Segway I180 Guida

WARNING!

Always shut down your Segway HT and unplug the Power Cord before performing any

maintenance or installing any part or accessory.

Follow these instructions carefully. Failure to follow these instructions could damage your

Segway HT and render it unsafe to use.

Questions?

If you have any questions or are missing a part, please contact an Authorized Segway

Dealer. For a list of Dealers, visit www.segway.com. Check www.segway.com for

updates to these instructions. Thank you.

Segway

Human Transporter (HT)

Splash Guard Replacement Instructions

i180 Model Fenders

LIMITED WARRANTY

The Segway HT Splash Guards are an “Accessory” covered for 90 days under the Segway®Human

Transporter Limited Warranty (copy delivered with the kit.)

Contents

> (2) Splash Guards

> (4) Fender Tabs

> (4) T-20 Drive Fender Fasteners

Note: Replace any fasteners you remove

with the new fasteners included in this kit.

Tools Required

> 16 mm deep socket

> 50 N-m Torque Wrench to accommodate

the 16 mm deep socket

> Rubber Mallet

> T-20 Six-Lobe bit (Torx T-20)

> 1.5 N-m Torque Wrench to

accommodate the Six-Lobe bit

Product Information

> Impact-resistant construction

> Identical/interchangeable for left/right

side and all 3 positions along the fender

Splash Guards

Wheel Insert Replacement Instructions

Fender Tab

Remove the Tire/Wheel Assembly

Step 1 Tip the Segway HT onto its side so

that the outside of one wheel lays flat

against a clean, smooth surface

Step 2 Remove the Wheel Nut with a 16 mm

deep socket wrench. Hold the wheel

from rotating and turn the wrench

counterclockwise. (This may require

considerable force.)

Step 3 Strike the outside edge of the tire with

a rubber mallet to unseat the wheel

hub taper. (This may require multiple

attempts as the wheel hub is seated

tightly into the Gearbox taper.)

Step 4 Lift off the wheel.

Step 5 Clean any debris from inside of

Gearbox taper and outside of wheel

hub.

Remove the Splash Guard

Step 1 Remove the two Splash Guard

fasteners using a T-20 six-lobed bit

(Torx T-20).

Step 2 Remove the two oblong Fender Tabs

that are between the fasteners and

the Fender, and save these for reuse

when you install the Splash Guards.

Step 3 Remove the Splash Guard

Wheel Insert Replacement Instructions

Install the Splash Guard

Step 4 Position the Splash Guard into the

position you select on the Fender.

(For best spray protection, install the

Splash Guard in the rear position.)

Step 5 Hold the two Fender Tabs in the slots

in the Fender, and thread the two

fasteners through the Fender Tabs

and Fender and into the Splash

Guard.

Step 6 Torque to 1.5 N-m using a T-20 six-

lobed bit (Torx T-20). Over tightening

could strip aluminum threads.

Reseat the Tire/Wheel Assembly

Step 1 Place the Wheel hub opening over

the Gearbox drive shaft; rotate the

wheel while pressing down until the

wheel seats.

Step 2 Thread on the wheel nut and tighten

with the socket wrench.

Step 3 Torque to 50.0 N-m.

We hope this document provided clear step-by-step instructions. If you feel these instructions

are incorrect in any way, we would like to hear from you. Please contact Segway Customer

Support at 1-866-4SEGWAY (1-866-473-4929) or go to www.segway.com if you have any

questions, comments or suggestions. Thank you!

Indice

Altri manuali Segway Scooter

Segway

Segway Ninebot KickScooter Air T15 Manuale utente

Segway

Segway Ninebot KickScooter Manuale utente

Segway

Segway Ninebot KickScooter F2 E Manuale utente

Segway

Segway KickScooter Manuale utente

Segway

Segway Ninebot KickScooter Manuale utente

Segway

Segway KickScooter Manuale operativo

Segway

Segway XT Manuale utente

Segway

Segway NINEBOT ONE S2 Manuale utente

Segway

Segway Ninebot KickScooter Air T15 Manuale utente

Segway

Segway P100 S Manuale operativo

Segway

Segway MINILITE Manuale utente

Segway

Segway GT Manuale utente

Segway

Segway Ninebot KickScooter F25 Manuale utente

Segway

Segway Ninebot KickScooter Manuale utente

Segway

Segway Steering Grip Kit Guida di riferimento

Segway

Segway Ninebot KickScooter Manuale utente

Segway

Segway i Series Manuale utente

Segway

Segway P65E Manuale utente

Segway

Segway x2 Turf Manuale operativo

Segway

Segway Ninebot Mecha Kit Manuale utente

Segway

Segway GT1A Manuale utente

Segway

Segway Ninebot KickScooter ES1L Manuale utente

Segway

Segway MAX Manuale utente

Segway

Segway eMoped B Series Manuale utente

Manuali Scooter popolari di altre marche

TEKTRO

TEKTRO CHEETAH Manuale utente

Douglas

Douglas Vespa Sprint Guida all'installazione

PLAYTIVE

PLAYTIVE AS-2448 Manuale utente

Ebinger

Ebinger DONKEY XL Manuale utente

Flyer

Flyer Mountain Guida utente

BackCountry eBikes

BackCountry eBikes Storm Manuale utente

equipmed

equipmed FreeRoam II Manuale utente

Yoto

Yoto Lion Manuale utente

WESTHILL BIKES

WESTHILL BIKES LINK Manuale utente

BAnff

BAnff eProdigy series Manuale utente

Winther

Winther 475 Manuale utente

Jetson

Jetson JBZL17 Manuale utente

First Choice Mobility

First Choice Mobility Roma Medical Corella S741 Manuale utente

Carrera

Carrera impel Manuale utente

Afikim

Afikim Superlight SL-3 Manuale utente

CareCo

CareCo ZOOM Manuale utente

Douglas

Douglas Vespa G.S. Manuale utente

Gazelle

Gazelle with BOSCH System Manuale utente

Segway i180 Guida

Manuali Scooter popolari di altre marche