SecureALL SA-MDR Manuale utente

SecureALL Corporation

SA-MDR Installation Guide

Version 3.0

SecureALL Corporation

SA-MDR Installation Guide

document may be reproduced in any form or any means, electronic or mechanical, including

photocopying, without permission in writing from the Company. All inquiries should be

addressed to SecureALL Corporation, 695 Woburn Court, Mountain View, CA 94040.

Revision History

Version

Date

Author

Revision Description

1.0

02-15-2012

JDS

Initial version

2.0

08-15-2012

RAS

Added step for changing lock from RH to LH;

added instructions for installing the flex cable

that has replaced the 14-pin cable; added step to

check current level post battery installation; new

mortise cutout template.

3.0

7-16-2013

RAS/DAC

Added spacer and corrected bill of materials

Table of Contents

Revision(History(.............................................................................................................................(3(

Table(of(Contents(...........................................................................................................................(4(

Introduction(.....................................................................................................................................(5(

Configuring(the(Mortise(Chassis(..............................................................................................(6(

Installation(Instructions(.............................................................................................................(7(

Appendix(A(-(Mortise(Cutout(Template(...................................................................(16(

Appendix(B(-(Mortise(Lock(Assembly,(Exploded(View(.........................................(18(

Appendix(C(-(Screw(Package(.......................................................................................(19

(

I. Introduction

These instructions are to be used to install a SecureALL SA-MDR mortise door reader. This

document assumes availability of a door with a cutout pocket for an industry standard, ANSI

Grade 1, heavy-duty mortise lock. See Appendix A for cutout dimensions.

Required Tools:

1. Phillips head screwdriver (Size #3 Drive)

2. Phillips head screwdriver (Size #2 Drive; pitch: 0.6) for Escutcheon Cover Screws

3. Allen wrench - supplied by SecureALL

Check the Materials:

Verify that the following materials are included and there is no visible damage. If there are any

damaged or missing items, contact SecureALL immediately for assistance. See Appendix B for

an exploded view of the lock and Appendix C for pictures of the screw hardware.

ITEM NO. PART NO. DESCRIPTION QTY

1 190-000176 FACE PLATE 1

2 850-000122 MORTISE CHASSIS ASSEMBLY 1

3 190-000177 INSIDE LEVER ASSEMBLY 1

4 190-000178 OUTSIDE LEVER ASSEMBLY 1

5 190-000171 SPINDLE W/SCREW (SET) 1

6 190-000189 SPACERS, 1/4" HIGH 2

7 190-000172 MOUNTING POST 2

8 190-000173 TRIM SCREW 2

9 820-000127 INSIDE COVER ASSEMBLY 1

10 820-000128 OUTSIDE COVER ASSEMBLY 1

11 820-000129 INSIDE RF ASSEMBLY 1

12 190-000175 DUST BOX 1

13 190-000179 STRIKE PLATE 1

14 190-000168 MORTISE SCREW 2

15 190-000166 CHASSIS SCREW 2

16 190-000170 SCALP SCREW 2

17 190-000167 ESCUTCHEON COVER SCREW 3

18 190-000169 STRIKE SCREW - FINISHED 2

19 530-000100 AA BATTERIES 3

II. Setting the mortise chassis

The diagram below gives the instructions to change from an inside (i.e. door opens in) to an

outside (i.e. door opens out) lock unit or from an outside to an inside lock unit. Picture #1 shows

an outside opening right hand door and #4 shows an inside opening right hand door.

If it is necessary to change from a left hand inside opening lock unit to a right hand inside

opening lock unit (or vice versa), first follow the procedure above to reverse the latch bolt. The

locking side must then be reversed. Unscrew the two screws in the left figure below and put

them in the same screw holes on the other side of the chassis.

III. Installation Instructions for Left Hand, Inside Opening Door

1. Orienting the Chassis Assembly (Item 2) as shown in Figure 1a, carefully thread the two

cables into the door pocket and through the second hole as shown in Figure 1b. Holding

the cables taut, push the Chassis Assembly all the way into the pocket.

Figure 1a Figure 1b

2. Using Mortise Screws (Item 14), secure the Chassis Assembly to the door, as shown in

Figure 2.

Figure 2

3. Place the outside Spindle (Item 5A) and inside Spindle with Screw (Item 5B) in the

Chassis Assembly and tighten the screw that is embedded inside Item 5B with the

Phillips screwdriver. See Figures 3a & 3b.

Figure 3a Figure 3b

Item 14

Item 5B

Item 5A

4. Mount Outside Lever Assembly (Item 4) on the outside Spindle. Insert Mounting Posts

(Item 7) through the holes in the Outside Lever Assembly, making sure they are

completely inserted. See Figure 4.

Figure 4

5. Mount the Outside Cover Assembly

a. Hold the Outside Cover Assembly (Item 10) perpendicular to the door as shown

in Figure 5a.

Figure 5a

Item 7

b. Slide the Outside Cover Assembly toward the handle until it butts up against the

handle end (Figure 5b).

Figure 5b

c. Rotate the Outside Cover Assembly clockwise and then push it toward the handle

until the end is within the Outside Cover Assembly cutout (Figure 5c).

Figure 5c

Indice

Altri manuali SecureALL Serratura

SecureALL

SecureALL SA-ODL Manuale utente

Manuali Serratura popolari di altre marche

Magic

Magic 105 Manuale utente

Gantner

Gantner GAT NET.Lock 7020 System Guida rapida

Wittkopp

Wittkopp Insys 7202 Manuale utente

Dorma

Dorma Studio Classic Manuale utente

Securam

Securam ECSL-601 Manuale utente

Sudhaus

Sudhaus 3003 Manuale utente

Safety 1st

Safety 1st 48517 Manuale utente

Pado

Pado FDS-10 Manuale utente

Esco

Esco systeQ Series Manuale utente

COMPX

COMPX National D8951 Manuale utente

secureo

secureo Key Box Manuale utente

Stock Loks

Stock Loks C8713 Manuale utente

COMPX

COMPX 1T-058 Manuale del proprietario

Auslock

Auslock T11 Manuale utente

ELCOM

ELCOM 7205 Manuale utente

Stealth SAFES

Stealth SAFES ShadowVault Manuale utente

Knox

Knox KeySecure 5 Manuale utente

Kwikset

Kwikset 48334/01 Manuale utente