Securitytronix ST-PTZIR530-36 Manuale utente

V1.0 12/15/11

INSTALLATION MANUAL

ST-PTZIR530-36

IP66 Rated High-Speed Intelligent Dome

PTZ IR Color Camera

v1.0 12/15/11

TABLE&OF&CONTENTS&

PACKAGE'CONTENTS ................................................................................................................... 3!

PRODUCT'DESCRIPTION............................................................................................................. 3!

SPECIFICATIONS............................................................................................................................ 3!

INSTALLATION'AND'OPERATION ............................................................................................ 4!

1.!UNPACKING'and'HANDLING........................................................................................................ 4!

2.!MECHANICAL'INSPECTION........................................................................................................... 4!

3.!SPECIAL'ATTENTION ..................................................................................................................... 4!

4.!CAMERA'SETUP................................................................................................................................ 5!

Protocol Set Up................................................................................................................................................... 5!

Camera Address Set Up................................................................................................................................ 6!

5.!PHYSICAL'INSTALLATION ............................................................................................................ 6!

6.!FUNCTIONS'and'OPERATION ...................................................................................................... 9!

System Information........................................................................................................................................10!

Display ....................................................................................................................................................................10!

Dome Settings ...................................................................................................................................................12!

Camera Setup.....................................................................................................................................................20!

Operation Setup................................................................................................................................................22!

Restart.....................................................................................................................................................................26!

Factory Defaults ...............................................................................................................................................27!

Help...........................................................................................................................................................................27!

7.!TROUBLESHOOTING ....................................................................................................................28!

APPENDIX'A ..................................................................................................................................29!

v1.0 12/15/11

PACKAGE&CONTENTS&

This package contains:

One ST-PTZIR530-36 high-speed intelligent dome color camera.

One mounting bracket with mounting hardware.

One installation manual.

PRODUCT&DESCRIPTION&

The ST-PTZ530-36 is an IP66 rated professional grade intelligent dome color camera with

pan, tilt and zoom (PTZ) capability of 530TVL using a 3.4mm to 122.4mm F1.6-F4.5 zoom

lens. This camera is capable of 360°continuous panning without any blind areas, supports

255addresses and 220 programmable presets and offers multiple cruising, auto-scan, and

pattern tour tracks. All settings are stored in non-volatile memory. The ST-PTZ530-36 is an

all weather camera with integrated heater and blower.

SPECIFICATIONS&

1. Image Sensor

¼” EX-View HAD CCD

2. Resolution

530TVL

3. Picture Elements

NTSC: 768x494

4. Lens

3.4mm ~ 122.4mm, F1.6-F4.5

5. Illumination

0.01 Lux IR On

6. Zoom

432X, 36X Optical, 12X Digital

7. Sync system

internal/External (V-Lock)

8. S/N Ratio

50dB

9. White Balance

ATW / Indoor / Outdoor / Manual / AWB / One Push WB

10. Gain

Auto / Manual

11. Video Output

1Vp-p Composite Video, 75Ω

12. Communications

RS485

13. Protocol

PELCO-P, PELCO-D

14. No. of Programmable Presets

220

15. Focus

Auto / Manual

16. Iris

Auto / Manual

17. No. of Cruising Tracks

18. No. of Auto Scan Tracks

19. No. of Privacy Zones

20. No. of Pattern Tours

21. Continuous Pan

360°

22. Manual Speed

0.01°~ 120°/s

23. Max. Cruising Speed

120°/s

24. No. of Addresses

255

25. Operating Temperature

-13°F ~ 122°F (IR Off), -13°F ~ 86°F (IR On)

26. Operating Relative Humidity

<95%

27. Power

110 ~ 220VAC @0.5A

v1.0 12/15/11

INSTALLATION&AND&OPERATION&

CAUTION: To reduce the risk of electrical shock do not remove the cover or back of

this unit. No user serviceable parts are inside.

CAUTION: To prevent electric shocks and risk of fire hazards, do not use other than

specified power source.

1. UNPACKING&and&HANDLING&

Each unit is shipped assembled and factory tested.

Ensure that all accessories are removed from the container before discarding packing

material

2. MECHANICAL&INSPECTION&

Inspect the front and rear of the equipment for shipping damage. Make sure the

equipment is clean, and no connectors are broken, damaged, or loose. If equipment

appears to be damaged or defective please contact your distributor or Securitytronix at

1-610-429-1511 for assistance.

