Page 5
BEFORE INSTALLATION
We recommend this appliance be installed
Appliances technician.
Please see our website www.
schweigen.com.au for a list of our
recommended installers.
It is dangerous to modify any part of this
immediately void the warranty.
The manufacturer declines all
responsibility in case of failure to adopt
proper safety measures.
Ensure that the location in which this
appliance is installed, has good and
permanent ventilation.
Please consult local laws and regulations
and install in accordance.
Please use an earthed electrical connector
that coincides with relevant local laws and
regulations.
Check that the power voltage in your area
corresponds to the appliance voltage
indicated on the rating label.
This appliance must be connected to an
electrical supply that has a grounded
connection.
Check that the indicated instructions and
local regulations are met and carried out
that are complaint with the applicable
legislation.
Schweigen will not be responsible for any
technicians that fail to heed the applicable
legislation on electrical safety.
The electrical technical data can be found
inside the rangehood, after removing the
already connected internally and emerges
from the rangehood near the air outlet
tube.
Before installing the electrical
connections, you should:
• Verify that the indicated electrical data
coincides with the voltage values and
frequency of the electrical circuit in the
house where the rangehood is to be
installed.
• Check that the premises has electrical
protection against short circuits and
electrocution.
•
the double-pole switch (mains power
switch). The power can only be turned
on for normal use, once the operation
has been completed.
• Ensure the supply cord is not exposed
to heat, chemicals or sharp objects. If
the supply cord is damaged, it must be
replaced by the manufacturer, service
order to avoid a hazard.
