9
FULL TIME (IF THERE IS NO PHONE LINE OR WILL NEVER BE
INSTALLED)
Program Function 07 for GSM Full Time (option=0) and connect the
customers alarm panel to the female side of the T-socket.
(You can also wire the RJ lead from the alarm panel to RJ on the
SED-64 CON1 directly without using the T-socket)
SMS Mode (Section 2.2)
Send a formatted text messages via SMS from any mobile phone to
program as per Section 2.2.
Operating Modes & Programming
Programming
BASIC BACK UP SYSTEM
Connect the phone line to the male side of the T-socket and the
customers alarm panel to the female side ,connect the RJ lead as shown
in 1.1 to the SED-64 Wire the GSM fault relay into a 24Hr zone on the
customers alarm panel.
INTELLIGENT BACK UP SYSTEM
(WE RECOMMENDED THAT THE INTELLIGENT MODE BE USED IN MOST CASES)
1
2
3
There are 2 available methods to program the SED-64
Manual Mode (Section 2.1)
Plug a standard telephone butt into the SED-62/64 Port marked
“CON1” and program as per Section 2.1
1.5
Operating Modes
Connect the phone line to the male side of the T-socket and the
customers alarm panel to the female side, connect the RJ lead as
shown in 1.1 to the SED-64. Wire the fault relay into a 24Hr zone on
the customers alarm panel. Power up the SED-64 and program
functions 1, 2 & 3. For programming details see Section 2.0 of this
manual Ensure the control room has set up the communication
Template on 2.10
4GPRS SUPERVISED POLLING
Phone 1300 65 44 33 to activate GPRS supervised polling
.
OR
