Seada DS2 Manuale di istruzioni
DS2 Quick Start Manual
SD-MA-030 V01
Note
1. Do not fix the device to any surface which is a heat source to avoid over heating
2. Do not cover the surface or ventilation grills of the device to avoid over heating
1. Verify the package contents
Please verify the package contents against the List Below
2. Set Up the DS2:
Power up the DS2 controller and connect the input and outputs to correct devices.
DS2
❶ ❷ ❸ ❹ ❺ ❻❼ ❽ ❾
1 –Power Switch 4 –HDMI Input 7 –Ethernet RJ45 Port
2 –Power Connector 5 –USB 3.0 Ports 8 - Dipswitches
3 –HDMI Outputs 6 –RS232 RJ45 Port 9 –RCA Audio Output
3. Run the software on control PC and connect through Network:
4. DS2 System Setup
In Configuration tab select System Setup to commence a 3 step
Edge Blending process.
Before you start Edge Blending Calculate the Edge Blending Width
•DS2 Edge Blending Controller
1
•Power Supplier
1
•DS2 Quick Start Manual
1
•Ethernet Cable
1
•Download Guide Card
1
•RS232 RJ45 to Serial Port Cable
1
From the Connection tab select Player
Connection Setting. When scan is
finished, choose the device from the
list, and click Connect.
Note:
The default IP address for DS2 is
192.168.1.236. Users need to change
the IP address of the control PC to the
same network segment as the DS2.
Use the equation below:
W: Edge Blending overlap width
T: Total Pixels of the projection
W = 𝑳×𝑷
𝑻
L: Length of the projection screen
P: Total Pixels of Edge Blending zone
DS2 Quick Start Manual
SD-MA-030 V01
Step 1: Set up the layout and parameters of the Edge Blending zone:
•Select the layout, angle, and overlap width
•Choose Channels to adjust and click Next
Step 2: Geometry Correction:
5. Basic Operations:
This quick start guide provides basic instructions for setting up SEADA DS2 Edge Blending controllers. For
additional information about how to use the controllers, please refer to the DS2 User Guide (SD-MA-029), which
is available on www.seada.co.uk.
•Choose the Channel
•Select adjustment
points and move them
around to match the
edges of projection
screen
•Adjust Grids of Blending
Zone, they should
overlap perfectly
•Click Next
Double click to change a
value of the projector box
Step 3: Gamma Correction
Use DS2 management software to create some
unique
layouts display captured video in frames and
shapes.
Organize and play content of build in Media
Player and many more.
Select Gamma Line Mode to use
SEADA optimized linear adjustment
tool
Altri manuali per DS2
1
Altri manuali Seada Controllori
Seada
Seada G88 HDMI Manuale utente
Seada
Seada G24-HDMI Manuale di istruzioni
Seada
Seada G4K Pro Manuale di istruzioni
Seada
Seada G4K Manuale di istruzioni
Seada
Seada G4K Pro Manuale utente
Seada
Seada GM9 Manuale utente
Seada
Seada GM9 Manuale di istruzioni
Seada
Seada SolarWall Pro Series Manuale utente
Seada
Seada DS2 Manuale utente
Seada
Seada G2000CTL Manuale utente
