Page7of7
8. Recommendations to find hidden cameras
The basic rule when it detects hidden cameras is the need to be in place, which are likely interested parts, the camera (or
the intended destination of the camera installation and locations).
Most likely these places are places of work (sitting at the table with them, people), leisure (chairs, couches, beds). If the
interest may be the attendance of an individual room - the camera can be aimed at the doorway.
Be aware that the cameras can be several. Detection of one or two video cameras does not give the right to conclude that
the room Check. You must check all the places from which possible video surveillance.
Search in the most difficult areas with a large amount of glare objects - a large number of mirrors, glass, etc. In the case of
the flare, which prevents any inspection of the surface, you need to change the angle at which the inspected surface. Often
enough to move a step and a highlight will disappear. In this case, the lens flare will remain.
Necessary for checking the premises to try not to stand at right angles to glare surface.
Video cameras can be installed in any part of the interior is suitable for such a facility. This may be the ceiling, video and
audio equipment, paintings, decorations, etc.
Search much easier and brightness visible spot on the lens flare increases, if the room is no direct sunlight. There is no
need to "make the darkness' - enough to create a normal operation of the lighting conditions. If necessary, you can work
almost in the direction of the sun, but the operator's eye lens is able to recognize the spot from 1-2 meters.
These recommendations are valid with any detector of hidden video cameras operating as blink detection facilities.
9. Safety regulations
Attention! The device is glass optical elements. In the case of breakage of any of them do not operate the device in order to
avoid injury.
Do not point the backlight on the eyes of people. Short-brightening of the eye is safe.
Avoid direct sunlight and heating unit.
Do not disassemble and do not throw the appliance.
Do not leave for a long time due to the low temperatures - a device designed for use in normal rooms with a temperature
range of +5 to +40 degrees Celsius
To clean dirty optics use only wipes designed to clean optical devices.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------
The originality of the method of detection is confirmed by the RF patent