3. SPECIAL&ATTENTION&

a. The installer must comply with electrical safety standards. There must be

sufficient space between the camera’s power supply and video line and any high

voltage equipment and/or cables.

b. To help ensure the camera’s life and proper operation do not point the camera

towards the sun or strong light.

c. Do not install the camera in an environment where the temperature is above 122°

d. Do not install the camera near a magnetic field or a high-power motor.

e. Do not mount the camera near a radiator or heater.

f. The installation site and material must fully support the weight of the product.

g. Only use a dry cloth to clean the camera. If there is dirt that is difficult to remove

wipe gently with a mild detergent. Never use strong or abrasive detergents.

This symbol is intended to alert the user to the presence of important operating and

maintenance (servicing) instructions.

This symbol is intended to alert the user to the presence of uninsulated “dangerous

voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a

risk of electrical shock.

v1.0 12/15/11

h. This camera uses AC power of 100 ~ 240 volts at 0.5A. Using a DC or other

incorrect power supply or source will damage the camera.

i. Only qualified installers are allowed to install, test and disassemble the camera.

j. The camera is a low voltage product. If installed outdoors proper safety and

lightning grounding are required in addition to surge protection.

k. Before installing be sure the grounding, wiring, input power, voltage, DIP

switches, communication protocol and baud rate are correctly set prior to

powering up and using.

4. CAMERA&SETUP&

It is advisable to configure the camera’s settings prior to physically installing the unit.

To set the camera’s address and protocol remove the “settings cover” on the side of the

camera. This will expose two sets of 8-bit DIP switches,one each to set the camera’s

protocol and address.

Protocol Set Up

The camera supports PELCO-P and PELCO-D protocols and three baud rates: 9600,

4800 and 2400bps. Using SW2 and the table below:

DIP Switches 1, 2 and 3 set the protocol (“1” means “ON”, “0” means “OFF”)

DIP Switches 4 and 5 set the baud rate (“1” means “ON”, “0” means “OFF”)

v1.0 12/15/11

Protocol

Switch 1

Switch 2

Switch 3

PELCO-D

PELCO-P

Reserved

…

Baud Rate

Switch 4

Switch 5

9600

4800

2400

Reserved

Camera Address Set Up

SW1 uses all of the 8-bit switches to set up to 255 camera addresses. The 1st bit is the

lowest and the 8th bit is the highest.

See Appendix A for SW1 DIP Switch configurations for PELCO-P and PELCO-D

protocols. Note the DIP Switch settings are slightly different for each protocol.

5. PHYSICAL&INSTALLATION&

Unscrew the power box from the mounting bracket. Then thread the cables across the

bracket and connect to the circuit board in the power box.

v1.0 12/15/11

Install the camera dome to the bracket

using the four hexagon screws. It is

advisable to apply a waterproof sealant to

the joint gap where the camera dome joins

the bracket.

Attach the mounting template to the location where

the camera is to be mounted. Drill holes according to

the template and install the mounting bolts.

Install the entire unit (camera body,

bracket and power box) to the mounting

bolts and tighten.

v1.0 12/15/11

Remove two screws from the power box

and open it.

Thread the power cable through the

waterproof head on the left and the RS485

and video cable through the waterproof

head on the right.

Connect the cables to the circuit board

and double check to ensure each cable is

connected to its proper location. Damage

may occur if cables are improperly

connected.

After all cables are connected, tighten the

two heads. It is advisable to apply

waterproof sealant to the heads.

Close the power box and tighten the bracket to the

box. Double check all bolts and screws are tight. It

is advisable to apply waterproof sealant to all joint

gaps.

After the camera is physically mounted and

installed:

Connect the camera to the monitor with a 75Ωcoaxial video cable.

Connect power supply’s AC plug to a suitable AC power outlet.

Make an RS485 connection between the camera and the PTZ controller. Ensure

the connections at the PTZ controller and camera have the same polarities.

v1.0 12/15/11

6. FUNCTIONS&and&OPERATION&

From the PTZ controller calling preset position 95 will display the camera’s On Screen

Display (OSD) menu. The camera’s OSD Menu Tree is below.

! ! ! !

