Page 7
Quick reference guide USB-MESY HID 570.77A
Quick reference guide USB-MESY HID 570.77A \ 10.2013 \
4. Executing the measurement
NOTICE
Damages at the electronics by high temperature
Avoid categorical an internal temperature of the
MESY of more than 60°C.
4.1. Executing the measurement
Proceed the following steps to run a measurement with the
USB-MESY HID with the standard parameters:
Connect the desired number of thermocouple sen-
sorswiththeinputs“Channel1…3".
Press the button [On/Off] at the MESY until you hear
a short beep for 5 times to switch on the USB-MESY
HID. To press the buried button you can use a ball
pen for example.
Press the button [Measure Start/Stop] until you hear
a long beep to start the measurement.
The measurement begins. Measurement values will
berecordedwiththepredenedintervalof0,5sec-
onds and will be stored in the memory of the MESY.
After you have recorded all desired measurement
values press the button [Measure Start/Stop]. You
will hear two long beeps and the USB-MESY stops
the measurement.
An internal temperature of more than 60°C will be signalized by
an interval beep (0,5 sec.) if the MESY is switched on.
If this sound appears the MESY should be taken to a
cooler place immediately.
The signal will sound as long as the temperature will fall under
40°C again. Only then a new measurement can be started.
Use the optional available Thermo insulating box
571.77 for an optimal heat protection.
With this box you can use the MESY in ambient tem-
peratures up to 300°C and residence times up to 450
seconds without problems.
