SB SB-SP7200-GSM Manuale utente
INSTRUCTION MANUAL
Revised: August 28, 2014
All-In-One GSM Home Alarm System
SB-SP7200-GSM
Page 2
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
PRODUCT REFERENCE
REMOTE
CONROL
USB CABLE
(2) DOOR /
WINDOW
UNITS
MOUNTING
ACCESSORIES
MOUNTING
ACCESSORIES
PIR / MOTION
DETECTION
UNIT
MAIN UNIT POWER
ADAPTER
Page 3
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
PRODUCT REFERENCE
CAMERA LENS
IR LIGHTS
STATUS LIGHT
MOTION
SENSOR
LIVE LISTENING
MICROPHONE SIREN SPEAKER
SLOW BLINK Device is searching for cellular signal
FLASHES 3 TIMES EVERY
2.5 SECONDS
Connected to cellular signal
LED FLASHES QUICKLY During setup of sensors, unit has connected successfully
STATUS LIGHT
e status light will also blink in other ways depending on the mode you are in. ese three
status blinks are the most important.
SOLAR PANEL
Your alarm system will automatically switch to IR “Night-Vision” when necessary.
Page 4
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
PRODUCT REFERENCE
MICRO SD CARD
SLOT
SIM CARD SLOT
LEARN BUTTON
BACK OF
MAIN UNIT
(BACK COVER
REMOVED)
BOTTOM OF
MAIN UNIT
(BACK COVER
REMOVED)
ON/OFF
SWITCH
CHARGING STATUS
RED - CHARGING
GREEN / OFF - CHARGED
ADAPTER
CONNECTION
Page 5
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
Your GSM Alarm System uses text messages to communicate with you. is requires sending
the unit particular codes. We have put together a list of codes at the end of this manual, but for
now, please follow the instructions in order so that you may best understand how the system
works.
REQUIREMENTS:
You should have the following for proper operation of your GSM Alarm System.
1) Your GSM Alarm System, with the Main Unit, Remote Control, Sensors, a Power Adapter,
USB Cable and mounting accessories.
2) A micro SD Card, up to 32GB. You can order a compatible card from SafetyBasement.com.
Should you already have an SD card, please be sure it has been erased.
3) A cellular SIM card. A compatible card is available from SafetyBasement.com. Please check
with SafetyBasement for SIM card requirement before using another card. ANY SIM card will
require a monthly fee.
4) A small Phillips head screwdriver.
5) 3 AAA batteries for wireless PIR unit.
INTRODUCTION
Page 6
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
INSTALL THE SD CARD
Slide LEFT to UNLOCK
1. Use your Phillips head screwdriver to remove the screw from the
bottom of the main unit.
2. Remove the back of the main unit.
3. With a ngernail, carefully push the silver SD Card slot lock to the
LEFT. It will click into the OPEN position.
4. Raise the silver lock to expose the SD card connection.
5. Place the SD card in the slot as shown, with the gold connectors
down.
6. Lower the silver lock and slide to the RIGHT to lock the SD in
place. It will click into the LOCKED position.
Slide RIGHT to LOCK
Page 7
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
INSTALL THE SIM CARD
Slide UP to
UNLOCK
1. Use your ngernail to slide the lock gate UP. It will click into place
when UNLOCKED.
2. Raise the lock gate.
3. Insert your SIM Card into the lock gate as shown, with the gold
connector facing you, and towards the bottom. e slanted part of
the SIM Card will be on the UPPER RIGHT.
4. Close the lock gate.
5. Slide the lock gate DOWN to lock your SIM Card in place.
6. Do not replace the back of the unit yet...
Slide DOWN to
LOCK
Page 8
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
POWER & CELLULAR SIGNAL
Insert the power adapter plug into the Main Unit.
e Charging Light should be RED. It will remain red for some
time until the backup battery is fully charged.
Turn the Main Unit ON.
Look at the Status Light under the Camera Lense.
Shortly, the Status Light will blink 3 times, every 2.5 seconds.
is means that the Main Unit has found a cellular signal and is
working properly.
If the status light does not blink like this within 2 minutes,
turn o the unit and check the installation of your SD and SIM
Cards.
Try again. If the unit does not blink 3 times, every 2.5 seconds,
try moving the unit to an area where there may be a better
signal.
Try moving on to the next step of this setup to see if you are
connected.
If you are unable to connect, you should check to make
sure your SIM Card has been properly activated. Contact
SafetyBasement or your cellular provider.
STATUS LIGHT
Page 9
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
Your SIM Card has a phone number. You will need this phone number to text or call your GSM
Alarm System. Please write this number down. When using the phone number, you will enter
an 11 digit number, such as 12345551234. at’s 1, followed by your Area Code, then phone
number with NO spaces.
CHECK THE TIME
DEFAULT PASSWORD IS
258000
We will be using standard text messages to communicate with the GSM Alarm system. Use your
standard text app as you would when texting anyone. TIP! Once you know how to work your
GSM Alarm System, use your text app and keyboard shortcuts to making talking to your system
as easy as possible. Refer to your phone and text app instructions for shortcuts.
A list of codes is at the end of this manual.
ALARM NUMBER IS
MY PASSWORD IS
258000#200# Send this text to the phone
number of your SIM card.
>>System time: 16:47 Your alarm should reply within
a few seconds with the system
time. e time is always on a
24 hour clock / military time.
If the system is not responding,
check the format of your text.
Make sure you are sending to
the complete phone number,
11 digits, no spaces.
Your text should also have NO
spaces.
Page 10
All-In-One GSM Home Alarm & Video System Product Manual : SB-SP7200-GSM
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
SET THE TIME
258000#03*1700# Send this text to the phone
number of your SIM card. In
this example, we are setting the
clock to 5pm, 1700.
>>Ok, setting successfully
If you enter the wrong
password, the system will not
respond as a security feature.
If you enter the correct
password, but something is
wrong with the format of your
command, the system will tell
you.
We may need to set the time of day. Remember, the alarm uses a 24 hour clock, military time.
>>Format error, please
input the right command!
SET THE LANGUAGE
258000#00*0# Send this text to the phone
number of your SIM card. In
this example, we are setting the
language to English.
>>Ok, setting successfully
is system can respond in English or Chinese. Choose 00*0 for English. 00*1 for Chinese.
Indice
Manuali Sistema di sicurezza popolari di altre marche
EDM
EDM Solution 6+6 Wireless-AE Manuale utente
Highway Safety Group
Highway Safety Group EA401 Manuale utente
Siren
Siren LED GSM Manuale utente
Detection Systems
Detection Systems 7090i Istruzioni per il montaggio
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manuale utente
Siemens
Siemens FDM273 Manuale utente