting.

* When the radio station signal is too weak when the Radio alarm

is activated, the alarm will become Buzzer alarm.

Indice

Altri manuali Sangean Radiosveglia

Sangean

Sangean Sangean RCR-5 Manuale utente

Sangean

Sangean RCR-1 Manuale utente

Sangean

Sangean PS-300 Manuale utente

Sangean

Sangean RCR-22 Manuale utente

Sangean

Sangean RCR-2 Manuale utente

Sangean

Sangean RS-332 Manuale utente

Sangean

Sangean RS-330 Manuale utente

Sangean

Sangean RS-332 Manuale utente

Sangean

Sangean RCR-30 Manuale utente

Sangean

Sangean RCR-40 Manuale utente

Sangean

Sangean RCR-22 Manuale utente

Sangean

Sangean Sangean- RCR-3 Manuale utente

Sangean

Sangean RCR-29 Manuale utente

Sangean

Sangean RCR-10 Manuale utente

Sangean

Sangean RCR-8WF Manuale utente

Sangean

Sangean RCR-40 Manuale utente

Sangean

Sangean CR-220DFM Manuale utente

Sangean

Sangean RS-330 Manuale utente

Sangean

Sangean RCR-8WF Manuale utente

Sangean

Sangean RCR-11 WF Manuale utente

Sangean

Sangean RCR-8WF Manuale utente

Sangean

Sangean RS-330 Manuale utente

Sangean

Sangean RCR-22 Manuale utente

Sangean

Sangean RCR-10 Manuale utente

Manuali Radiosveglia popolari di altre marche

Denver

Denver CRQ-105 Manuale utente

Audiovox

Audiovox CE90 Manuale utente

Sony

Sony Dream Machine ICF-C763L Manuale utente

Sanyo

Sanyo DMP-P6 Manuale utente

RCA

RCA RPC100 Manuale utente

Yamaha

Yamaha ISX-80 Manuale utente

Pyle

Pyle PLMR20W Manuale utente

Blaupunkt

Blaupunkt CR7BK Manuale utente

Philips

Philips AJ3180 Manuale utente

HoMedics

HoMedics SS-5500-2EU Manuale utente

RCA

RCA RC66i Manuale utente

Versaudio

Versaudio Vers Manuale utente

SOUNDMASTER

SOUNDMASTER UR8100 Manuale utente

Audiovox

Audiovox CE90 Manuale utente

Jensen Audio

Jensen Audio JCR-222 - AM/FM Projection Alarm Clock Radio Manuale utente

Roberts

Roberts ChronoDAB Manuale utente

AEG

AEG MRC 4132 BT Manuale utente

Tokai

Tokai TC-155 Manuale utente