1 - INTRODUCTION
1.1 Scope
This User’s Guide provides the necessary information for the operation of all SEMCO MC110 RF Multi-
Coupler configurations, which are used to receive and distribute RF signals from antennas operating in the
200 MHz to 2500 MHz frequency spectrum. The most common use of the MC110 RF Multi-Coupler is the
distribution of these antenna RF signals to telemetry receivers installed in telemetry ground stations in
support of aircraft, missile, and weapon system flight tests.
1.2 Purpose and Description
This User’s Guide provides detailed information to allow for operation of all MC110 RF Multi-Coupler
configurations (Figure 1-1).
Section 2, Getting Started briefly describes and lists the standard and optional hardware features of the
rackmount MC110 RF Multi-Coupler and then describes how to install and apply power to the MC110.
Section 3, Hardware I/O describes system hardware and I/O interface. This standardized hardware I/O
description facilitates MC110 RF Multi-Coupler operation in a typical Telemetry Ground Station
environment.
Section 4, RF Multi-Coupler Operation provides instructions for MC110 operation.
Figure 1-1
MC110 Series RF Multi-Coupler
