MULTI-PARAMETER INSTR
Seametrics • 253.872.0284 Page 4 seametrics.com
What is the Multi-Parameter Smart Sensor?
The Seametrics Multi-Parameter Smart Sensor combines up to three Seametrics Smart
Sensor probes in a single, easy-to-deploy, unit. Depending on conguration the Multi-
Parameter Sensor can measure pH, ORP, temperature, conductivity, salinity, TDS, pressure,
level, and dissolved oxygen or turbidity, depending on conguration.
The Multi-Parameter Smart Sensor is powered from a 12 VDC power supply and can be
networked with other Seametrics Smart Sensors, either directly from a single computer or
via a third party System.
Features
Initial Inspection and Handling
Upon receipt of your smart sensor, inspect the shipping package for damage. After
opening the carton, look for concealed damage, such as a cut cable. If damage is found,
immediately le a claim with the carrier. Check the label attached to the cable at the
connector end for the proper cable length.
Do’s and Don’ts
Do handle the device with care.
Don’t install the device so that the connector end is submerged.
Don’t support the device with the connector or with the connectors of an extension
cable. Use a strain relief device to take the tension o the connectors.
Don’t allow the device to free-fall down a well as impact damage can occur.
Don’t bang or drop the device on hard objects.
• Measures pH, ORP, temperature,
conductivity, salinity, TDS, pressure
level, and dissolved oxygen or turbidity
(depending on conguration)
• Modbus®and SDI-12 interface for
greater exibility
• Non-volatile memory
• RS485 network — connect with other
Seametrics Smart Sensors
• Modular design — accommodate
changes to parameter and data needs
• Flexible, Windows®-based
programming
• Real time viewing
• Easy export to spreadsheets and
databases
• Direct read option — use with panel
meters or RTU/PLC applications
• Fits in 2” (5.1 cm) well
INTRODUCTION
