SDG S007 Manuale utente
Smart Wifi Robotic cleaner with HD camera
S007
User Manual
Table of contents:
1.Safety instruction
2.Components of cleaner
3.Charging base
4.Operation instruction
5.Cleaning modes
1.1 About the instruction manual
1.2 About power supply
2.1 Parts name
2.2 Power rated
1.3 Suitable usage
1.4 Attention before use
1.5 Attention for children
1.6 About rechargeable battery and disposal
1.7 About package
1.8 Technical support
4.1 Display screen and control panel
4.2 Switch on the unit
4.3 Stop the unit
5.1 Auto mode
5.2 Spot mode
5.3 Mopping
6.Maintenance
7.Failure checking
8.Trouble shooting
6.1 Cleaning the dust box and filter
6.2 Cleaning the infrared receiver and charging connector
6.3 Cleaning the side brushes or replacement
6.4 Cleaning the fabric brush
4.4 Sleep mode
4.5 Pre-set timer
4.6 Full-go
6.5 Assembly the trailing bar and mop pad
1.Safety instruction
CAUTiON
Do not use the cleaner on small table and chair
or other small space without protection railings,
or use it hung in the air, the unit may damage.
1.1 About the instruction manual
Read the instruction carefully before use:
Read the instruction carefully, and following the step to operate the unit.
Keep this instruction manual for further reference.
If you transfer the unit to other people, send it with instruction manual.
Do not operate the unit that not mentioned in this instruction manual.
1.2 About power supply
Please use the original parts and battery, otherwise the unit may be damaged.Stop using
the unit, If the AC-DC adaptor and cord was damaged. Contact the service center for repair
or replace.
Do not pull the power cord to moving the unit or charging base.
Do not use the wet hand to touch or operate the unit and plug.
And do not place the electrical cord under a cover. Do not overlay the cord with little
covers or such element. Place the cord in an area where there are not any risk to
stumble over it.
Disconnect the charging base or unit when not in use.
1
Keep the connection jack clean and dry to avoid bad contact of the power supply.
2
Do not use in outdoor, commercial and industrial area.
Do not use it in cold and extremely hot area (over 50đ).
Do not use the cleaner to clean huge amount of dust, shape objects, such as glass, nail,
etc. it may damage the unit and the warranty will be voided.
Do not approach cigarette, lighter, match and other heat objects or combustible materials
such as gasoline cleaner, it may cause explosion.
Do not use it hung in the air or in stairs, the unit may falling down and cause damage
and injured.
Do not use in wet floor and wet area, such as toilet, or cleaning any liquors.
1.3 Suitable usage
Not suitable areaφ
Suitable use areaφ
The unit just suitable to use indoor. And it can cleaning the wooden floor, compound
floor, plastic floor, ceramic floor, marble floor, carpet (within 15mm), etc..
Wooden
Carpet (within 15mm)
Ceramic
Marble
3
1.4 Attention before use
1.5 Attention for children
Remove all easy damaged objects (including luminous objects, fabrics, glass bottles, etc.)
before using, it may cause damage to these objects or affecting the using of cleaner.
Check the fabric brush and dust box is assembly well.
Check the ground detection sensors are clean.
If just clean the bedroom, close the door.
If need to clean the bottom side of the sofa, bed, but the cleaner cannot get in, pad the
sofa or bed before use.
Inform the family members that the cleaner is working, and beware it to avoid damage
and injured.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
Storage the cleaner well and far away from children.
Children should be supervised to ensure that they do not play with the appliance.
Unit protected by plastic bag, and plastic bags can be dangerous. To avoid danger of
suffocation, keep this bag away from babies and children.
To ensure the cleaner operating smoothly, please follow:
--- Remove the easy damage objects to a safety area.
--- Beware of the tablecloth and window curtains, make sure it above the floor.
--- Beware of the edge of the carpet has no wind around it.
--- Remove all cigarette, lighter etc. before use the cleaner.
--- Clean and storage well the power cord and removable objects before use.
--- Remove the new paper, books and large rubbish before use.
4
1.6 About rechargeable battery and disposal
1.7 About packing
Use the original battery only, wrong use of other battery
will cause explosion, if you need to replace the battery
please contact your local dealer.
It is dangerous to use the imitative battery or accessories,
and the warranty will void if you do so.
