Instruction for the use of
the LED POWER SUPPLY
Model: SLT6-350ISC-UN
Applications
This type of power supply is an exclusively designed stabilized
power supply for LED lamp. and meets the requirements of the
RoHS Directive (2011/65 / EC), the Low Voltage Directive
(2014/35 / EU) and the EMC Directive (2014/30 / EU).
With constant current/constant voltage (CC/CV) technology, it is
suitable for constant voltage lamps connected in parallel or
constant current lamps connected in series.As an advantage of
CC/CV technology, a switch can be installed between secondary
side and lamps.
The built-in protection circuit will shut down the power supply in
case of such faults as: open circuit, short circuit , over load or
over temperature. The power supply will restart automatically
after fault correction.
Important information for the installation
·The unit uses dangerous mains voltage(120-240VAC), it
should only be installed by qualified electricians according to
European safety standards or relevant nation regulations.
Failure to observe any of the installation instructions may cause
fire or other hazards.
·The power supply is for LED lamps only. Pay attention to the
polarity of LED, wrong polarity may damage the LED.
·The power supply is only for indoor use and permissible
operating temperature is -20 to 50℃.
·The power supply cannot be independently installed.
·The indicated load should not be exceeded.
For 1W high power LED(IF=350mA, VF=3.25V), 1 to 6PCS.
·The maximum length of the output cable to the LED lamps
should not exceed 2m in order to meet the EMC standard.
·If the LED power supply is used for purposes other than
originally intended or it is connected incorrectly, the
manufacturer is not responsible for possible damages.
·Wasted PCB during transit, delivery, use and scrap disposal
can cause certain environment damage.Please handle it
according to “waste electronic products disposal rules” locally.
Manufacturer
SELF Electronics Co.,Ltd.
No. 1345 Ju Xian Road, Hi-Tech Park, Ningbo, China
Tel: 0086-574-28805765
Specifications
Input power: max 8W
Input voltage : 120-240VAC
Input frequency : 50/60Hz
Input current : 0.08A@120Vac 0.05A@220-240Vac
Input power factor : 0.90C@120Vac 0.80C@220-240Vac
Constant current output: 350mA
Output voltage : 5 -17VDC Uout=25VDCmax
Rated output power : 1.75-6 W
Constant voltage output: 24VDC, max 0.25A, 6W
Operation mode: PWM+PFM
LED type : COB or high power LED
Ambient temperature : -20…+50℃
Case temperature : 90℃
IP protection : IP66(for enclosure only)
Brown
Blue
Black/ White
Black/ White
Red
-
L
N 120~240V 50/60HZ
29.7
03/07/2018
Brown
Blue
SEC(OUTPUT)