!! ! ! !

!!!!!

v1.0 12/15/11

System Information

A = Camera Dome ID E = TV System (NTSC or PAL)

B = Camera Dome Address F = Camera’s Internal Temperature

C = Baud Rate G = Version

D = Protocol

Display

Call preset 95 to enter the OSD Menu and move the PTZ controller’s joystick to select

DISPLAY and press IRIS OPEN to enter submenu DISPLAY.

A = DOME. Press IRIS OPEN to set the Dome Setting with the ON/OFF option.

B = PRESET. Press IRIS OPEN to set the Preset Setting with ON / OFF / 2SEC / 5SEC /

10SEC option

C = MOTION. Press IRIS OPEN to set the Auto Setting with ON / OFF/ 2SEC / 5SEC /

10SEC option.

D = ZONES. Press IRIS OPEN to set the Zones Settings with ON / OFF / 2SEC / 5SEC /

10SEC option.

E = DATE/TIME. Press IRIS OPEN to set the Date/Time Settings and move the joystick

to select ON / OFF / 2SEC / 5SEC / 10SEC option.

Indice

Altri manuali Securitytronix Telecamera di sicurezza

Securitytronix

Securitytronix ST-D420IR6-B Manuale utente

Securitytronix

Securitytronix ST-IP-BTVF-2 Manuale utente

Securitytronix

Securitytronix ST-LCDHD-18.5 Manuale utente

Securitytronix

Securitytronix ST-D600IR2812-HB Manuale utente

Securitytronix

Securitytronix ST-BT600SIR –B Manuale utente

Securitytronix

Securitytronix ST-PTZIR650-23 Manuale utente

Securitytronix

Securitytronix ST-D7002812-B Manuale utente

Securitytronix

Securitytronix ST-IP-BT3.6-1 Manuale utente

Securitytronix

Securitytronix ST-PTZ480-22X Manuale utente

Securitytronix

Securitytronix HD-COAXINATORTVI ST-HDC2PTZ Manuale utente

Securitytronix

Securitytronix ST-D650IRVP-B Manuale utente

Securitytronix

Securitytronix ST-DWDIRVF2812-720B Manuale utente

Securitytronix

Securitytronix ST-PTZMINI-IR10XTA Manuale utente

Securitytronix

Securitytronix ST-IP4FB Manuale utente

Securitytronix

Securitytronix HD-CoaxinatorTVI ST-HDC2VFB-MZ Manuale utente

Securitytronix

Securitytronix ST-HD-D2812M-2MP Manuale utente

Securitytronix

Securitytronix ST-DWD1000IRVP2812 Series Manuale utente

Securitytronix

Securitytronix ST-IP2FB Manuale utente

Securitytronix

Securitytronix HD-CDAXINATORTVI ST-HDC2VFD-MZ Manuale utente

Securitytronix

Securitytronix ST-HD-BT2812M-2MP Manuale utente

Securitytronix

Securitytronix ST-CVTMD420-WPIR-W Manuale utente

Securitytronix

Securitytronix ST-WD600PTZMINI Manuale utente

Securitytronix

Securitytronix ST-BT6003.6-W2 Manuale utente

Securitytronix

Securitytronix ST-D600IR2812 Manuale utente

Manuali Telecamera di sicurezza popolari di altre marche

Okina USA

Okina USA SIR36-870VF650LP Manuale utente

Divio

Divio NDR155PA Manuale utente

Canon

Canon VB-C500D Manuale utente

Easy Access

Easy Access EasyGuard Manuale utente

Vivotek

Vivotek FD9389-EHV-v2 Manuale utente

TUYA

TUYA COSMO W2 Manuale utente

Eusso

Eusso UNC7500-IR Guida all'installazione

urmet domus

urmet domus 1096/204 Manuale utente

VC VC20 series Manuale utente

Axis

Axis Q1614 Manuale utente

ieGeek

ieGeek DD201 Manuale utente

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuale utente

Vicon

Vicon V662-D-1 Istruzioni operative

Grundig

Grundig GCH-K0274P Manuale utente

Lorex

Lorex VANTAGE LBC7032 Manuale utente

4xem

4xem WPT Manuale utente

Samsung

Samsung SCV-3082 Manuale utente

Vitek

Vitek VTC-C544 Manuale utente