Don't put the packaging material products as household
garbage discarded.
Please put the packaging material to the recycling point
properly so as to be able to once again make use of these
resources.
The battery should be recycled with safe disposal. Please
don’t discard it freely or throw it into fire for fear of explosion!
1.8 Technical support
No one else can disassemble, maintain or transform the
product except our service center, it may cause fire, electric
shock or personal injury.
Please contact our service center for product support and
maintenance service.
Attention:
Take out the battery inside the remote if not in
use for long time. If the battery has leakage, be
careful and avoid the liquid to skin or cloths, use
dry mop to clean if touched and drop the battery
to recycle bin.
AUTO SPOT
MOPCHARGE
CLOCK TIMER
5
2.Components of cleaner
2.1 Parts name
Touch control
switch
Dust box button
Infrared signal
receiver
Sensor window
LED display
Front wheel Ground detection sensor
Right side
cleaning brush Left side cleaning brush
Battery cover
Left wheel
Fabric brush
Dust box
Power switch
Charging electrode
Right wheel
Trailing bar
1. On/off switch (cancel key)
2. Powerful cleaning / Sun
3. Turn left button
4. Forward button / Mon
5. Turn right button
6. Backward button / Tues
7. Full-Go, auto cleaning after fully charged
Open/Close voice.
8.Spot cleaning mode / Thur
9.Auto cleaning mode / Wed
10. Mopping mode / Sat
11. Auto recharge button / Fri
12. Timer setting
13. Clock setting (current time setting)
Infrared signal receiver
Power indicator
Docking hole
Connection indicator
Infrared signal emitter
Charging electrode
Charging station
Remote control
POWERFUL
1 Million pixels camera Reset button
LED display
MIC Input
VOICE
FULL-GO
6
2.2 Power rated
3.1 Position the charging base
3.2 Two charging methods
Specification
Rating
Voltage of the unit (V)
Power rated of the unit (W)
Adaptor output (V)
Adaptor output (mA) 1000mA
24W
DC 19V
DC 14.8V
Note: Suitable storage temperature from -20đto 50đ
*
We reserve the right to change the product specification without notice.
3. Charging base
Install the charging station on the flat ground firmly and against
the vertical wall (fixed on the wall with the charging station sticker).
Ensure no obstacle or hollow areas 3m away from the charging
station in front and 1.5m on right and left.
Connect the AC-DC adaptor with the charging hole on unit
Control the unit return to the charging station under stand-by
or working mode. (press the auto recharge button on remote
or unit.)
7
3.4 Auto recharge
4.1 Display screen and control panel
Display screen
4.Operation instruction
Attention:
Please keep the charging station well connected
with power socket, otherwise, the cleaner cannot
find charging station to perform auto recharge.
* Switch off the power switch on unit when not in use, and
disconnect with the charging.
Error symbol Full-go symbol
Battery symbol
Current time display
Powerful cleaning
Voice display
WiFi signal
Timer symbol
Connected the charging station, the cleaner will auto return to
charging station when power low.
Pls be noted the signal range of the charging station is 7M, at
an angle of about 35 degrees. If beyond the range, robot will
go to search the signal along the wall till power off.
8
4.2 Switch on unit
4.3 Stop
Turn on the power switch on the bottom of the unit, LED display flashing, and now under
stand-by mode.
Ordering the unit by control panel or remote control.
Press any key on the control panel to stop working
Stop means to stop the current working mode or change working mode.
Attention:
If the unit is under sleep mode, press any key to
weak up the unit first, and then select the cleaning mode.
Attention:
After the unit is stopped, and change to other
working mode.
Control panel
Auto recharge
Auto cleaning
Mopping
1. Press auto recharge the unit will auto return to the connected charging base.
2. Press auto cleaning the unit will perform auto cleaning until power low.
3. Press mopping and use with trailing bap and mop pad, the unit will perform mopping.
Note: under auto recharge, auto cleaning, mopping operating mode, press any key to
stop working.
4.4 Sleep mode
The unit is stop working and under sleep mode to save the energy, the display screen off.
If the unit is idle for 1 minutes, the unit will switch to sleep mode automatically.
Press the on/off switch on remote control, the unit will switch to sleep mode, and press
any key to weak up the unit.
Attention:
Turn off the unit by switch off the power switch
when not in use for long time.
Indice
