123
456
789
*
0 #
3) Install Keypad
4) Identify Door Handing
5) Adjust Thumb Turn Piece
C.Insert the plastic lock groove and the strike plate into door jamb tighten with wood screws.
Install double-screw bolt into
keypad inner plate.
Place IC wire, latch link bar and dou -
ble-screws through the holes on the
deadbolt, as the picture on the right
shows.
The door is "Left-handle" if the hinges are on the
left side of the door.
Whereas the door is "Right-handle" if the hinges
are one the right side of the door.
Rotate the thumb turn piece to “Horizontal Direction”
for Left-handle (open into room) door when in
unlock status.
Rotate the thumb turn piece to “Vertical Direction”
for Right-handle (open into room) door when in
unlock status.
Note: IC wire should be placed under latch.
After installing the front pad, roll the
handle spindle to test if it could work with
deadbolt or not. If could not, take out the
front pad and roll the latch link bar around
90 degree and try to install again untill it
could work with the deadbolt.
Note: Please place the IC line as shown in the figure to avoid the
lock latch out of control.
Pass the IC wire and the latch link bar to mounting plate.
Use 1 flat screw to secure with the keypad double-screw bolt.
Use 2 flat screw connect mounting plate with latch.
Left-handle
Hinge
1 2 3
456
789
*0 #
Right-handle
Hinge
1 2 3
456
789
*0 #
Left-handle Right-handle
(07) (08）
