
RF PRO ASSEMBLY MANUAL
sE Electronics RF Pro Assembly + Use
Thank you for purchasing an sE Electronics RF Pro! We hope it helps make
your tracks sound great - no matter WHERE you’re recording.
STEP ONE
The rst step is to attach
the hardware to the stand,
which is done by loosening
the metal clamps (a), tting
the stand between them,
and tightening the key (b)
for a secure t.
If your stand’s diameter is
very large or very small, you
may have to adjust the large
threaded nut (c) opposite the
turning key to t.
STEP TWO
Next, attach the support
rod (d) to the lter by
screwing it into the socket
on the bottom edge (e).
Tighten the nut using the
wrench supplied in the box.
a
b
c
d
e