Jan van Gentstraat 123-F
1171 GK Badhoevedorp
The Netherlands
Tel. +31(0) 20 659 26 92
www.sellmore.nl
mail@sellmore.nl
RFID programming instructions
Activating the programming card
Initializing / activating a programming card:
1.
Press the push-button on the rear side.
2.
The lock will make a ticking sound (signal). Hold the programming card on the lock within 3 seconds
of hearing this signal.
3.
Two short ascending tones will confirm that the programming card has been saved successfully.
Initializing a key
Initializing the key card or chip key:
1.
Please place the programming card onto the lock.
2.
The lock will make a ticking sound (signal). Place the key card or chip key onto the lock within
3 seconds of hearing this signal.
3.
Two short ascending tones will confirm that initialization was successful.
4.
The lock can now be opened using the key card or the chip key.
Deleting the key card or chip key
1.
Please place the programming card onto the lock.
2.
The lock will make a ticking sound (signal). Place the key card or chip key onto the lock within
3 seconds of hearing this signal.
3.
Two short ascending tones will confirm that deletion was successful.
Delete all keys
To delete all keys at once, place the programming card onto the lock for several seconds.
ACCESSORIES ACCESSORIES
3050 - Battery 3040s - external antenna (125 KHz)
The 3 volt lithium battery has life-span of 10 years
with the 125 KHz and 3 years with the 13,56 MHz
technology. The battery has enough power to
open the lock more than 30,000 times. When the
battery starts to run out, the lock will no longer lock
and a contin- uous tone will sound for 15 seconds,
at this point change the battery.
The flat external antenna is used whenever the
distance from the key is greater than 25 mm or if
the lock is fixed onto a rear panel. Cable: 1,5m
3041 - round mini antenna (125 KHz)
With a hole of 7,5mm diameter, this round
Metal kit mini antenna can be placed in several varia-
With a stamp in the metal door, the internal
antenna of the SOLO and S0L013 lock will work
through the metal door.
tions.
3010 - Programming card
3060 glass set This card can be used to give or deny access
This set is similar to the metal kit and consists of an
additional adhesive glue tape. Depending on
where the force is applied, the double-sided sticky
tape on an untreated surface will hold up to 25 kg
or 45 kg (551 bs or 991 bs), depending on the
direction of pull.
as well as to change the software settings. The
same programming card can be as- signed to
multiple locks within a shop / area for example.
3030 - Key card
3051s - External power supply The range is approx. 30 mm cross wood or
The cable is 1,5 m long and can be plugged
directly into the lock. Each converter can supply a
maximum of 5 locks. Please note: Never use
transformers and batteries at the same time!
glass. Program up to 50 different keys per lock.
3053s –Spacer plate 3020 –Chip key
This chip key is extremely small with a diame-
A square shaped spacer plate to prevent cables
from being crushed. Measurements: 60 x 60 x 5 mm ter of approx. 30 mm. It can be easily at- tached to
a key ring. The maximum range is 20 mm.
